Rev. 12/9/2019 CYL-M, MANUAL
Vestil Manufacturing Corp.
2999 North Wayne Street, P.O. Box 507, Angola, IN 46703
Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868
Fax: (260) 665-1339
Web: www.vestilmfg.com e-mail: info@vestil.com
CYL-M INSTRUCTION MANUAL
Receiving instructions:
After delivery, remove the packaging from the product. Inspect the product closely to determine
whether it sustained damage during transport. If damage is discovered, record a complete description of
it on the bill of lading. If the product is undamaged, discard the packaging.
NOTE:
The end-user is solely responsible for confirming that product design, use, and maintenance comply
with laws, regulations, codes, and mandatory standards applied where the product is used.
Replacement Parts and Technical Assistance:
To order replacement parts, labels, and accessories, contact the technical service and parts
department online at http://www.vestilmfg.com/parts_info.htm. Alternatively, you may request
replacement parts and/or service by calling (260) 665-7586 and asking for the Parts Department.
Table of Contents
Signal Words……………………………………………….………………………………………………………. 2
Hazards of Improper Use……………………………………………………..………………………….……….. 2
Exploded View and Bill of Materials………..……………………………………………………………............3
Labeling Diagram.………….. ………………………………………..……………............................................4
Limited Warranty…………………………………………….…………………………………………………… 5
Copyright 2019 Vestil Manufacturing Corp. Page 1 of 5
Rev. 12/9/2019 CYL-M, MANUAL
Signal Words:
This manual uses SIGNAL WORDS to direct the reader’s attention to important safety-related
messages. These messages describe uses of the product that could result in personal injury or property
damage. Each signal word corresponds to a specific hazard level. The following are definitions of signal
words that might appear in this manual.
Identifies a hazardous situation which, if not avoided, WILL result in
DEATH or SERIOUS INJURY. Use of this signal word is limited to the most
extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in
DEATH or SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in
MINOR or MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
Safety Instructions:
Vestil strives to identify all foreseeable hazards associated with the use of its products. However,
material handling is dangerous and no manual can address every conceivable risk. Ultimately, the most
effective way to prevent injury is to apply sound judgment whenever using this device.
Improper or careless use of this product could result in serious personal injuries.
•
Read and understand the entire manual before assembling, installing, using or servicing the
product.
•
Read the manual to refresh your understanding of proper use and maintenance procedures.
•
DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so and
certain that it will be safe to use afterwards.
•
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil.
Unauthorized modifications automatically void the Limited Warranty and might make the product unsafe to
use.
•
DO NOT exceed the maximum rated load. See Label 287 in Labeling Diagram on p. 4.
•
DO NOT attempt to lift a cylinder with this carrier unless you can easily handle the weight. The carrier can
be used by 2 people, i.e. each person grasps 1 of the handles. If a cylinder is too heavy for you to
comfortably lift and control, then enlist someone to help you.
•
DO NOT put your feet, or any part of your body, underneath the cylinder while carrying it.
•
Instruct all other persons to keep clear of the cylinder and to stay out of your path of travel.
•
DO NOT use the carrier unless both cylinder grips (item 4 on p. 3) are in place and undamaged. The grips
prevent cylinders from sliding through the carrier when elevated.
•
Inspect the product before each use.
A. DO NOT use this product if the inspection reveals structural damage. Examples of structural damage
include, but are not limited to, the following: 1) Cracked, broken or significantly deformed load-bearing
members; 2) cracked welds; 3) missing or deformed safety chain/strap; 3) corrosion, severe wear, or
other condition that affects the ability of the product to support weight or itself. Replace each part that
fails to pass an inspection, and DO NOT use the product until it is fully restored to normal condition.
B. DO NOT use the product if any unusual noise or movement is observed. If a malfunction occurs,
remove the unit from service and notify your supervisor & maintenance personnel about the issue.
•
DO NOT use this device UNLESS all product labels are readable and undamaged. See Labeling Diagram
on p. 4
Proper use, maintenance, and storage are essential for this product to function properly.
o Always use this product in accordance with the instructions in this manual and consistent with any training
relevant to machines, devices, etc. used in conjunction with this product.
o Keep the product clean & dry. Lubricate moving parts.
Copyright 2019 Vestil Manufacturing Corp. Page 2 of 5