VIEWONHOME VOH1010 Operation Manual

8

VOH1010

Wireless Gas Detector

Product Introducon

Product Features

Technical Specficaon

Installaon

Installaon Guide Layout

Operang Instrucon

Switch to Connection Mode on the control panel. Press the test
button of the sensor twice. The control panel beeps once: the
motion detector is registered. If you hear two beeps,the detector
has already been connected.

To check if the registration is complete, arm the system and
trigger the sensor again. If the siren rings out, the registration
is successful.

This product bears the selective sorting symbol for

.)EEEW( tnempiuqe cinortcele dna lacirtcele etsaw

This means that this product must be handled pursuant

to European.

Directive 2002/96/EC in order to be recycled or
dismantled to minimize its impact on the
environment.
For further information,please contact your local or
regional authorities.
Electronic products not included in the selective
sorting process are potentially dangerous for the
environment and human heath due to the presence of
hazardous substances.

In compliance with European law.

This product was designed and manufactured in
compliance with Directive 2002/95/EC of the
European Parliament and of the Council on the
restriction of use of certain hazardous substances in
electrical and electronic equipment (RoHS Directive

- Rohs) and is deemed to comply with the maximum
concentration values set by the European Technical

Tesng

Failure Analysis & Treatments

Standards

Emergency Alarm Treatment

Register the Detector in the Alarm System

Warning