Vigon VC-600, VC-600S, VC-610, VC-610S Instruction Manual

VC-600 and VC-610 Series

COLOR DOME CAMERAS

About this manual

Dimensions : inch (mm)

INSTRUCTION MANUAL XX166-02

Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
This installation should be made by a qualified service person and should
conform to the National Electric Code, ANSI/NFPA 70 and all local codes.
Installers should use appropriate hardware mounting materials.

PRECAUTIONS

■ Do not open or modify
Do not open the case except during maintenance and
installation, as it may be dangerous and cause damages.

■ Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or damages.

■ Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.

■ Install away from electric or magnetic fields

■ Protect from humidity and dust

■ Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen
or boiler room, as the temperature may rise to high levels.

■ Cleaning
Dirt can be removed from the case only by wiping it
with a soft cloth moistened with a soft detergent solution.

■ Mounting Surface
The mounting surface material must be strong enough to support the
camera.

TROUBLESHOOTING

LENS ADJUSTMENT

Before sending the camera out for repair, check the items below.
If the problem persists after checking these items, contact
your service center.

■ If no image appears

Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?

■ If the image is unclear

Is the lens in focus?
Is the lens dirty?
Dirt or fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?

WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.

1. Adjust the panning(360˚) and tilt(60˚) position.

2. Set the zoom position by using Zoom Lever Screw.

3. Set the focus by using Focus Lever Screw.

4. Loosen set screws to adjust roll (turns camera position top/bottom).

PAN - 360˚

TILT - 60˚

Zoom

Focus

Set Screw
(2x)

ROLL

SPECIFICATION - VC-600, VC-600S

SPECIFICATION - VC-610, VC-610S

GENERAL Spec NTSC PAL

HQ Interline Transfer CCD 1/3" 410K Pixels Color 1/3" 470K Pixels Color
Total Number of Pixels 811(H) x 508(V) 795(H) x 596(V)
Scanning System 525 Lines 625 Lines
Horizontal Resolution
Sensitivity to Light [30IRE]
Gamma Correction
Shutter Speed 1/60 - 1/100,000[NTSC] 1/50 - 1/100,000[PAL]
S/N Ratio
Synchronization
Video Output

Control DIP Switch

BLC
ME/AE
ATW/AWB
AGC

Electrical Spec

Operating Voltage
Power Consumption

Mechanical Spec

Operation Temp
Air Humidity
Lens Mount
Connections via

550TV Lines

0.03fc, 0.3Lux(Scene) With F1.2 Lens

0.45

> 48dB [AGC off]

Internal (12VDC) / External (Line Lock, 24VAC)

1.0Vp-p/75ohm Compos ite

DIP Switch Select ON/OFF
DIP Switch Select ME/AE (ON/OFF)

DIP Switch Select ON/OFF

12VDC(11-20V), 24VAC(20-27V)
12VDC -2.3W, 24VAC - 2.6W

DIP Switch Select ATW/AWB (ON/OFF)

14°F ~ 131°F ( -10°C ~ +55°C )
Up to max.90%

3.3-12mm
BNC(VIDEO), 2P WIRE (P ower)

GENERAL Spec NTSC PAL

CCD Type 1/3" 410K P ixels Color 1/3" 470K Pixels Color
Total Number of Pixels 811(H) x 508(V) 795(H) x 596(V)
Scanning System 525 Lines 625 Lines
Horizontal Resolution
Sensitivity to Light [30IRE]
Gamma Corre ction
Shutter Speed 1/60 - 1/100,000[NTSC] 1/50 - 1/100,000[PAL]
S/N Ratio
Synchronization
Video Output

Control DIP Switch

ME/AE
ATW/AWB
WDR ON/OFF
AGC MAX ON

Electrical Spec

Operating Voltage
Power Consumption

Mechanical Spec

Operation Temp
Air Humidity
Lens Mount
Connections via

DIP Switch Select ATW/AWB (ON/OFF)

DIP Switch Select ME/AE (ON/OFF)

Up to max.90%

14°F ~ 131°F ( -10°C ~ +55°C )

DIP Switch Select ON/OFF

DIP Switch Select WDR (ON/OFF)

BNC(VIDEO), 2P WIRE(Power)

0.45

0.06fC, 0.6Lux(Scene) Wi th F 1.2 Lens

480TV Lines

1.0Vp-p/75ohm Composite

Internal (12VDC) / External (Line Lock, 24VAC)

> 45dB [AGC off]

12VDC -3.9W, 24VAC - 4.0W

12VDC(11-20V), 24VAC(20-27V)

3.3-12mm