Page 1
ALTIMETER
TM
14378 REV2010
The Altimeter comes equipped with a 3 volt lithium battery (Panasonic
CR 1225, 3V). To change the battery, use the mini-screwdriver to open the
battery compartment and replace the battery (see illustration below).
ALTIMETER BATTERY CHANGE
The altitude is displayed with a delay in order to substantially
extend battery life. For this reason, a Victorinox Altimet er
may not be used to measure altitudes during parachuting
or similar types of speed/air pressure sports.
IMPORTANT
Extend each implement halfway, then
apply a few drops of oil at the base of that
implement. For blades that do not move
easily, open and close a few times in
warm water, then dry and oil. This care
will ensure a lifetime of faithful service.
MAINTENANCE
For more information about our complete line of products, please visit
us on-line at www.swissarmy.com.
© Victorinox Swiss Army, Inc. 2010. All Rights Reserved.
OUR PRODUCTS
Victorinox produces and sells unique, high qual ity product s
worldwide which are of practical use in differing areas of life:
Swiss Army Knives, Cutlery, Timepieces, Travel Gear, Fashion and
Fragrances.
The head office of the company is in Ibach, Schwyz, in the heart
of Switzerland, where founder Karl Elsener first set up his cutler’s
business in 1884 and, a few years later, designed the legendary
“Original Swiss Army Knife”.
OUR LEGACY
Victorinox Swiss Army, Inc., warrants this Victorinox product to be free
from defects in material and workmanship for the entire life of the
Swiss Army Knife. Electronic parts are covered by a two-year warranty.
If your Swiss Army Knife has a manufacturer’s defect covered by our
warranty, we will either repair or replace it, at our option, without
charge when it is returned to a Victorinox Authorized Dealer or sent to:
Service Center:
Victorinox Swiss Army, Inc. • 7 Victoria Drive • Monroe CT 06468-1212
Please include your name, address and phone number with your return.
WARRANTY
A damaged Swiss Army Knife not covered by the warranty can be
repaired for a nominal fee. Please return the damaged Swiss Army
Knife with a letter explaining the requested repair, to the above
address. You will then receive a letter confirming the cost of that repair
before the repair is done. Mail form with check, money order or credit
card information or call our customer service number to give approval
with credit card number.
REPAIRS
Only when you see
the name Victorinox
®
stamped on the blade
can you be assured
you have the Original
Swiss ArmyTM Knife.
Replacement Parts
Call customer service or visit us at swissarmy.
com to find an Authorized
Dealer near you.
Customer Information • 1-800-442-2706
CUSTOMER SERVICE
Victorinox guarantees all Swiss Army Knives to be of first class
stainless steel, and provides a lifetime guarantee against any
defects in material and workmanship.
VICTORINOX GUARANTEE
Page 2
Adjusting the altitude
In altitude mode, press and hold the Shield for 4 seconds until the
up and down arrows appear. Release the Shield. The up and down
arrows will flash alternately. To increase the elevation displayed,
press the Shield repeatedly while the arrow is up. To decrease the
elevation, press the Shield repeatedly while the arrow is down.
Once the display shows the correct elevation, wait 4 seconds until the
display stops flashing. The display will switch itself off automatically
after 15 minutes if not in use.
o
C
o
C
o
C
o
F ft
o
C
o
C
o
C
o
F ft
o
C ft
o
F ft
o
C
o
C
o
C
o
F ft
o
C ft
o
F ft
o
F m
o
C ft
o
C
o
C
o
C
o
F ft
o
C ft
o
F ft
o
F m
o
C ft
o
C m
o
F m
o
C
o
C
o
C
o
F ft
o
C ft
o
F ft
o
F m
o
C ft
o
C m
o
F m
o
C
o
C m
Calibration
Altimeters calculate altitude on the basis of air pressure. For this
reason, any altimeter has to be recalibrated prior to use owing to
daily fluctuations in air pressure. The altimeter has to be reset at
a known altitude (e.g. at home, at a railway station, mountain cottage,
etc.) to this altitude.
Turning on Digital Display
Press and hold the Cross and Shield for 4 seconds until information
appears on the display. Either the temperature or the altitude will
appear depending on how long the display was last set. To toggle
between Altitude and Temperature modes, press the Cross and Shield.
Setting Combinations
1 Large Blade
2 Small Blade
3 Corkscrew
4 Can Opener with
5 – Small Screwdriver
6 Bottle Opener with
7 – Large Screwdriver
8 – Wire Stripper
9 Reamer
10 Key Ring
11 Tweezers
12 Toothpick
13 Scissors
14 Multi-Purpose Hook
(Parcel Carrier)
15 Digital Altimeter
16 Digital Thermometer
17 Pressurized Ball Point Pen
18 Straight Pin
19 Patented Mini-Screwdriver
(20 Wood Saw – Altimeter Plus only)
ALTIMETER
™
Operating ranges Altitude: -100 to +6000m (-300 to +18000 ft)
Temperature: -20º to +60ºC (0º to +140º F)
For shipping purposes the battery was put in upside down.
Remove battery and install correctly.
FEATURES
o
C
o
C
o
C
o
F ft
o
C ft
o
F ft
o
F m
o
C ft
o
C
o
C
o
C
o
F ft
o
C ft
o
F ft
o
F m
o
C ft
o
C m
o
F m
o
C
o
C m
Press 4 seconds
Press 3 seconds
Press 6 seconds to increase
Press 1 second
Press 1 second
Press 6 seconds
Press 1 second to decrease
After 10 seconds
the altitude is set
Press 4 seconds
Press 1 second
Press 1 second
Press 1 second
Press 1 second
After 10 seconds
Celsius + Meters
Farenheit + Feet
Celsius + Feet
Farenheit + Meters
Celsius + Meters
chosen setting will remain
15,16
4
5
31991410
18121117
6 8
7
13
1
Loading...