Viking VSOT730WH, LVDOT730KA, LVDOT730FW, LVDOT730DG, LVDOT730CY Installation Manual
...
Installation
Guide
7 SERIES
Professional TurboChef Speedcook Ovens
VSOT730
VDOT730
Table of Contents
Warnings and Important Information _________________________________ 3
Dimensions _____________________________________________________ 6
Speci cations ____________________________________________________ 8
Cutout Dimensions________________________________________________ 9
General Information ______________________________________________ 11
Installation _____________________________________________________ 12
Performance Checklist ____________________________________________ 16
Control Panel ___________________________________________________ 16
Service & Registration ____________________________________________ 17
2
IMPORTANT – Please Read and Follow!
• Before beginning, please read these
instructions completely and carefully.
• DO NOT remove permanently a xed labels,
warnings, or plates from product. This may void
the warranty.
• All local and national codes and ordinances
must be observed. Installation must conform
with local codes. Verify your appliance has
been properly connected and grounded in
accordance with local codes or in absence of
codes, with the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.
• The installer must leave these instructions
with the consumer who should retain for local
inspector’s use and for future reference.
In Massachusetts: This appliance must be
installed by a Massachusetts licensed plumber
or electrician.
Your safety and the safety of others is
very important.
We have provided many important safety
messages in this manual and on your
appliance. ALWAYS read and obey all
safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded
by the safety alert symbol and the word
“DANGER” or “WARNING” or “CAUTION.”
These words mean:
DANGER
You will be killed or seriously injured if
you don't follow instructions.
WARNING
In Canada: Installation must be in accordance
with the current CSA C22.1 Canadian Electrical
Codes Part 1 and/or local codes.
You can be killed or seriously injured if
you don't follow instructions.
CAUTION
Hazards or unsafe practices which
COULD result in minor personal injury
or property damage.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
33
IMPORTANT – Please Read and Follow!
A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local
ordinances.
• The required use of a GFI is normally related to the location of a receptacle with respect to
any signi cant sources of water or moisture.
• Viking Range, LLC will NOT warranty any problems resulting from GFI outlets which are not
installed properly or do not meet the requirements below.
If the use of a GFI is required, it should be:
• Of the receptacle type (breaker type or portable type NOT recommended)
• Used with permanent wiring only (temporary or portable wiring NOT recommended)
• On a dedicated circuit (no other receptacles, switches or loads in the circuit)
• Connected to a standard breaker of appropriate size (GFI breaker of the same size NOT
recommended)
• Rated for Class A (5 mA +/- 1 mA trip current) as per UL 943 standard
• In good condition and free from any loose- tting gaskets (if applicable in outdoor situations)
• Protected from moisture (water, steam, high humidity) as much as reasonably possible
4
IMPORTANT – Please Read and Follow!
WARNING
To prevent possible damage to cabinets
and cabinet fi nishes, use only materials and
fi nishes that will not discolor or delaminate
and will withstand temperatures up to
194°F (90°C). Heat resistant adhesive must
be used if the product is to be installed
in laminated cabinetry. Check with your
builder or cabinet supplier to make sure that
the materials meet these requirements.
WARNING
Wall ovens can not be installed sideby-side. Single wall ovens can not be
installed undercounter
WARNING
The misuse of the oven door(s) (e.g.
stepping, sitting, or leaning on them) can
result in hazards or injuries and damage
to the product.
WARNING
This appliance should not be used for
space heating. This information is based
on safety considerations.
DANGER
ELECTRICAL SHOCK
HAZARD
To avoid risk of electrical shock,
personal injury or death; verify
your appliance has been properly
connected and grounded in accordance
with local codes or in absence of codes,
with the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.
WARNING
ELECTRICAL FIRE HAZARD
Improper connection of aluminum house
wiring to copper leads can result in
an electrical hazard or fi re. Use only
connectors designed for joining copper to
aluminum and follow the manufacturer's
recommended procedure closely.
WARNING
MOVING HAZARD
To avoid risk of severe
personal injury; this appliance
requires two or more personnel
while handling and moving. Possible
use of appliance moving devices is
recommended.
CAUTION
During installation DO NOT remove the
top double wall oven door or the single
wall oven door. DO NOT push on the
outer trim. Doing so could cause the
doors to misalign, requiring repair and/or
replacement.
WARNING
The use of cabinets for storage above the
oven may result in potential fi re or burn
hazard
WARNING
DO NOT use the handle or oven door to
lift the oven. Remove lower door before
installation to ensure that it is not used to
lift the unit. Make sure latches are
properly locked in place before removing
door to prevent injury to hands and/or
fi ngers.
5
UPPE
R
OFF
LO
WER
OFF
3-1/8”
(7.9 cm)
Dimensions - VDOT
28-1/8”
(71.4 cm)
24”*
(61.0 cm)
3-7/8”
30-1/16”
(76.5 cm)
UPPER
OFF
(10.2 cm)
(9.8 cm)
(10.2 cm)
4”
4”
SIDE VIEW
7/16"
(0.44 cm)
LO
OFF
WER
50–7/8”
(129.2 cm)
20-1/2”
(52.1 cm)
TOP VIEW
50–3/8”
(128.0 cm)
*Includes stando s DO NOT REMOVE the stando s
1"
(2.5 cm)
24"*
(61.0 cm)
1"
(2.5 cm)
6
Loading...