Viking D3 RDFN536D Installation Manual
Installation
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information, call 1-888-VIKING1 (845-4641)
or visit the Viking Website at vikingrange.com
F20876 EN
W10476847
(062012)
U
L
C
U
L
Standard-Depth Freestanding French Door
Bottom-Mount Refrigerator/Freezer
All manuals and user guides at all-guides.com
all-guides.com
IMPORTANT
It is the customer’s responsibility to:
• Contact a qualified electrical installer.
• Read all instructions before using the
refrigerator.
• Observe all local codes and ordinances.
Install refrigerator according to installation
instructions. All connections for water,
electrical power and grounding must
comply with local codes and be made by
licensed personnel when required.
• DO NOT modify plug on power cord. If
plug does not fit electrical outlet, have
proper outlet installed by a qualified
technician. Replace worn power cords
and/or loose plugs.
• Assure that the electrical installation is
adequate and in conformance with the
National Electrical Code, ANSI/NFPA
70-latest edition or Canadian Electrical
Code C22.1-1998 and C22.2 No. 0-M91
(or latest edition), and all local codes and
ordinances. (115 volt, 60-Hz, 15 amp,
fused, electrical supply is required. It is
required that a separate circuit serving only
this appliance be provided. This appliance
is equipped with a power supply cord
having a 3-prong grounding plug. To
minimize possible shock hazard, the cord
must be plugged into a mating 3-prong,
grounding type wall receptacle. If a
2-prong receptacle is encountered, the
customer must contact a qualified
electrical installer to have it replaced with a
properly grounded 3-prong receptacle.
DO NOT use an extension cord or adapter
plug.
• DO NOT ground to a gas line or cold-
water pipe.
• DO NOT remove warning tag from power
cord.
• Refrigerator is designed to operate on a
separate 115 volt, 15 amp., 60 cycle line.
• DO NOT tamper with refrigerator controls.
• DO NOT service or replace any part of
refrigerator unless specifically
recommended in Use & Care or Installation
Instructions. DO NOT attempt service if
instructions are not understood or if they
are beyond personal skill level.
• ALWAYS disconnect refrigerator from
electrical supply before attempting to
change light bulbs, clean, or service the
refrigerator. Disconnect the power cord by
grasping the plug, not the cord.
• ALWAYS read and follow manufacturer’s
storage and ideal environment instructions
for items being stored in refrigerator.
• DO NOT allow children to operate, play
with, crawl inside or stand on any part of
the refrigerator.
• DO NOT clean refrigerator parts with
flammable fluids. The fumes can create a
fire hazard or explosion.
• Clean up spills or water leakage associated
with water installation.
• Keep your refrigerator in good condition.
Bumping or dropping refrigerator can
damage refrigerator or cause refrigerator
to malfunction or leak. If damage occurs,
have refrigerator checked by qualified
service technician.
3
– Please Read and FollowTable of Contents
Warnings & Important Information_____________________________________________________3
Designer
Dimensions ______________________________________________________________________________6
Specifications ____________________________________________________________________________7
Proper Disposal (of old refrigerator) ____________________________________________________8
General Information__________________________________________________________________9
Remove the Packaging ___________________________________________________________________9
Location Requirements___________________________________________________________________9
Moving Refrigerator_____________________________________________________________________10
Electrical Requirements _________________________________________________________________10
Water Supply Requirements _____________________________________________________________11
Doors & Drawer Removal____________________________________________________________12
Remove and Replace Handles___________________________________________________________12
Remove Doors and Hinge_______________________________________________________________12
Replace Doors and Hinge _______________________________________________________________13
Remove and Replace Freezer Drawer____________________________________________________13
Replace Drawer Front ___________________________________________________________________13
Installation_________________________________________________________________________14
Water Supply Requirements _____________________________________________________________14
Connect the Water Supply ______________________________________________________________14
Connect the Water Line_________________________________________________________________14
Leveling ________________________________________________________________________________16
Door Alignment_________________________________________________________________________17
Complete Installation ___________________________________________________________________17
Performance Checklist ______________________________________________________________18
Service & Registration_______________________________________________________________19
2
All manuals and user guides at all-guides.com
IMPORTANT5– Please Read and FollowRefrigerator Safety
4
A GFI shall be used if required by NFPA-
70 (National Electric Code),
federal/state/local laws, or local
ordinances.
• The required use of a GFI is normally
related to the location of a receptacle with
respect to any significant sources of water
or moisture.
• Viking Range Corporation will NOT
warranty any problems resulting from GFI
outlets which are not installed properly or
do not meet the requirements below.
If the use of a GFI is required, it should be:
• Of the receptacle type (breaker type or
portable type NOT recommended)
• Used with permanent wiring only
(temporary or portable wiring NOT
recommended)
• On a dedicated circuit (no other
receptacles, switches or loads in the
circuit)
• Connected to a standard breaker of
appropriate size (GFI breaker of the same
size NOT recommended)
• Rated for Class A (5 mA +/- 1 mA trip
current) as per UL 943 standard)
• In good condition and free from any
loose-fitting gaskets (if applicable in
outdoor situations)
• Sheltered from moisture (water, steam,
high humidity) as much as reasonably
possible
All manuals and user guides at all-guides.com
Loading...