Viking DERT300-4B, Designer DERT301-4B, VCRT301, VCRT361, VERT301-4B Installation Manual

Viking Installation Guide

Electric Induction Rangetops

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information,

call 1-888-VIKING1 (845-4641)

or visit the Viking Web site at

vikingrange.com

F20115A

(PS032607JJ

)

1

• Before beginning, please read and follow
these instructions completely and carefully.

• Do not remove permanently affixed labels,
warnings, or plates from product. This may
void the warranty.

• Please observe all local and national codes

and ordinances.

• Please ensure that this product is properly
grounded.

• Installation must conform with local codes,
or in the absence of codes, with the
National Electrical Code, ANSI/NFPA 70,
latest edition.

• In CANADA: Electrical installation must
be in accordance with the current CSA
C22.2 Canadian Electrical Codes Part 1
and/or local codes.

• Installer should leave these instructions
with the consumer who should retain for
local Inspector’s use and for future
reference.

• Consumer should retain this guide for the

local Electrical Inspector’s use.

IMPORTANT – Please Read and Follow!

General Information

2

• All openings in the wall behind the
appliance and/or in the floor under the
appliance should be sealed.

• Keep appliance area clear and free from
combustible materials, gasoline and other
flammable vapors.

• Disconnect the electrical supply prior to
servicing and/or cleaning.

• When removing the appliance for service
and/or cleaning, disconnect AC power
supply and carefully remove the appliance
by pulling forward.

• Electrical requirements are listed in the
product specifications chart. Electrical
installation should comply with national
and local codes.

• DO NOT remove protective packaging
until you are ready to perform the
installation.

Back Trim Accessories

Assembly and installation instructions are
included with all back trim accessories.

W A R N I N G

ELECTRICAL GROUNDING

INSTRUCTIONS

This applianc e must be electric ally in
accordance with local code s, or in the
absence of local code s, t he National
Electrical ANSI/NFPA 70, latest edition.

FOR PERSONAL SAFETY, THIS

APPLIANCE MUST BE PROPERLY

GROUNDED.

W A R N I N G

The use of cabinets for storage above the
appliance may result in potential fire or burn
hazard. Combusti ble items ma y ignite,
metallic items may become hot and cause
burns. If a cabinet storage is to be provided,
the risk can be reduced by installing a
rangeho od that project s horizontally a
minimum of 5” (12.7cm) beyond the bottom
of the cabinets.

Electrical Requirements

Check your national andlocal codes regarding
this unit. This rangetop is supplied with a 3
wire, 240/208 VAC, 60 Hz conduit which is
equipped with a No. 10 ground wire. See
electrical connection section for grounding
instruc tions. Th is unit s hould be fused

separately.

C A U T I O N

Be sure all electrical power is off between
the breaker box and the junction box, until
the unit is installed and ready to operate.
The junction box should be connected to a
suitable ground.

Electrical Connection

When making the wire connections, use the
entire length of the conduit provided (3 feet).
The conduit must not be cut. Connect the red
and black leads from the unit conduit to the
corresponding leads in the junction box. The
bare ground wire in the conduit is connected
to the unit frame. When connecting to a 3­conductor branch circuit, if local codes permit,
connect the bare ground connector lead of
the unit to the branch circuit neutral (gray or
white in color).

DDOO NNOOTT UUSSEE AANN EEXXTTEE NNSSIIOONN CCOORRDD WWIITTHH
TTHHIISS AAPPPPLLIIAANNCCEE.. SSUUCCHH UUSSEE MMAAYY RREESS UULLTT
IINN AA FFIIRREE,, EELLEECCTTRRIICCAALL SSHHOOCCKK OORR OOTTHHEERR
PPEERRSS OONNAALL IINNJJUURRYY..

W A R N I N G

This appliance should not be used for space
heating. This information is based on safety
considerations.

W A R N I N G

Electrical power to the unit must be shut
off while line connections are being made.
Failure to do so could result in serious
injury or death.

Dimensions & Specifications

Induction/Radiant Rangetop

Description VCRT301 VCRT361

Overall Width 29 7/8” (75.9 cm) 35 7/8” (91.1 cm)
Overall Height From

Bottom

BASE HEIGHT ADDITIONS TO BASE HEIGHT

To top of glass frame To top of island trim - add 1 1/4” (3.2 cm)
7 7/8” (20.0 cm) To top of backguard - add 6” (15.2 cm)

To top of high-shelf - add 23 1/2” (59.7 cm)

Overall Depth From
Rear

To edge of side panel - 24” (61.0 cm)

To end of control panel - 25 15/16” (65.9 cm)

To end of knobs - 27 7/16” (69.7 cm)

Cutout Width 30” (76.2 cm) 36” (91.4 cm)

Cutout Height 7 1/2” (19.1 cm)

Cutout Depth 24” (61.0 cm)

Electrical
Requirements

3 - Wire, 240/208 VAC, 60 Hz, electrical connection.
Unit is equipped with No. 10 ground wire in conduit. Should be fused separately.

Maximum Amps

240v - 37.9 amps
208v - 32.8 amps

240v - 55.0 amps
208v - 50.2 amps

Surface Element
Rating

240V 208V 240V 208V

Left Front 2500 watts 1875 watts Left Front 2200 watts 1650 watts
Left Rear 1500 watts 1125 watts Left Rear 1500 watts 1125 watts

Center Front 1800 watts 1350 watts
Bridge 800 watts 600 watts

Center Rear 1800 watts 1350 watts
Right Front 1200 watts 900 watts Right Front 1200 watts 900 watts
Right Rear 3300 watts 2475 watts Right Rear 3300 watts 2475 watts

Approx. Shipping Wt.

110 lbs. (49.5 kg) 125 lbs. (56.2 kg)

Dimensions & Specifications

3

4

All Induction Rangetop

Description VIRT301 VIRT361

Overall Width 29 7/8” (75.9 cm) 35 7/8” (91.1 cm)
Overall Height From

Bottom

BASE HEIGHT ADDITIONS TO BASE HEIGHT

To top of glass frame To top of island trim - add 1 1/4” (3.2 cm)
7 7/8” (20.0 cm) To top of backguard - add 6” (15.2 cm)

To top of high-shelf - add 23 1/2” (59.7 cm)

Overall Depth From
Rear

To edge of side panel - 24” (61.0 cm)

To end of control panel - 25 15/16” (65.9 cm)

To end of knobs - 27 7/16” (69.7 cm)

Cutout Width 30” (76.2 cm) 36” (91.4 cm)

Cutout Height 7 1/2” (19.1 cm)

Cutout Depth 24” (61.0 cm)

Electrical
Requirements

3 - Wire, 240/208 VAC, 60 Hz, electrical connection.
Unit is equipped with No. 10 ground wire in conduit. Should be fused separately.

Maximum Amps

240v - 37.9 amps
208v - 32.8 amps

240v - 56.3 amps
208v - 56.3 amps

Surface Element
Rating

240V 208V 240V 208V

Left Front 2500 watts 1875 watts Left Front 2700 watts 2025 watts
Left Rear 1500 watts 1125 watts Left Rear 1800 watts 1350 watts

Center Front 2700 watts 2025 watts

Center Rear 1800 watts 1350 watts
Right Front 1200 watts 900 watts Right Front 1200 watts 900 watts
Right Rear 3300 watts 2475 watts Right Rear 3300 watts 2475 watts

Approx. Shipping Wt.

110 lbs. (49.5 kg) 125 lbs. (56.2 kg)

Minimum Clearance from adjacent combustible construction

• Cooking surfaces and below (36” [91.4 cm] and below)

• Sides - 0”

• Rear - 0” with backguard or highshelf; 0” with island trim and non-combustible wall; 6” (15.2 cm) with
island trim and combustible rear wall

• Top grate support - 36” (91.4 cm)

• Above cooking surface (above 36” [91.4 cm])

• Sides - 6” (15.2 cm)

• Within 6” (15.2 cm) side clearance, wall cabinets no deeper than 13” (33.0 cm) must be minimum 18”

(45.7 cm) above cooking surface.

• Wall cabinets directly above product must be minimum 36” (91.4 cm) above cooking surface.