ViewSonic PJ551D User Manual
ViewSonic
®
PJ551D
DLP Projector
IMPORTANT: Please r ead this User Guide to obtain important information on
installing and using your product in a safe man ner, as well as register ing your
product for future service. Warranty information contained in this User Guide will
describe your limited coverage from ViewSonic Corporation, whi ch is also found
on our web site a t http://www.views onic.com in English, or in specic languages
using the Regional selection box in the upper right corner of our website.
“Antes de operar su equipo lea cuidadosamente las instrucciones en este manual”
- User Guide
- Guide de l’utilisateur
- Bedienungsanleitung
- Guía del usuario
- Guida dell’utente
- Guia do usuário
- Användarhandbok
- Käyttöopas
- Руководство пользователя
- 使用手冊 (繁體)
- 使用手冊 (簡體)
- 사용자 안내서
Model No. : VS11973
PJ551DViewSonic i
Compliance Information
FCC Statement
This device complies with part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: You are cautioned that changes or modications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
For Canada
• This Class B digital apparatus complies with Canadian ICES-003.
• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
CE Conformity for European Countries
The device complies with the requirements of the EEC directive 89/336/EEC as
amended by 92/31/EEC and 93/68/EEC Art.5 with regard to “Electromagnetic
compatibility”, and 73/23/EEC as amended by 93/68/EEC Art.13 with regard to “Safety.”
Following information is only for EU-member states:
The mark shown to the right is in compliance with the Waste Electrical and Electronic
Equipment Directive 2002/96/EC (WEEE).
The mark indicates the requirement NOT to dispose the equipment as unsorted municipal
waste, but use the return and collection systems according to local law.
PJ551DViewSonic ii
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this unit near water.
6. Clean with a soft, dry cloth. If still not clean, see “Cleaning the Display” in this guide for
further instructions.
7.
Do not block any ventilation openings. Install the unit in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
devices (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade and the third prong are provided for your safety. If
the provided plug does not t into your outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs. Convenience
receptacles and the point where they exit from the unit. Be sure that the power outlet is
located near the unit so that it is easily accessible.
11. Only use attachments/accessories specied by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specied by the
manufacturer, or sold with the unit. When a cart is used, use caution when
moving the cart/unit combination to avoid injury from tipping over.
13. Unplug this unit when unused for long periods of time.
14. Refer all servicing to qualied service personnel. Servicing is required when the unit has
been damaged in any way, such as: if the power-supply cord or plug is damaged, if liquid is
spilled onto or objects fall into the unit, if the unit is exposed to rain or moisture, or if the
unit does not operate normally or has been dropped.
PJ551DViewSonic iii
Declaration of RoHS Compliance
This product has been designed and manufactured in compliance with Directive 2002/95/EC of
the European Parliament and the Council on restriction of the use of certain hazardous substances
in electrical and electronic equipment (RoHS Directive) and is deemed to comply with the
maximum concentration values issued by the European Technical Adaptation Committee (TAC)
as shown below:
Substance
Proposed Maximum
Concentration
Actual Concentration
Lead (Pb) 0.1% < 0.1%
Mercury (Hg) 0.1% < 0.1%
Cadmium (Cd) 0.01% < 0.01%
Hexavalent Chromium (Cr6+) 0.1% < 0.1%
Polybrominated biphenyls (PBB) 0.1% < 0.1%
Polybrominated diphenyl ethers (PBDE) 0.1% < 0.1%
Certain components of products as stated above are exempted under the Annex of the RoHS
Directives as noted below:
Examples of exempted components are:
1. Mercury in compact uorescent lamps not exceeding 5 mg per lamp and in other lamps not
specically mentioned in the Annex of RoHS Directive.
2. Lead in glass of cathode ray tubes, electronic components, uorescent tubes, and electronic
ceramic parts (e.g. piezoelectronic devices).
3. Lead in high temperature type solders (i.e. lead-based alloys containing 85% by weight or
more lead).
4. Lead as an allotting element in steel containing up to 0.35% lead by weight, aluminium
containing up to 0.4% lead by weight and as a cooper alloy containing up to 4% lead by
weight.
PJ551DViewSonic iv
Copyright Information
Copyright© ViewSonic© Corporation, 2007. All rights reserved.
Macintosh and Power Macintosh are registered trademarks of Apple Computer, Inc.
Microsoft, Windows, Windows NT, and the Windows logo are registered trademarks of Microsoft
Corporation in the United States and other countries.
ViewSonic, the three birds logo, OnView, ViewMatch, and ViewMeter are registered trademarks
of ViewSonic Corporation.
VESA is a registered trademark of the Video Electronics Standards Association. DPMS and DDC
are trademarks of VESA.
PS/2, VGA and XGA are registered trademarks of International Business Machines Corporation.
Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or
omissions contained herein; nor for incidental or consequential damages resulting from furnishing
this material, or the performance or use of this product.
In the interest of continuing product improvement, ViewSonic Corporation reserves the right to
change product specications without notice. Information in this document may change without
notice.
No part of this document may be copied, reproduced, or transmitted by any means, for any
purpose without prior written permission from ViewSonic Corporation.
Product Registration
To meet your future needs, and to receive any additional product information as it becomes
available, please register your product on the Internet at: www.viewsonic.com. The ViewSonic®
Wizard CD-ROM also provides an opportunity for you to print the registration form, which you
may mail or fax to ViewSonic.
For Your Records
Product Name:
Model Number:
Document Number:
Serial Number:
Purchase Date:
PJ551D
ViewSonic DLP Projector
VS11973
PJ551D_UG_ENG Rev. 1A 08-27-07
_____________________________________
_____________________________________
The lamp in this product contains mercury.
Please dispose of in accordance with local, state or federal laws.
Contents
Introduction......................................................................1
Projector Features...................................................................................................1
Package Contents...................................................................................................2
Projector Overview..................................................................................................3
Using the Product............................................................5
Control Panel..........................................................................................................5
Connection Ports.....................................................................................................6
Remote Control.......................................................................................................7
Replacing the Battery..............................................................................................8
Remote Control Operation............................................................................. ... ......9
Installation......................................................................10
Connecting the Projector.......................................................................................10
Powering On/Off the Projector..............................................................................11
Adjusting the Projector..........................................................................................12
Menu Operation..............................................................14
Maintenance ...................................................................18
Cleaning the Lens.................................................................................................18
Cleaning the Projector Housing ............................................................................18
Replacing the Lamp..............................................................................................19
Specifications.................................................................21
Appendix .........................................................................22
LED Indicator Messages.......................................................................................22
Compatibility Modes..............................................................................................23
Troubleshooting....................................................................................................24
ViewSonic PJ551D
Introduction
* means compressed.
Ground
Projector Features
The projector integrates high-performance optical engine projection and a user - friendly
design to deliver high reliability and ease of use.
The projector offers the following features:
Single chip 0.55" Texas Instruments DLP
XGA (1024 x 768 pixels)
Auto image re-sizing (Auto-Sync.) to 1024 x 768 full screen with scaling compression
compatibility for VGA, SVGA, XGA and SXGA*
Compatibility with Macintosh
®
computers
Compatibility with NTSC, PAL, SECAM and HDTV
D-Sub 15-pin terminal for analog video connectivity
User-friendly, multi-language on-screen display
Advanced electronic keystone correction
Notes on the AC Power Cord
AC Power Cord must meet the requirement of countries where you use this projector.
Please confirm your AC plug type with the graphics below and ensure that the proper AC
Power Cord is used. If the supplied AC Power Cord does not match your AC outlet, please
contact your sales dealer. This projector is equipped with a grounding type AC line plug.
Please ensure that your outlet fits the plug. Do not defeat the safety purpose of this
grounding type plug. We highly recommend using a video source device also equipped
with a grounding type AC line plug to prevent signal interference due to voltage
fluctuations.
®
technology
ViewSonic 1 PJ551D
Package Contents
Save the original shipping ca rton and packing material; they wi l l comein handy
if you ever to ship your un it. For m axim um pr otection , rep ack yo ur uni t as it wa s
originally packed at the factory.
Accessories and components may vary by retailer and region.
When you unpack the projector, make sure you have all these compon ents:
Projector with Lens Cap AC Power Cord VGA Cable (D-SUB to D-SUB)
Remote Control (IR) User’s Manual Quick Start Guide
ViewSonic 2 PJ551D
Projector Overview
1
2 4 5 63
7 9
10 8
11
1
7
2
8
3
9
4
10
5
11
6
Front View
Lens cap AC power socket
Elevator button Control panel
Lens cap strap Zoom ring
Projection lens Focus ring
Front IR remote control sensor Lamp cover
Ventilation holes
ViewSonic 3 PJ551D
Rear View
1
3
2
4
1
2
3
4
1
2
3
1
2
3
This projector can be used with a ceiling mount for support. The ceiling mount is
not included in the package.
Connection ports
Kensington lock
Rear IR remote control sensor
Ventilation holes
Bottom View
Elevator foot
Ceiling mount
Tilt-adjustment foot
ViewSonic 4 PJ551D
Using the Product
1 2
3
4
568 7
1
2
3
4
5
6
7
8
Control Panel
LED
Lamp (Lamp LED indicator)
Refer to “LED Indicator Messages”.
Temp (Temperature LED indicator)
Refer to “LED Indicator Messages”.
Button Function
Four directional buttons
Use four directional buttons to select items or make adjustments to your selection.
Enter
Enter to sub-menu and confirm the menu selection. Activate in Color Setting, Lamp
Counter Reset and Factory Default menu operations.
Resync
Resynchronize the projector to the input signal from a computer.
Power
Turn the projector on or off.
Menu
Display or exit the on-screen display menus.
Source
Manually select an input source.
ViewSonic 5 PJ551D
Loading...