Videofield SE650, SE550, SE750 Installation Instructions Manual

Exterior Siren/Strobe Model SE650/SE550/SE750

I N S T A L L A T I O N I N S T R U C T I O N S

Made b y RS I VID EO TE CHNO LOGIE S 101 2-c Feb ruar y 20 08

Product Summary

The Exterior Siren/Strobe Model SE650/SE550/SE750 is a wireless
siren designed for use in RSI VIDEO TECHNOLOGIES™ security sys­tems. The siren includes the following features:

Totally wireless, battery operated

>

Weather-resistant enclosure

>

Dual tamper function provides detection for both wall

>

and cover tamper.

Transmits check-in/status signal every 8 minutes

>

Programming/RF Testing

The following provides summarized steps for device
programming and testing. For complete details, refer
to the control panel installation manual.

Installation Guidelines

For easier installation, programming and RF testing
should be done to check for good communication between
the control panel and all system devices before mounting
system devices. Install the siren and other system devices
in the following order:

Programming/RF Testing—program siren and

>

all other devices into the control panel and test
RF communication from each intended device
location to the control panel.

Mounting—mount siren at the tested location.

>

1

Remove four cover
screws, separate cover
from siren and install
batteries.

2

Put control panel
into programming/
conguration mode.

3

Using a programmed
alphanumeric keypad,
proceed through menus
until the display shows
ADD A NEW DEVICE.

4

Press Yes. The display
shows PRESS PROGRAM
BUTTON OF DEVICE.

5

Press and release
program button on siren
using a paper clip end.
The siren LED ashes.
Wait for keypad display
to show SIREN (1 - 24)
RECORDED.

6

Press Yes. The display shows RADIO RANGE TEST?
Press
keypad display shows TEST IN PROGRESS.

7

make sure LED ashes continuously, indicating good
communication with control panel.

8

Screws

Program Button

9

Repeat steps 4 - 8 for remaining sirens.

10

Yes again. The siren LED starts ashing and

Take siren to its intended mounting location and

Press Yes to end radio range test, then press Esc/No.

The display shows ADD A NEW DEVICES?

When nished, exit from conguration mode.

www.videofied.com

Mounting

I N S T A L L A T I O N I N S T R U C T I O N SExterior Siren/Strobe Model SE650/SE550/SE750

Use proper tools and hardware for mounting the unit.

>

Mount outdoors under eves to help prevent direct contact

>

from elements.

Mount on front of structure where strobe light is clearly

>

visible to responding authorities.

Regulatory Information

FCC Part 15

This device complies with FCC Rules Part 15.
Operation is subject to the following two conditions:

1.) This device may not cause harmful interference and,

2.) this device must accept any interference that may be
received, including interference that may cause undesired
operation.

Changes or modications not expressly approved by RSI VIDEO
TECHNOLOGIES, Inc. can void the user’s authority to operate the
equipment.

1

Remove batteries.

2

Hold unit up against
mounting surface and
mark the three
mounting holes.

3

Drill pilot holes
and install anchors
where needed.

4

Place unit on mouning surface so mounting holes
line up with pilot holes/anchors and secure unit with

Mounting Holes

appropriate screws.

5

Install batteries, observing correct polarity.

6

Place the ash wire of the cover to the siren.

7

Attach front cover.

Specif ications

Panel Compatibility VIDEOFIED V6000/VISIO1000/V7000

Operating Frequency 915/868/920 MHz

Radio type Spread Spectrum Bidirectional RF

Power Requirements Four 1.5 V Alkaline batteries

Battery Type D size alkaline

Power Output 105 dB @ 1 meter

Operating Temperature -13° - 158° F (-25° - +70° C)

Maximum Relative Humidity 70%, non-condensing

Dimensions (LxWxD): 9 in. x 6-1/2 in. x 3 in.

(227 mm x 166 mm x 80 mm)

Weight 31 oz./880 g (without batteries)

Approvals UL / FCC (SE650)

CE / EN50131 / EN300220 / INCERT/ IDA / NCP (SE550)

A-Tick (SE750)

EMEA SALES

2, rue Al exis de Tocque ville
92160 ANTONY
FRANCE
Phone [phone]

Fax [phone]

© 2007 RSI VIDEO T ECHNOLOGIES™ V ideoed® is a Register ed Trademark of RSI VI DEO TECHNOLOGI ES™.

S2View® is a registere d trademark of R SI VIDEO TECHNOLO GIES™. Speci cations subjec t to change witho ut notice.

www.vi deo fie d.com

USA SALES

4455 Whi te Bear Park way, Suite 700
White B ear Lake, MN 55110
USA
Phone [phone]

Fax [phone]