Viesa holiday ii User Manual

E C O L O G I C A L C O O L E R S

HOLIDAY II

User’s Manual

www.viesa.ca / 1-888 438-8444

IMPORTANT

Installation requires an experienced mechanic with specific knowledge in the installation of
the VIESA Ecological Cooler. Installation, disassembly, repairs and maintenance
must be performed by an Authorized Installer. Authorized Installer must use proper
protective equipment when installing the system.

Improper installation or use of unauthorized parts can cause malfunctions, loss of battery life
or other consequences which may result in serious injury.

Manufacturer or Distributor will not be responsible for injuries or damages resulting from
misuse of equipment, use contrary to operating instructions or installation by any person
other than an Authorized Installer.

Information contained in this manual is subject to change. Manufacturer reserves the right,
without notice, to make changes in equipment design or components as progress in
engineering, manufacturing or technology may warrant.

World-wide Patents
VIGIA is a trademark of Col-Ven S.A.

Function

To lower the inside temperature of the caravan’s cabin using evaporative cooling.

Operation

The unit is equipped with an electrovalve that is activated by two sensors located
at the front and back of the unit. The electrovalve allows passage of water from
pressurized pipes to the unit where a tank tray stores it. A centrifugal pump
carries the water from the tank tray to a distributor coil that constantly and
homogeneously moistens the evaporator contained in the unit. A biturbo blower
pushes the exterior air to the interior of the caravan forcing the air through the
evaporator and therefore cooling the warm air.

BOARD INDICATIONS

Important: before switching on the equipment:

With parked vehicle: Open 2 to 3 cms.one of the windows
With the vehicle in motion: Open 2 to 3 cms and one of the windows

close all other air entrances to the cabin so that hot air does not
enter from the exterior.

BOARD

TO POWER ON
AND OFF THE EQUIPMENT
(TURBO BLOWER AND CON­TROL OF THE WATER PUMP)

REMOTE CONTROL
RECEIVER

Menu

TO SEE AND

Menu

ENTER FUNCTIONS:
TIME SETTING
SELF POWER ON
SELF POWER OFF
WORKING HOURS

Note: time is expressed in 24H mode.

DISPLAYS
FUNCTIONS AND
PARAMETERS OF
THE EQUIPMENT

AUTO

Dry

TO INCREASE
AND/OR LOWER THE
SPEEDS OF THE TURBO
BLOWER AND SET
CLOCK,
SELF POWER ON AND
SELF POWER OFF

TO TURN ON
OR OFF THE
OPERATION OF THE
WATER CYCLE

Power

Dry

KEEP IT PRESSED

Power

FOR 2 SECONDS:
IT SHUTS DOWN
THE EQUIPMENT
COMPLETELY
(DISPLAY OFF)
AND IT RESTARTS
IT

TO ACTIVATE
THE AUTOMATIC DRYING
SYSTEM: TURBO BLOWER
TO TOP SPEED UNTIL THE
EVAPORATOR FILTER GETS
DRY

REMOTE CONTROL

Performs all the functions explained before, except when the

equipment is off.

Instruction for the Dry

key: It activates the drying system;

turbo blower to top speed UNTIL the evaporator filter gets totally dry.

- Keep the batteries of the remote control away from children. Wrong use may
cause fire or burns. Do not recharge or heat batteries.

Dispose dead batteries according to local laws. Replace batteries with the

same type (AAA).

- Batteries may explode if not correctly inserted. Immediately dispose of dead
batteries. Do not throw them into fire.