Viking DFUW1441CR, DFUW1541CR, DFUW2441CR, DFWD101, FGIM515 Installation Manual

F20690 EN

(082009J)

Viking Range Corporation

111 Front Street

Greenwood, Mississippi 38930 USA

[phone]

For product information,

call 1-888-VIKING1 (845-4641)

or visit the Viking web site at

vikingrange.com

Viking Installation Guide

DDHK29 Designer Handle Kit

For Use With DFUR, DFUW, DFRI, DFIM, DFWD101 Models

IMPORTANT–Please Read and Follow!

2 3

• Before beginning, please read these instructions completely and carefully.

• Use caution during assembly to minimize scratches.

• Do not remove permanently affixed labels, warnings or plates from the product. This may

void the warranty.

• Please refer to the DFUR, DFUW, DFRI, DFIM, DFWD101 Installation Instructions for more
information on installing the door panel.

• The installer should leave instructions with the customer who should retain for local
inspector’s use and future reference.

Parts Included

Required Tools

Handle Installation

To Install:

Installation with Wooden Full Overlay
Custom Door Front

1. Locate the wooden custom panel.

2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the four holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.

3. The Designer handle will be mounted using (4) of the #10 x 3/4” Hex head screws provided.
Using the 3/16”(0.5 cm) drill bit, drill completely through the door in the hole locations.
Using the 7/16” (1.1 cm) bit, counter-bore four holes 1/2” (1.2 cm) deep max. on the
BACKSIDE of the custom door panel.

4. Attach the Designer handle to the panel using (4) #10 x 3/4” screws provided.

Part Quantity

Designer Handles
#10 x 3/4” Hex Head Screws
Installation Instructions

(1)
(4)

Electric Drill
3/16” (0.5 cm) Drill Bit
7/16” (1.1 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Hex Head Screw Driver
Masking Tape and Pencil

C

L

A

A

13/16”

(2.1 cm)

26-7/16”

(67.2 cm)

C

L

DFUW - WINE CELLAR
DFIM - ICE MACHINE
DFUR - BEVERAGE CENTER
DFRI - COMBINATION BEVERAGE CENTER/ICE MAKER

3/4” (1.9 cm)

Full Overlay

Panel

3/16” (0.5 cm)
Thru Hole

7/16” (1.1 cm)
Counter Bore x 1/2”
Depth (max)

13/16”

(2.1 cm)

Section A-A