ViewSonic VC10 User Manual
VC10
Wireless Presentation Gateway
User Guide
Model No. VS17129
IMPORTANT: Please read this User Guide to obtain important information on installing
and using your product in a safe manner, as well as registering your product for future
service. Warranty information contained in this User Guide will describe your limited
coverage from ViewSonic Corporation, which is also found on our web site at http://
www.viewsonic.com in English, or in specic languages using the Regional selection
box in the upper right corner of our website. “Antes de operar su equipo lea cu
idadosamente las instrucciones en este manual”
Thank you for choosing ViewSonic
As a world leading provider of visual solutions, ViewSonic is dedicated to
exceeding the world’s expectations for technological evolution, innovation,
and simplicity. At ViewSonic, we believe that our products have the
potential to make a positive impact in the world, and we are confident that
the ViewSonic product you have chosen will serve you well.
Once again, thank you for choosing ViewSonic !
i
Compliance Information
Please read before proceeding
• Use only the batteries and power adapter provided by the manufacturer. The use
of unauthorized accessories may void your warranty.
• Do not store your device in temperatures higher than 50°C (122°F).
• The operating temperature for this device is from 0°C (32°F) to 35°C (95°F).
FCC Compliance Statement
The following statement applies to all products that have received FCC approval.
Applicable products bear the FCC logo, and/or an FCC ID in the format FCC ID:
GSS-VS15989 on the product label.This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation. This
mobiledevice has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequencyenergy
and, if not installed and used in accordance with the instructions, may cause
harmful interferenceto radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for
compliance could void theuser’s authority to operate the equipment.The antenna(s)
used for this transmitter must not be colocated or operating in conjunction with any
otherantenna or transmitter.
The device was tested and complies to measurement standards and procedures
specied in FCC OET Bulletin 65, Supplement C
ii
FCC SAR Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specic operating instructions
for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body.
The users manual or instruction manual for an intentional or unintentional radiator
shall caution the user that changes or modications not expressly approved by
the party responsible for compliance could void the user's authority to operate the
equipment.
CE Conformity for European Countries
The device complies with the EMC Directive 2014/30/EU and Low Voltage
Directive 2014/35/EU.
Following information is only for EU-member states:
The mark shown to the right is in compliance with the Waste Electrical and
Electronic Equipment Directive 2012/19/EU (WEEE).
The mark indicates the requirement NOT to dispose the equipment as
unsorted municipal waste, but use the return and collection systems
according to local law.
If the batteries, accumulators and button cells included with this equipment,
display the chemical symbol Hg, Cd, or Pb, then it means that the battery has
a heavy metal content of more than 0.0005% Mercury, or more than 0.002%
Cadmium, or more than 0.004% Lead.
European Union Regulatory Conformance
The equipment complies with the RF Exposure Requirement 1999/519/EC, Council
Recommendation of 12 July 1999 on the limitation of exposure of the general
public to electromagnetic elds (0-300 GHz). This equipment meets the following
conformance standards: EN301489-1, EN301489-17, EN60950-1, EN300328.
We, hereby, declare that this Wi-Fi radio is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
iii
IC Warning Statement
This device complies with Industry Canada license- exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : ( 1 ) l’appareil ne doit pas produire de brouillage, et ( 2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, méme si le brouillage est
susceptible d’en compromettre le fonctionnement.
Country Code Statement
For ptoduct available in the USA/Canada market, only channe 1~11 can be operated.
Selection of other channels is not possible.
Pour les produits disponibles aux États-Unis/Canada du marché, seul le canal 1 à 11
peuvent être exploités. Sélection d’autres canaux n’est pas possible.
For MPE Statement – Mobile device
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complied with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies
pour un environnement non contrôlê. Cet équipement doit être installé et utilize avec
un minimum de 20cm de distance entre la source de rayonnement et votre corps.
iv
Declaration of RoHS2 Compliance
This product has been designed and manufactured in compliance with Directive
2011/65/EU of the European Parliament and the Council on restriction of the use
of certain hazardous substances in electrical and electronic equipment (RoHS2
Directive), and is deemed to comply with the maximum concentration values issued
by the European Technical Adaptation Committee (TAC) as shown below:
Substance
Proposed Maximum
Concentration
Actual Concentration
Lead (Pb) 0.1% < 0.1%
Mercury (Hg) 0.1% < 0.1%
Cadmium (Cd) 0.01% < 0.01%
Hexavalent Chromium (Cr
6+
) 0.1% < 0.1%
Polybrominated biphenyls (PBB) 0.1% < 0.1%
Polybrominated diphenyl ethers (PBDE) 0.1% < 0.1%
Certain components of products as stated above are exempted under the Annex III
of the RoHS2 Directives as noted below:
Examples of exempted components are:
1. Mercury in cold cathode uorescent lamps and external electrode uorescent
lamps (CCFL and EEFL) for special purposes not exceeding (per lamp):
(1) Short length (≦500 mm): maximum 3.5 mg per lamp.
(2) Medium length (＞500 mm and ≦1,500 mm): maximum 5 mg per lamp.
(3) Long length (＞1,500 mm): maximum 13 mg per lamp.
2. Lead in glass of cathode ray tubes.
3. Lead in glass of uorescent tubes not exceeding 0.2% by weight.
4. Lead as an alloying element in aluminium containing up to 0.4% lead by weight.
5. Copper alloy containing up to 4% lead by weight.
6. Lead in high melting temperature type solders (i.e. lead-based alloys containing
85% by weight or more lead).
7. Electrical and electronic components containing lead in a glass or ceramic other
than dielectric ceramic in capacitors, e.g. piezoelectronic devices, or in a glass or
ceramic matrix compound.
v
Contents
Compliance Information
FCC Compliance Statement ...................................................................................i
CE Conformity for European Countries ................................................................. ii
IC Warning Statement .......................................................................................... iii
Declaration of RoHS2 Compliance ....................................................................... iv
Copyright Information
Product Registration ............................................................................................ vii
For Your Records ................................................................................................ vii
General
Hardware Installation .............................................................................................1
App (iOS/Android) .................................................................................................2
iOS System requirements ..........................................................................................................2
Android OS System requirements .............................................................................................2
Start up ......................................................................................................................................2
Download ...................................................................................................................................2
Device Connection ....................................................................................................................3
App starts (below photos are based on iOS version) ................................................................3
App Features .............................................................................................................................5
Special Features..................................................................................................11
Preferred Device ......................................................................................................................11
Host control .............................................................................................................................12
Installation (Windows) .........................................................................................17
Download and Install ...............................................................................................................18
Next .........................................................................................................................................18
Install progress ........................................................................................................................19
Request from Guest ................................................................................................................22
Denied by Host ........................................................................................................................22
Mirror the complete screen ......................................................................................................23
Make vPresenter Pro devide as an extension screen .............................................................23
Web Browser ...........................................................................................................................25
Online Video ............................................................................................................................26
Setting .....................................................................................................................................29
Connection ..............................................................................................................................34
Connection ..............................................................................................................................34
vi
Installation (Mac) .................................................................................................35
Download and Install ...............................................................................................................36
Next .........................................................................................................................................36
Mirror .......................................................................................................................................44
Extension .................................................................................................................................44
Split screen ..............................................................................................................................45
Update .....................................................................................................................................45
Setting .....................................................................................................................................48
Connection ..............................................................................................................................53
Connection ..............................................................................................................................53
Other Information
Customer Support ...............................................................................................54
Limited Warranty .................................................................................................55
Mexico Limited Warranty .....................................................................................57
vii
Copyright Information
Copyright © ViewSonic Corporation, 2017. All rights reserved.
ViewSonic and the three birds logo are registered trademarks of ViewSonic
Corporation.
VESA is a registered trademark of the Video Electronics Standards Association.
DPMS, DisplayPort, and DDC are trademarks of VESA.
ENERGY STAR® is a registered trademark of the U.S. Environmental Protection
Agency (EPA).
As an ENERGY STAR® partner, ViewSonic Corporation has determined that this
product meets the ENERGY STAR® guidelines for energy efficiency.
Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors
or omissions contained herein; nor for incidental or consequential damages resulting
from furnishing this material, or the performance or use of this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves
the right to change product specifications without notice. Information in this
document may change without notice.
No part of this document may be copied, reproduced, or transmitted by any means,
for any purpose without prior written permission from ViewSonic Corporation.
Product Registration
To meet your future needs, and to receive any additional product information as it
becomes available, please register your product on the Internet at:
www.viewsonic.com.
For Your Records
Product Name:
Model Number:
Document Number:
Serial Number:
Purchase Date:
VC10
Wireless Presentation Gateway
VS17129
VC10_UG_ENG Rev. 1A 08-25-17
Proper product disposal is necessary at the end of product life
ViewSonic respects the environment and is committed to working and living green.
Thank you for being part of a Smarter, Greener Computing effort.
Please visit the ViewSonic website to learn more.
USA & Canada: http://www.viewsonic.com/company/green/recycle-program/
Europe: http://www.viewsoniceurope.com/uk/support/recycling-information/
Taiwan: http://recycle.epa.gov.tw/recycle/index2.aspx
1
General
“EZCast Pro” is a new product based on successfulwireless app EZCast, and adds
some new features for commercial/educational application. It supports Multi-users
Display under our new Host Control System and Content Broadcasting function.
There are still more new features to be added soon, please download and enjoy our
EZCast Pro features with hardware!
Hardware Installation
LED Indicator
HDMI port + DC power
MHL port
The EZCast Pro dongle is compatible with MHL interface, so there are 2 ways to
connect with EZCast Pro dongle with your receiver devices like TV, Monitor or
Projector. Use the switch to choose HDMI output or MHL output, please be noted
your MHL device must provide 900mA power, and if you use HDMI out, you will need
external 5V/1A DC power to bring up the dongle.
MHL
MHL
Plug into MHL port directly to use it
directly.
*Requires 900mA from MHL port
Use external DC power, and make sure
you’re your USB DC power can provide
1A current.
2
App Installation
• IOS and Android users:
• Please search “EZCast Pro” in Apple’s App Store or Google Play and install it.
• Or Use the QR scanner app to scan the QR code on EZCast LAN’s main
page.
*Supports iOS9 and Android 4.2 above
• Windows and Mac OS users:
• Please download it from our official website: www.iezcast.com or
www.iezvu.com
*Supports from Windows 7/8.1/10, and Mac OS 10.10 and after.
• Get Started (ex: iOS version)
• Enter your NB/PC/Smartphone/Tablet’s WiFi setting, find the SSID
(EZCastPro_xxxxxxxx or Pro D01_xxxxxxxx) and connect with it.
• Open EZCastPro app on your device.
• Once you’ve connected to EZCastPro, the on-screen link status will
beupdated and show how many devices are linking to it directly.
3
App starts(below photos are based on iOS version)
• When you execute the app, if you are not linking to EZCast Pro, youcan only
use several functions in offline mode.
• Click “EZCastPro” icon, the device will be listed, you can select thedevice you
like to cast if there are more than one.
--> Discover device
--> Input IP or Miracode to link manually
--> Work under offline mode
Note: EZCastProapponlyworkswithEZCastProhardwarenow,it’snotcompatiblewithno
rma lEZCastproduct.
• Click “EZCastPro” icon, the device will be listed, you can select thedevice you
like to cast if there are more than one.
• If you are not linking to EZCast Pro, youcan only use several functions in
offline mode.
Note: EZCastProapponlyworkswithEZCastProhardwarenow,it’snotcompatiblewithno
rma lEZCastproducts.
Loading...