Vicoustic Wave Wood User manual

Installation Procedures

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

STEP 6

Wavewood | Ceiling

Apply Vicoustic Flexi Glue at the back of the

acoustic panel, near the edges.

Page 1 of 1 |

Required Apparatus:

- Wavewood (Panel)

- Vicoustic Flexi Glue

- 1 x Glue Gun

Installation Instructions:

Wall surfaces should be examined prior to installation, ensuring they are clean, smooth, and dry.
If you have unpainted gypsum board surfaces, these should be primed with a drywall primer (or another material manufactured
especially for the purpose), to equalize the absorption between the gypsum board face paper, joint compound, and skin coating
materials. You should then apply the paint, and allow air circulation in order to dry the paint within the time frame speci
paint manufacturer. Please ensure the paint is dry before installing the acoustic panel.
Make sure the room has all the conditions necessary to receive the acoustic panels.
After you apply the glue on the back of each acoustic panel, please ensure you hold the acoustic panel on the wall the required
time (mentioned below), and ensure it stays

Apply Vicoustic Flexi Glue in the centre

of the acoustic panel like shown on the
image above.

xed in place.

Apply the acoustic panel on the ceiling

surface.

ed by the

Leave the acoustic panel glued on the

surface for 15 seconds.

VICOUSTIC O ce Rua Quinta do Bom Retiro Nº16, Armazém 9, 2820-690 Charneca da Caparica, Portugal | Phone . [+351] 212 964 100 | Fax [+351] 212 964 101 | E-mail . [e-mail]
VICOUSTIC R&D and Logistics Facility Avenida do Polo 3, Nº159 . 4590-137 Carvalhosa, Paços de Ferreira, Portugal | Mobile . [+351] 917 851 019 | E-mail . [e-mail]

VICOUSTIC USA 5701 Sixth Avenue South, Suite 229 . Seattle, WA 98108 | phone . [206] 767-2020 | E-mail . [e-mail]

www.vicoustic.com | www.vicousticusa.com

Remove the acoustic panel slightly from the

wall surface (approximately 2 cm) during 15
seconds.

Apply again the acoustic panel on the

surface and hold for 1,5 minutes and ensure
it stays xed in place.