Vibration C223 User Manual
Stereo 2-Way/Mono 3-Way Crossover
C223
User s m anual
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
ATTENTION:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
WARNING:
The symbols shown above are internationally accepted symbols that warn of potential hazards
with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that
there are dangerous voltages present within the unit. The exclamation point in an equilateral
These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit.
Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. Opening the
chassis for any reason will void the manufacturer's warranty. Do not get the unit wet. If liquid is
spilled on the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit
triangle indicates that it is necessary for the user to refer to the owner's manual.
during storms to prevent damage.
WARNING
FOR YOUR PROTECTION. PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Appliance should not be used near water(e.g. near a bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do
POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating
GROUNDING OR POLARIZATION: Precautions should be taken so that
POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them, paying particular attention to cords at plugs, convenience
SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to service the appliance beyond that
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE
not fall and liquids are not spilled
the grounding or polarization means of an appliance
receptacles, and the point
RECEPTACLE: Replace fuse with same type and rating
into the enclosure through openings.
instructions or as marked on the appliance.
is not defeated.
where they exit from the appliance.
described in the operating instruction. All other servicing should be referred to qualified service personnel.
only.
B:20010918
2-WAY, 3-WAY CROSSOVERS
FRONT PANEL
Stereo 2-way mode
In 2-way stereo mode the controls are marked BELOW the horizontal red line.
Channel one and channel two functions are identical in the stereo mode. LEDs are disabled for controls
which are non-functional in this mode.
INPUT GAIN
LOW CUT
LOW/HIGH
X10 LED
LOW OUTPUT
PHASE INVERT
HIGH OUTPUT
PHASE INVERT
STEREO
Controls the INPUT level with +/- 12dB of gain.
Switch for selecting the 40Hz high pass filter. An LED indicates the selection.
Selects crossover point between the LOW and HIGH outputs.
Indicates that the LOW/HIGH crossover frequency range is 450Hz to 9.6KHz.
Controls the Low Frequency output level with a range of to +6dB.
Switch for reversing the polarity on the low output. An LED indicates the selection.
Controls the High Frequency output with a range of to +6dB.
Switch for reversing the polarity on the High Output. An LED indicates the selection.
LED indicating stereo mode operation.
[1]&[5]
[9]&[15]
[2]&[6]
[10]&[16]
[3]&[7]
[11]&[17]
[4]&[8]
[12]&[18]
[14]
9 10
11 121314
15 16
17
18
CHANNEL ONECHANNEL ONE CHANNEL TWOCHANNEL TWO
INPUT LOW CUT LOW/MID
LOW/HIGH
LOW OUTPUT
HIGH OUTPUT
MONO
STEREO
INPUT LOW CUT LOW OUTPUT
0
+6-6
+12-12
dB
GAIN
dB
GAIN
-10
-30
0
240
140
70
350
680
45 960
Hz
XOVER FREQ
0
dB
GAIN
-10
-30
+6
Stereo 2-Way/Mono
3-Way Crossover
C223
INV
40Hz x10
INV
MID/HIGH
LOW/HIGH
MID OUTPUT
HIGH OUTPUTINPUT LOW CUT LOW OUTPUT
0
+6-6
+12-12
dB
GAIN
dB
GAIN
-10
-30
0
+6
240
140
70
350
680
45 960
Hz
XOVER FREQ
0
dB
GAIN
-10
-30
+6
INV
40Hz x10
INV
HIGH OUTPUT
Loading...