VICTORIA VTA-754B User Manual

STEP

STEP

Insert the protective rubber (22) into the Victoria mill body (2) with the serrated surface facing
down, then place the body (2) on the edge of a stable and firm surface; secure the Victoria mill
body (2) by tightening the clamp screw (3) until it is fixed and firm.

STEP

Fully insert the feed screw (12) into the mill body(2)

STEP

Make sure to have the adjusting screw (14) as open as possible. Then fasten the bearing support
(8) with the grinding disk cover (15) to the mill body (2), adjusting the wing nuts (9) to the brackets
on each side and tightening until direct contact is ensured.

STEP

Place the crank handle (4) on the protrusion of the feed screw (12) and fix it with its
respective screw (5)

STEP

Place and tighten the grinding disk cover(15) to the bearing support(8),
matching the external tracks.

Place the hopper (1) on top of the mill body (2), matching its pins and turning the hopper
slightly clockwise to secure.

USAGE INSTRUCTIONS

Once the mill is installed, adjust the grinding adjusting screw(14) to obtain the desired texture - the
tighter, the finer the grind, and the more open, the coarser the grind. Finally, secure the adjusting
screw(14) by tightening the lock nut(13).

ASSEMBLY AND INSTRUCTIONS

GRAIN MILL

IMPORTANT

Loosen the adjusting screw (14) before

disassembling the Victoria grain mill.

Contact us at [e-mail]

VictoriaCookware @VictoriaCookware

assembly visit our channel

FOR USA: Questions?

For instructions on

VictoriaCookware

WATCH IT ON

YouTube