Viking F21040 EN User Manual [EN]

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information

call 1-888-VIKING1 (845-4641)

or visit the Viking Web site at

vikingrange.com

F21040 EN

(102512)

Viking Use/Installation Guide

Brigade Range/Rangetop Accessories

32

screw

holes

HIGH-SHELF BACK

(rear view)

Rear Trim Accessories

Rear Trim Accessories

Backguards come equipped with Nylon Spacers (See Figure 1), which are needed to space the range off a
combustible wall at a prescribed safe distance.

Important: If installing the range with a backguard against a combustible wall, then the spacers are
mandatory and must remain in place on the backguard.

If installing the range with a backguard against a non-combustible wall, then the spacers can be removed
(See Figure 2).

Once you determine whether or not your product needs the provided spacers, the backguard is ready to be
attached.

ATTACHING HIGH-SHELF

Simply slide the high-shelf back down onto the rear of the unit until it settles on the shoulder screws located on
the back of the range.

ATTACHING BACKGUARD

Figure 1

Figure 2

Simply slide the backguard down onto the
rear of the unit until it settles on the shoulder
screws located on the back of the range.

screw

holes

Once the backguard is in position, attach using the
(4) screws provided.

Once the high-shelf back is in position, attach using the (4) screws provided. Once secured to the range, place
the top rolled edge (X) of the high shelf over the front lip of the high-shelf back.

X

HIGH-SHELF

(side-view)