Vestil CB-W-3S User Manual

Vestil Manufacturing Corporation

2999 North Wayne St., Angola, IN 46703

Ph: 260-665-7586 • Fax: [phone]

E-mail: [e-mail]

Website: www.vestil.com

Ergonomic Solutions

Contents

Revised 08-04

A company dedicated to solving ergonomic
and material handling problems since 1955.

OWNER'S
MANUAL

GAS CYLINDER STEEL BUMPER

Receiving Instructions .......................................... 1

Warranty ............................................................... 1

RECEIVING INSTRUCTIONS

Every unit is thoroughly tested and inspected prior to shipment.
However, it is possible that the unit may incur damage during
transit. If damage is noticed when unloading, make a note of it
on the BILL OF LADING. Remove all packing and strapping
material, then inspect the unit again for damage. IF DAMAGE IS

EVIDENT, FILE A CLAIM WITH THE FREIGHT CARRIER
IMMEDIATELY!

WARRANTY

This product is warranted for 90 DAYS from date of purchase to
be free of manufacturing defects in material and workmanship.

This warranty does not cover normal wear of parts or damage
resulting from any of the following: negligent use or misuse of
the product, use or application contrary to installation
instructions, or disassembly, repair or alteration by any person

prior to authorization from a factory representative.

INCLUDED

(1) Steel Bumper
(1) Heavy Duty Nylon Strap Assembly

Mounting Recommendations.................................1

Mounting Instructions ............................................1

MOUNTING INSTRUCTIONS:

1) For best stability results, mount
your steel bumper approximately
2/3 up from the floor using the
average height of your most
commonly used gas cylinder.

2) Push each bolt through their
respective holes on the steel
bumper bracket. Then
proceed to anchor to the wall.

AVERAGE

HEIGHT

2/3 HEIGHT

OF AVERAGE

CYLINDER

**NOTE**
Hardware used to mount your bumper bracket to the wall is not
included. Your mounting surface will determine the hardware
used for installation.

MOUNTING RECOMMENDATIONS

• CONCRETE WALL: (2) 3/8" diameter x 3-1/2" long lag screws
with masonry expansion shieds

• WOOD WALL: (2) 3/8" diameter x 3-1/2" long wood screws

• CINDER BLOCK WALL: (2) 3/8" diameter x 3-1/2" long lag
screws with masonry expansion shieds.

• DRY WALL: (2) 3/8" diameter x 4-1/2" long t-style hollow wall
anchors.

advisable due to lack of surface strength unless anchored to a stud.

Drywall material recommendation is listed above, but it is not