Apply Vicoustic Flexi Glue at the back of the
Cinema Round | Ceiling
Apply Vicoustic Flexi Glue in the centre
Apply the acoustic panel on the ceiling
Leave the acoustic panel glued on the
Remove the acoustic panel slightly from the
Apply again the acoustic panel on the
Installation Procedures
Required Apparatus:
- Cinema Round (Panel)
- Vicoustic Flexi Glue
- 1 x Glue Gun
Installation Instructions:
Wall surfaces should be examined prior to installation, ensuring they are clean, smooth, and dry.
If you have unpainted gypsum board surfaces, these should be primed with a dry wall primer (or another material manufactured
especially for the purpose), to equalize the absorption between the gypsum board face paper, joint compound, and skin coating
materials. You should then apply the paint, and allow air circulation in order to dry the paint within the time frame speci
paint manufacturer. Please ensure the paint is dry before installing the acoustic panel.
Make sure the room has all the conditions necessary to receive the acoustic panels.
After you apply the glue on the back of each acoustic panel, please ensure you hold the acoustic panel on the wall the required
time (mentioned below), and ensure it stays
xed in place.
ed by the
acoustic panel, near the edges.
surface for 15 seconds.
of the acoustic panel like shown on
image above.
wall surface (approximately 2 cm) during 15
seconds.
surface.
surface and hold for 1,5 minutes and ensure
it stays xed in place.
VICOUSTIC O ce Rua Quinta do Bom Retiro Nº16, Armazém 9, 2820-690 Charneca da Caparica, Portugal | Phone . [+351] 212 964 100 | Fax [+351] 212 964 101 | E-mail . info@vicoustic.com
VICOUSTIC R&D and Logistics Facility Avenida do Polo 3, Nº159 . 4590-137 Carvalhosa, Paços de Ferreira, Portugal | Mobile . [+351] 917 851 019 | E-mail . info@vicoustic.com
VICOUSTIC USA 5701 Sixth Avenue South, Suite 229 . Seattle, WA 98108 | phone . [206] 767-2020 | E-mail . info@vicousticusa.com
www.vicoustic.com | www.vicousticusa.com