Page 1
Advantix Vario accessory set
Instructions for Use
suitable for Advantix vario standing grate model 4965.30,
4965.31, 4965.32, 4965.33
Model Year built:
4965.86 from 08/2011
en_INT
Page 2
Advantix Vario accessory set 2 from 9
Page 3
Table of contents
1 About these instructions for use 4
Table of contents
1.1
1.2
1.3
Target groups 4
About this translated version 4
Other applicable documents 4
2 Product information 5
2.1
2.2
2.2.1
Standards and regulations 5
Product description 5
Overview 6
3 Handling 7
3.1
3.2
Assembly 7
Disposal 9
Advantix Vario accessory set 3 from 9
Page 4
About these instructions for use
1 About these instructions for use
Trade mark rights exist for this document, further information can be
found at viega.com/legal.
1.1 Target groups
The information in this instruction manual is directed at the following
groups of people:
n Heating and sanitary professionals and trained personnel
n Tilers
It is not permitted for individuals without the abovementioned training or
qualification to mount, install and, if required, maintain this product. This
restriction does not extend to possible operating instructions.
1.2
1.3
The installation of Viega products must take place in accordance with
the general rules of engineering and the Viega instructions for use.
About this translated version
This instruction for use contains important information about the choice
of product or system, assembly and commissioning as well as intended
use and, if required, maintenance measures. The information about the
products, their properties and application technology are based on the
current standards in Europe (e. g. EN) and/or in Germany
(e. g. DIN/DVGW).
Some passages in the text may refer to technical codes in Europe/
Germany. These should serve as recommendations in the absence of
corresponding national regulations. The relevant national laws, stand‐
ards, regulations, directives and other technical provisions take priority
over the German/European directives specified in this manual: The
information herein is not binding for other countries and regions; as said
above, they should be understood as a recommendation.
Other applicable documents
This instruction for use describes the mounting of an accessory set for
an Advantix Vario shower channel in rough steps.
The instructions for use of the Advantix Vario shower
channel must also be strictly observed for the mounting of
the accessory set.
Advantix Vario accessory set 4 from 9
Page 5
2 Product information
2.1 Standards and regulations
The following standards and regulations apply to Germany / Europe.
National regulations can be found on the relevant web site of your
country at viega.com/standards.
Regulations from section: Sealing
Scope / Notice Regulations applicable in Ger‐
Product information
many
Stress class of the underground,
as well as suitable bonded sealing
Stress class of the underground,
as well as suitable bonded sealing
Approved bonded sealings with
proof of practicability in keeping
with building law for stress
classes A and AO
Approved bonded sealings with
proof of practicability in keeping
with building law for stress
classes A, B and C
Permitted bonded sealings EN 14891
Regulations from section: Media
Scope / Notice Regulations applicable in Ger‐
Typical domestic wastewater DIN 1986-3
ZDB-Merkblatt 8/2012
Leitfaden zur Abdichtung im Ver‐
bund (AIV)
ETAG 022 T1
DIBt-Bauregelliste A, Teil 2 des
DIBt und Prüfgrundsätze für
Abdichtungen im Verbund
(PG AIV-F)
many
2.2 Product description
The accessory set standing grate may only be mounted in Viega
Advantix Vario shower channel model 4965.10.
Model 4965.86 Advantix accessory set
Article 686 383 matt version
Advantix Vario accessory set 5 from 9
Description
standing grate, complete set
for the use of shortened
standing grates, with cover
caps
Page 6
4 1
3 2
Product information
2.2.1 Overview
Description
689 728 polished version
713 072 black version
713 089 white version
Fig. 1: Scope of delivery
1 - grate supports
2 - screws
3 - cover caps
4 - grate holder
Advantix Vario accessory set 6 from 9
Page 7
3 Handling
3.1 Assembly
Handling
Remove protective insert.
Insert screws.
Place the grate holder onto the screw and adjust to tile height.
The maximum height of the standing grate is 20 mm above the
flange.
When using the natural stone set, the maximum height of the
standing grate is 30 mm above the flange.
Advantix Vario accessory set 7 from 9
Page 8
Handling
The upper edge of the grate holder must be approx. 1 mm below the
upper edge of the tiles.
Secure the grate supports to the standing grate.
Distribute the standing grate supports in such a way that there is a
grate support fitted after every one third of the grate.
Insert standing grate.
Replace cover caps.
Advantix Vario accessory set 8 from 9
Page 9
3.2 Disposal
Handling
The cover caps can be moved by up to 9 mm (see fig,).
Separate the product and packaging materials (e. g. paper, metal,
plastic or non-ferrous metals) and dispose of in accordance with valid
national legal requirements.
Advantix Vario accessory set 9 from 9
Loading...