Vigitech TAG 702, TAG 708, TAG 707, TAG 710 Instructions Manual

GPS Camera&Navi Tracker

Instructions

TRACKERS

TAG 702 / 707 / 708 / 710

1250 S. Alhambra Circle #10

Coral Gables, FL 33146

[e-mail]

1 GPS Tracking System Introduction

GPS Camera Tracker integrates GPS and GSM functions, which could send vehicle location and
status to mobile and Internet. It can track the vehicles remotely and transmit image of the vehicle
to Internet through camera. The system structure is as below:

2 Product Description TAG 702/707/708/710

2.1 Specification

GSM module:

 Band:850/900/1800/1900MHz
 Max RF Output: 33.0dBm±2dBm
 Dynamic Input Range: -15 ~ -102dBm

1250 S. Alhambra Circle #10

Coral Gables, FL 33146

[e-mail]

GPS module:

 GPS chip set: SiRF Star III
 Frequency: L1, 1575.42 MHz
 Number of Channel: 20

Interface:

 1 Camera interface
 1 extend R232 port
 1 A/D Port
 general I/O Ports
 1 Microphone interface

Battery:

 Voltage:3.7V
 Charge:<4.2V
 Li-ion: 200~850mAh

Input Voltage: DC 9~36V

Operating Temperature:-45~65 ℃

2.2 Features:

1. Use Google map, Global free

2. Take photo of the vehicle, and Image transmit to internet.

3. Fuel Check / monitor

4. Real-time locating / inquiry

5. SOS button/Power-cut Alarm

6. Listen by telephone

7. E-fence/Over-speed Alarm

8. Compatible original anti-theft

9. Remote control engine

1250 S. Alhambra Circle #10

Coral Gables, FL 33146

[e-mail]

3 Installation Instructions

GPS1GSM

132

4

DATA1

DATA2

6

2

7

38495

10

No

.

Description

No

.

Description

1

DC+ (9~36V)

6

GND

2

Fuel check line

7

SOS button

3

GND 8 Extend port1(Assist alarm)

4

ACC

9

Extend port2

5

Engine cut_off control

10

Extend port3

SIM

MIC

PHONE

LED1 ResetLED2

3.1 Interface

DATA1

DATA2：

Camera port

1、SIM: Port for SIM card

2、PHONE: Connect to Microphone

3、MIC: Connect to earphone

4、LED1: Power light

5、LED2: Status light

6、Reset

1250 S. Alhambra Circle #10

Coral Gables, FL 33146

[e-mail]

3.2 Installation Figure

3.3 Installation and Test:

Please test after installation. If you don’t need some functions, you can disconnect
corresponding interface. Please make sure ACC, DC, GND installed correctly. Otherwise, the device
cannot work. Please check the device status through signal light after power on:

 LED1 is off indicates there is no power.
 LED2 flashes for one second which indicates GSM registers successfully.
 LED2 flashes three seconds once which indicates GPS is obtaining orientation
 LED2 is on which indicates work successfully that GSM has registered and GPS has obtained

the orientation.

 If LED 2 is on 0.1 second then off 0.1 second for more than 3 minutes, please make sure SIM

card inserts well. Without SIM card, the device cannot work.

1250 S. Alhambra Circle #10

Coral Gables, FL 33146

[e-mail]

4 SMS Operation Instruction

SMS Format: A******,cmd,param1,param2…

1. ******is the password, Initial Password is 000000

2. cmd is the command ID.

3. Param is the command parameter. Different cmd use different parameters. All the
parameters must use half-angle symbol. Wrong SMS format or wrong password, it will not
respond.

4.1 Location Enquiry (000)

Message format: A******,000

e.g. A000000,000

Reply: Longitude E113.93923 Latitude N22.54079 08-10-20 17:38:30,

User could enquiry in HTTP://maps.google.com.

4.2 Change Password (001)

Message format：A******,001,New Password

1250 S. Alhambra Circle #10

Coral Gables, FL 33146

[e-mail]