Vigo VG6041CHCL6074 Installation Manual

VIGO INDUSTRIES INSTALLATION GUIDE FOR
SHOWER DOOR (MODEL VG06041)

SAFETY PRECAUTIONS

This Installation Guide uses the following symbols to indicate important information.
Always observe the instructions indicated by these symbols.

WARNING

Instructions that, if ignored, could result in death or serious personal injury caused by
incorrect handling or installation of the product. These instructions must be observed for
safe installation.

C AUTI ON

Instructions that, if ignored, could result in personal injury or material damage caused by
improper handling or installation of the product. These instructions must be observed for
safe installation.

IMPORTANT

Maintenance and other important non-personal injury and non-material damage instructions
or statements that should be observed.

MODEL VG06041 2

VIGO INDUSTRIES IN ST ALL A T IO N GUIDE FOR
SHOWER DOOR (MODEL VG06041)

PACKING LIST:

1. Wall mount bracket (2pc)

2. Fixed panel holders (2pc)

3. Rollers (4pc)

4. Fixed panel (1pc)

5. Door (1pc)

6. Handle assembly (1pc)

7. Fixed panel bottom clip
(1pc)

8. Door bottom guide (1pc)

9. Door threshold (1pc)

10. Door stopper (2pc)

11. Structural rail (1pc)

12. Door and fixed panel seal
strip (2pc)

13. Door seal strip (4pc)

14. Threshold extension clip
(1pc)

15. Phillips screw 2” (2pc)

16. Phillips screw 3/4” (4pc)

17. Plastic anchors (6pc)

MODEL VG06041 3

MODEL VG06041 4

WARNING

WE STRONGLY RECOMMEND THAT A LICENSED PLUMBER INSTALL THIS STANDING SHOWER
CABIN AND INCLUDE THE ASSISTANCE OF A SECOND PERSON TO INSTALL THE DOOR UNIT.

INSTALLATION OF THE SHOWER DOORS BY AN INEXPERIENCED PERSON MAY RESULT IN
GLASS BREAKAGE AND, CONSEQUENTLY, CAUSE PERSONAL INJURY OR DEATH.

BEFORE STARTING

Compare items on your invoice with what you have received. Carefully review the Packing List on page 2.
If any item is missing, please call Vigo Industries at 1-866-591-7792.

REQUIRED TOOLS

o Square and/or Phillips #1 and #2 screwdriver
o Flat head screwdriver
o Electric drill plus a 1/8”, 3/16”, or 7/32” drill bit (depending on wall)
o Level
o Measuring Tape
o Pencil (non-permanent; HB)
o Clear silicone caulking
o Utility knife

WARNING

• Handle fragile items with care to prevent personal injury or material damage.

• Glass on panels and doors is tempered glass and must never be cut to prevent personal injury.

IMPORTANT

• Fiberglass or acrylic construction might not be sufficiently strong enough to support the shower door
enclosure. You should use the wood framing from behind the face edge of the stall to provide a secure
mounting to the door. Apply a bead of silicone between the walls and base of the stall.

• For optimum performance, you should install the shower door perfectly level on a level surface.

MODEL VG06041 HAS A REVERSIBLE DOOR AND CAN THEREFORE BE INSTALLED TO EITHER
THE RIGHT OR LEFT SIDE (SEE CONFIGURATION DIAGRAM BELOW)