Page 1
I. GENERAL INFORMATION
Congratulations on having chosen a Victorinox Swiss Army timepiece. To ensure
your timepiece operates perfectly, we recommend that you follow the advice given
in these instructions.
Your timepiece is fitted with either a screw-down or a “pull-out” crown. In order to
establish which, gently try to pull the crown out to position 2, if that works, your
timepiece is fitted with a “pull-out” crown. If not, use your thumb and forefinger to
apply mild pressure on the crown, while rotating towards you to release it. If it does
so, you have a screw-down crown.
After use, push the crown back in or screw it down until it is secure in
order to maintain the water resistance of your timepiece.
Quartz timepieces are battery-operated. When the battery is exhausted, we recommend that you have it replaced immediately at an authorized Victorinox Swiss Army
Service Center where the water resistance of your timepiece will also be checked.
The battery is not covered by the warranty.
COLLECTION AND DISPOSAL OF QUARTZ TIMEPIECE BATTERIES*
This symbol indicates that this product must not be thrown away
with household rubbish. It must be disposed of at an authorized battery disposal point. By doing so you will be protecting the environment and human health. Recycling conserves natural resources.
*Applicable in EU member countries and countries with similar legislation.
3
English
VICTORINOX SWISS ARMY INSTRUCTIONS FOR USE
I. GENERAL INFORMATION
– Disposal of used batteries 3
– Water resistance 4
– Meter/bar correlation 5
II. INSTRUCTIONS FOR USE
– Use of the chronograph 5
Single event 6
Split/Intermediate time 6
– Setting the time 7
– Setting the time zone 7
– Setting the date 7-8
– Adjusting the chronograph functions 8
– Tachymeter Timer 9
2
English
Page 2
METER/BAR CORRELATION
Meter and bar measurements are different things: under water,the water pres-
sure is added to the air pressure above; a depth of 10 meters corresponds to 1 bar
of water pressure and 1 bar of atmospheric pressure above water level, therefore
2 bars in total.
II. INSTRUCTIONS FOR USE
Pushers:
A Chronograph start/stop
B Split timing, zero reset
Timepiece Indication:
C Hours
D Minutes
E Seconds
F Date
Chronograph Indication:
G 12-hour counter
H 1/10th of a second
I 60-second counter
J 60-minute counter
5
English
WATER RESISTANCE
Please check the details on the back of your Victorinox Swiss Army timepiece case
and read the following information carefully:
Water-resistant to 3 atm (100 feet/30 meters). Resistant to rain and splashes and accidental immersion, but must not be worn in the shower or when
swimming.
Water-resistant to 5 atm (165 feet/50 meters). May be worn in the shower or
when swimming in shallow water. Do not wear when diving.
Water-resistant to 10 atm (330 feet/100 meters). May be worn when swimming or snorkelling.
Water-resistant to 30 atm (990 feet/300 meters). May be worn when swimming or free diving and scuba diving.
Water-resistant to 50 atm (1650 feet/500 meters). May be worn when swimming or deep-sea diving.
The water resistance of your timepiece cannot be guaranteed indefinitely, considering that joints may age, crowns or pushers may sustain knocks and climate or
temperature may vary.We therefore recommend that you have the water resistance
of your timepiece checked at an authorized Victorinox Swiss Army Service Center
every 18 months or whenever the timepiece case is opened.
Never operate the crown and/or pushers when the timepiece is under water
and ensure that the crown and pushers are properly pushed back or screwed
down after each use.
4
English
A
B
C
D
I
J
F
G
H
E
12 3
Page 3
SETTING THE TIME
1. Pull the crown out to position 3. The seconds hand will stop.
If your timepiece indicates the date, remember the date advances at 12:00 midnight, not 12:00 noon.
2. Turn the crown to position hands to the desired time.
3. Push the crown back to position 1.
(Remember to screw it back down if you have a screw-down model).
SETTING THE TIME ZONE
1. Pull the crown out to position 2.
2. Turn the crown back or forth to reach a new time zone.
3. Push the crown back to position 1.
(Remember to screw it back down if you have a screw-down model).
SETTING THE DATE
1. Pull the crown out to position 2.
2. Turn the crown and the hour hand back or forth until the desired date is reached.
3. Push the crown back to position 1.
To avoid any errors, do not perform this operation between 21.00 and 03.00
7
English
The crown has 3 positions:
1 Screwed-in position
2 Time zone adjustment back and forth, date setting
3 Hour and minute setting
Do not operate the pushers or crown when your timepiece is under water
or if it is wet.
USE OF THE CHRONOGRAPH
Single event:
1. Press pusher A to start the chronograph.
2. Press pusher A again to stop the chronograph.
3. Press pusher B to reset to zero.
Split/Intermediate time
1. Press pusher A to start the chronograph.
2. Press pusher B to display an intermediary time, the chronograph will continue
timing.
3. Press pusher B again to catch up with the timing.
4. Press pusher A to end the timing.
5. Press pusher B to reset to zero.
6
English
A
B
12 3
Page 4
TACHYMETER TIMER
The tachymeter timer allows you to measure the speed of an object moving at constant speed. Start the chronograph and stop it after a certain distance covered
(1 km for example). The chronograph hand indicates a figure on the tachymeter
scale corresponding to the speed in km/h or miles/h – mph.
9
English
in the morning when the date mechanism is in action. Be careful not to confuse
midday and midnight.
ADJUSTING THE CHRONOGRAPH FUNCTIONS
12-hour counter:
1. Pull out the crown to position 2.
2. Press pusher A to adjust 12-hour hand to zero.
60-minute counter:
1. Pull out the crown to position 2.
2. Press pusher B to adjust 60-minute hand to zero.
Second counter:
1. Pull out the crown to position 3.
2. Press pusher A to adjust the second hand to zero.
1/10th of a second:
1. Pull out the crown to position 3.
2. Press pusher B to adjust 1/10th of a second to zero.
8
English
Loading...