vienybe SIRIJUS 20, SIRIJUS 30 Technical Datasheet, Installation And Operation Manual

Technical Datasheet, installation and Operation Manual 3

SOLID FUEL BOILERS

SIRIJUS 20
SIRIJUS 30

LST EN 303-5 GOST 20548

ENG

Sirijus 20, 30 (13.05) V1 LT

Sirijus 20, 30 Sirijus 20, 30

Sirijus 20, 30 (13.05) V1 LT Sirijus 20, 30 (13.05) V1 LT

13. CERTIFICATE OF ACCEPTANCE

Heating boiler “SIRIJUS -“ “,

Serial No. ____________________

Meets the requirements of LST EN 303-5 and GOST 20548 and is suitable for use.

Date of manufacture ________________________
TKS Controller ____________________________

TKS Seal _____________________________
Packed by ___________________________

______________________________________________________

date of receipt (purchase) of the product, signature

Table of Contents

1. General information................................................................. 4

2. Technical Data........................................................................ 5

3. Description of the Design.........................................................6

4. Transportation and Storage................................................... 7

5. Installation of the boiler .......................................................... 7

5.1. Mounting location........................................................... 7

5.2. Chimney and Flue.......................................................... 7

5.3. Connection to the Heating System .................................8

5.4. Connection of the Boiler Cooling System …...................10

6. Operation of the Boiler............................................................ 12

6.1. Firing…………………………………………………...……12

6.2. Adjustment of Draft Control............................................12

6.3. Heating.......................................................................... 12

6.4. Cleaning........................................................................ 13

6.5. Fuel.............................................................................. 14

6.6. Replaceable parts during operation............................. 14

6. Safety ………………………….…...........................................14

8. Disposal..................................................................................15

9. Risk Analysis and Troubleshooting ........................................15

10. Scope of Supply ...................................................................16

11. Warranty .............................................................................. 16

12. Warranty Claim Form .......................................................... 17

13. Certificate of Acceptance .....................................................18

To be filled in by a seller

Sirijus 20, 30 Sirijus 20, 30

Sirijus 20, 30 (13.05) V1 LT Sirijus 20, 30 (13.05) V1 LT

Dear Buyer!

Thank You for purchasing our company’s article and for the confidence in products of JSC
“UMEGA”.

We wish you success in use of it!

JSC “UMEGA”

1.GENERAL INFORMATION

Solid fuel boilers “SIRIJUS-20”, “SIRIJUS-30” (hereinafter – the boiler) are intended for:

- heating of residential houses,

- heating of administration offices or industrial premises.
Fuel suitable for the boiler *:

- wood,

- coal

- peat briquettes,

- compounds of the above listed fuels.
* fuel wetness not exceeding 20%
Boiler “SIRIJUS” are designed in compliance with all the applicable up -to-date economic,

environmental, and safety requirements and have good performance characteristics.
Shell is a welded carbon steel sheet of 5-4 mm thickness, with channels where water circulates.

The boiler has:

- Primary and secondary air supply,

- high degree of heat insulation,

- a high efficiency coefficient.

NOTICE! Before installation and operation of the heating boiler-oven, please read this
manual. This will help You to properly install and the most effectively use the product
purchased and to avoid accidents.
When buying the boiler, please read terms of warranty, make sure that the certificate of
acceptance is filled in completely and correctly.

12. WARRANTY CLAIM FORM

To General Director of JSC “Umega”

I .................................................................................. have acquired the product made by

(name, surname or name of company)

your company:......................................................................., serial No. …………......…………., …

(product name) (date of manufacture)
…...…………………………………………... ……………………………………………….……………
(date, place of purchase, name and number of the purchase document)

I have read the product data sheet and hereby declare that the product has been installed in
accordance with the requirements, established by the manufacturer in the data sheet, and is used
for its intended purpose, without violating the requirements of the operation manual. Given that, I
have the following claim against this product:

…………………….…………………….…………………….......…………………..………………….

…………………………………………………………………….......………………………………….

…………………………………………………………………………... ...………………………….…

……………………………………………………………………………….......………………….……

…………………………………………………………………………………….......………….………

………………………………………………………………………………………….......….…………

…………………………………………………………………………………………….........…………

…………………………………………………………………………………………….……........……

…………………………………………………………………………………………….……………....

…………………………………………………………………………………………….……………...

…………………………………………………………………………………………….……………....

Assuming that the deficiencies, expressed in the claim, were affected by defects of your product,
please send your representative to inspect the product installed, detect the defects, and eliminate
them. If these deficiencies are found to have occurred due to improper connection or use of the
product, or there are no defects under the warranty, I shall undertake to cover travel expenses for
the arrival of your representatives (0.8 Lt/km) and the time spent on travel and on-site inspection
30 Lt/h) to each employee of the service team (no more than to three employees).

If, within 7 calendar days, I fail to cover the above expenses, I agree to recovery of them
against me in the manner prescribed by the legislation of Lithuania.

My address ……………………………………………., phone…. …………………….
……………………………………………………………………………………………..

Name, surname Signature