VibraHone CB-30 Operating Instructions Manual
CB-30
Operating Instructions
Planetary Barrel Centrifugal Polisher
Model CB-30
Vibra Finish Company
WWW.VIBRAFINISH.COM
Contents
Machine Safety Requirements
Machine Specifications
Machine Components
Installation
Operation
Maintenance & Service
2
3
4
6
7
8
Vibra Finish Company
WWW.VIBRAFINISH.COM
1
Machine Safety Requirements
y
IMPORTANT: READ BEFORE OPERATING UNIT
1. SHIPPING BOLTS AND SPACERS MUST BE REMOVED BEFORE WIRING the Variable AC
Motor Drive or operating the machine. Damage will occur to unit and motor if operated without removing the shipping bolts and spacers.
2. Shut off and lock out power before removing any machine guards or doors.
3. All doors and guards must be kept in place at all times during operation of the
machine to avoid exposure to parts rotating at high speeds. Severe injury can occur
if hands or feet reach inside unit while power is on.
4. To avoid electric shock, attach ground lead, labeled “0” in power cord to ground.
NEVER REMOVE grounding strap to bowl unit.
5. Securely tighten all bolts/nuts on vibrating unit according to instructions in this manual.
Special attention must be paid to motor mounting bolts. If a motor vibrates loose,
damage to power cord and structure may result as well as risk of personal injury.
6. When maintaining or adjusting eccentric weights, extreme caution must be used to
correctly attach all keys, retainers and fasteners. Failure to lock weights securely in
place can result in parts being thrown from machine at high speed, endangering
personnel.
7. Higher amplitudes occur during machine start up and shut down. Caution should be
taken to provide adequate clearance from accessory equipment to avoid contact
during these cycles.
Vibra Finish Compan
WWW.VIBRAFINISH.COM
2
Loading...