VGS Hammer Bridge Owner`s Manual

VG570.209 - VGS - HAMMER BRIDGE

Specifications

- Battery: 9V Alkaline 6LR6l or 6F22

- DC power supply: 9V stabilized

- Power consumption: 10mA

- Frequency response : 10Hz to 20kHz

- Input impedance : 1mOhm

- Output impedance : 1kOhm

- Dimension: 75.5 x 115.5 x 47.5 (mm)

- Weight: 260g (including battery)

Battery & Power

Output Level
control

SE-BOD

Blues Overdrive

HAMMER BRIDGE

Solo Distortion

Distortion gain

Tone control
low - high

Indicator

When using a battery and the indicator starts blinking or no longer lights up
while the effect is on it means that the battery is nearly dead and must be
replaced. It can also mean that the voltage of power supply is too low or
disconnected when used in a combined power supply system.

When using the pedal with batteries, please use ALKALINE batteries to

prevent leaking damage.

When using the pedal with an AC adaptor or DC power supply system,
please use a DC9V (100 mA or higher) stabilized switching power supply.
Using a non-stabilized switching power supply may cause hum or high
frequency noise.

Limited Warranty

The products manufactured by VGS will be under warranty for defects in

workmanship and material for a period of two years from purchasing date.

For warranty, please contact the authorized dealer or shop in your region.

Contour:
classic tube ­modern metal

Output jack

DC jack

Input jack

Foot switch
Effect - Bypass
(Direct Bypass)

Producer & Service:

GEWA music GmbH
Oelsnitzer Straße 58
D-08626 Adorf

[e-mail]
www.gewamusic.com