Vexilar Ice-Ducer®Instructions
The Ice-Ducer system provides a quick and easy way to set up
the transducer for ice fishing. All of the adjustment needed to
find the true perpendicular point is done automatically. To use
the Ice-Ducer, simply adjust the transducer to the desired depth
and drop the assembly into the ice hole.
There are three main components to this Ice-Ducer system. They include the
Transducer, the Float, and the Stop. The size and shape of your Transducer may
vary, depending on the beam angle you have purchased.
1. Install the Stop by passing the Transducer cord
through the slit in the side of the Stop.
2. Install the Float between the Stop and the
Transducer in the same way. Make sure the
tapered hole is facing up towards the Stop.
Pushing the Stop into this hole helps it grip the
cable.
3. Adjust the Stop to allow the Transducer to float at
the desired depth. Keep at least 2” between the
Transducer and Float in order to make sure that
the it will hang straight. Try not to hang it below
the bottom of the ice, as this can cause tangling
problems when bringing in a fish. Many Vexilar
ice fishing packs also come with a support arm or
eye that you can use in place of the Float.
IMPORTANT - Before using the Ice-Ducer each time,
wet the face of it by rubbing the bottom of the
Transducer with water. This will eliminate any
residue, ice or air film and insure good acoustical
contact between the Transducer and the water.
CAUTION - Your transducer’s cord is very soft so
that it will allow the transducer to hang straight in
even the coldest temperatures. This makes damage
from objects with sharp edges possible. Please keep
the cord away from sharp objects. Also, if fishing line
gets wrapped around it, use caution when
unwrapping or the line can cut the cord insulation.
Stop
Float
Transducer
Vexilar, Inc. Minneapolis, MN 55438 | 952-884-5291 - www.vexilar.com
Loading...