ViewSonic VS12946, VS12914 User Manual

ViewSonic

VNB130/VNB140

NetBook

Model No. : VS12914

VS12946

Compliance Information

For U.S.A.

This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

ViewSonic VNB130/VNB140 i

Warning: You are cautioned that changes or modifications not expressly approved by the party

responsible for compliance could void your authority to operate the equipment.

For Canada

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

(For VNB130)

CE Conformity for European Countries

The device complies with the EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC.

Following information is only for EU-member states:

The mark shown to the right is in compliance with the Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE).

The mark indicates the requirement NOT to dispose the equipment as unsorted municipal waste, but use the return and collection systems according to local law.

If the batteries, accumulators and button cells included with this equipment, display the chemical symbol Hg, Cd, or Pb, then it means that the battery has a heavy metal content of more than 0.0005% Mercury or more than, 0.002% Cadmium, or more than

0.004% Lead.

ViewSonic VNB130/VNB140 ii

FCC Radiation Exposure Statement

This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This wireless module device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Industry Canada Notice

This wireless module device complies with Canadian RSS-210.To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmitting antenna) that is installed outdoors is subject to licensing. The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s web site www.hc-sc.gc.ca/ rpb.

ViewSonic VNB130/VNB140 iii

(For VNB130)

R&TTE Compliance Statement

This wireless module device complies with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC). This equipment meets the following conformance standards:

ETSI EN 300 328V1.7.1 (2006) EN 301 489-01 V1.6.1 (2005) EN 301 489-17 V1.2.1 (2002) EN 62311 (2008)

Notified Countries: Germany, UK, Netherlands, Belgium, Sweden, Denmark, Finland, France, Italy, Spain, Austria, Ireland, Portugal, Greece, Luxembourg, Estonia, Latvia, Lithuania, Czech Republic, Slovakia, Slovenia, Hungary, Poland and Malta.

ViewSonic VNB130/VNB140 iv

Important Safety Instructions

1. DO NOT press or touch the LCD Screen. DO NOT place the Notebook PC with small items, they may scratch LCD Screen or enter the Notebook PC.

2. DO NOT expose the Notebook PC to dirty or dusty environment. Keep the environment clean

and dry.

3. DO NOT place the Notebook PC on uneven or unstable work surface.

4. DO NOT place or drop objects on the top of the Notebook PC. DO NOT shove any foreign

objects into the Notebook PC. DO NOT cover the LCD Screen strongly.

5. DO NOT expose the Notebook PC to strong magnetic or electrical fields; DO NOT place the

floppy disk near or on the Notebook PC, that may loss the data of the floppy disk.

6. DO NOT leave the Notebook PC facing the sun as it can damage the LCD Screen, especially

in the car.

7. SAFE TEMP: This Notebook PC should only be used in environments with ambient

temperatures between 5° C (41° F) and 35° C(95° F).

8. DO NOT expose the Notebook PC to or use near liquids, rain, or moisture.

9. Caution: risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries

according to the instructions.

10. DO NOT throw the Notebook PC in municipal waste. Check local regulations for disposal of

electronic products. Please recycle the Battery Pack, and check with your Local Authority or retailer for recycling advice.

ViewSonic VNB130/VNB140 v

11. The Notebook PC and the Adapter may occur some heat during operating or charging. DO

NOT leave the Notebook PC on your lap or any part of the body in order to prevent discomfort or injury from heat exposure.

12. INPUT RATING: Refer to the rating label on the Notebook PC and be sure that the by the

manufacturer.

13. Checking the connections between the main unit and attachments before turning on the

Notebook PC.

14. DO NOT use the Notebook PC during eating food avoid dirtying the Notebook PC.

15. DO NOT insert anything into the Notebook PC that may result in short circuit or damage the

circuit.

16. Powering off the Notebook PC, if you want install or remove some external devices, which are

not support hot-plug.

17. Disconnect the Notebook PC from the electrical outlet and remove any installed batteries

before cleaning. And Keep it away from children.

18. DO NOT disassemble the Notebook PC, only a certified service technician should perform

repairs on your computer. Otherwise, problem may result and the manufacturer should not hold responsibility for the damage.

19. Only use Battery Packs approved by the manufacturer or else damage may occur.

20. The Notebook PC has some little metal flake to disperse heat. DO NOT place the Notebook

PC on soft objects (e.g.: bed, sofa, your lap), or else the Notebook PC may become hot and halt the system operating.

ViewSonic VNB130/VNB140 vi

Declaration of RoHS Compliance

This product has been designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and the Council on restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS Directive) and is deemed to comply with the maximum concentration values issued by the European Technical Adaptation Committee (TAC) as shown below:

Substance Proposed Maximum Concentration Actual Concentration

Lead (Pb) 0.1% < 0.1%

Mercury (Hg) 0.1% < 0.1%

Cadmium (Cd) 0.01% < 0.01%

Hexavalent Chromium (Cr

Polybrominated biphenyls (PBB) 0.1% < 0.1%

Polybrominated diphenyl ethers (PBDE) 0.1% < 0.1%

ViewSonic VNB130/VNB140 vii

)

0.1% < 0.1%

Certain components of products as stated above are exempted under the Annex of the RoHS Directives as noted below:

Examples of exempted components are:

1. Mercury in compact fluorescent lamps not exceeding 5 mg per lamp and in other lamps not

specifically mentioned in the Annex of RoHS Directive.

2. Lead in glass of cathode ray tubes, electronic components, fluorescent tubes, and electronic

ceramic parts (e.g. piezoelectronic devices).

3. Lead in high temperature type solders (i.e. lead-based alloys containing 85% by weight or

more lead).

4. Lead as an allotting element in steel containing up to 0.35% lead by weight, aluminium

containing up to 0.4% lead by weight and as a cooper alloy containing up to 4% lead by

weight.

ViewSonic VNB130/VNB140 viii

Microsoft® Corporation in the United States and other countries. ViewSonic®, the three birds logo, OnView, ViewMatch, and ViewMeter are registered trademarks

of ViewSonic® Corporation. Intel®, Pentium®, Celeron®, and Centrino® are registered trademarks of Intel Corporation. Award® is a registered trademark of Phoenix Technologies Ltd. ENERGY STAR® is a registered trademark of the U.S. Environmental Protection Agency (EPA). As an ENERGY STAR® partner, ViewSonic Corporation has determined that this product meets the

ENERGY STAR® guidelines for energy efficiency. Disclaimer: ViewSonic® Corporation shall not be liable for technical or editorial errors or

omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.

In the interest of continuing product improvement, ViewSonic® Corporation reserves the right to change product specifications without notice. Information in this document may change without notice.

No part of this document may be copied, reproduced, or transmitted by any means, for any purpose without prior written permission from ViewSonic® Corporation.

ViewSonic VNB130/VNB140 ix

+ 21 hidden pages