INSTALLATION MANUAL
Raked Ceiling Mount Accessory
ISSUED: MAR. 2013
NOTE: Rea d the entire instr uction manual be fore you st art ins tallati on and assembly.
WARNING
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone with good mechanical ability
who has basic building experience and fully understands this manual.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
Component Checklist
IMPORTANT: E nsu re that you h ave r ece ive d all parts a cco rdi ng to t he co mponent c hec kli st pr ior to inst all ati on.
If an y par ts ar e mis sing or fau lty, t ele phone you r loc al di str ibutor fo r a rep lac eme nt.
Package W
set scr ew( x1)
B
ceili ng pl ate ( x1)
A
Allen key (x1)
C
M8 (x6 )x70 i ron exp ansio n bolt
W-A
1.For Solid Brick and Concrete Mounting (fit flat roof or pitched roof)
60mm
45mm
60mm
(2.4")
(1.8")
2.4"( )
ø 12mm
(ø 1/2")
1
Mark the e xac t
loc ati on of
mounti ng ho les
2
Drill six pilot
holes
Screw ceiling
plate on the
ceiling
or
W-A
W-A
1-1/2 " int ern al di ameter
WARNING
Installers must verify that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
2.Installing the Pole
Threa d and t igh ten t he pole
(not in clu ded ) ont o the ceiling
plate .
B
Inser t and t igh ten o ne set
screw t o sec ure i t.
C
INSTALLATION MANUAL
Flat Panel Ceiling Mount Accessory
75x75 /10 0x1 00
200x1 00/ 200 x20 0
7
42"
MAX
ISSUED: MAR. 2013
NOTE: Rea d the entire instr uction manual be fore you st art ins tallati on and assembly.
WARNING
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
Component Checklist
IMPORTANT: E nsu re that you h ave r ece ive d all parts a cco rdi ng to t he co mponent c hec kli st pr ior to inst all ati on.
If an y par ts ar e mis sing or fau lty, t ele phone you r loc al di str ibutor fo r a rep lac eme nt.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
Package M
M4x14 ( x4)
D5 wash er (x 4)
M-A
M-E
set scr ew( x1)
B
M5x14 ( x4)
M-B
ceili ng pl ate ( x1)
A
M6x14 ( x4)
D8 wash er (x 4)
M-F
Allen key (x1)
C
M-C
M8x20 ( x4)
M-D
small s pac er (x 8)
M-G
21
1. Separating the VESA Plate
Use a pro per s cre wdr iver to loosen
the scr ew to s epa rat e the VESA plat e
from th e cei lin g mou nt accessory.
3.Installing the VESA Plate
2. Attaching the VESA Plate to the Pipe
Threa d and t igh ten t he VESA plate
onto th e pip e(n ot in cluded).
1-1/2 " int ern al di ameter
B
C
M-A
M-B
M-C
M-D
M-E
M-F
Top of the di spl ay
or
Top of the di spl ay
M-D
M-F
M-D
M-F
or
M-G
Not e: Choose the appropriate screws, wa sher s and spa cers (if necessary) acc ordi ng to the type of sc reen .
Scr ew the VE SA plate onto the displ ay.
Tig hten all screws b ut do n ot ov er ti ghten.
3
M-G
M-G
4
1b. Solid Brick and Concrete Block Mounting: 4. Hanging the Display onto the Ceiling Mount Head
1-1/2 " int ern al di ameter
5. Adjustment
+5°
-12°
adjus tme nt ha ndl e
Loose n the a dju stm ent handle to adj ust t he di spl ay to obtain the de sir ed an gle t hen tighten it.
Hook th e VES A plat e (at tached the disp lay ) ont o the c eiling mount he ad an d tig hte n the screw to secu re it .
Maint ena nce
• Check t hat t he br ack et is secure and sa fe to u se at r egu lar intervals (at l eas t eve ry three months ).
• Pleas e con tac t you r dealer if you hav e any q ues tio ns.
65
Loading...