Vestil ALL-TTB User Manual

INSTRUCTION MANUAL

ALL TERRAIN PALLET TRUCK

HAND PALLET TRUCK

WARNING

1. Read and understand instruction manual before using the pallet truck.

2. Do not place hands or feet under the pallet truck at any time.

3. Do not operate loaded pallet truck on ramps or inclines.

4. Do not tip loaded pallet truck for

personal injury if the rear of

5. Never leave a loaded pallet truck unattended in the raised position.

6. Do not load pallet truck beyond its rated capacity.

7. Secure load before transporting.

8. To prevent accidental tipping, make sure load is centered on the forks.

9. Do not move a loaded pallet truck by other than manual force.

10.

ailure to comply with these warnings may result in personal injury and/or

F

property damage.

NOTE: Materials, design, and specifications are subject to change without

notice.

!

ks. This may cause damage to the forks and

the pallet truck suddenly “pops up”.

troduction

In

Thank you for purchasing an ALL-T-2 manual pallet truck. This pallet truck was designed to traverse rough

terrain where no ordinary pallet truck c
construction sites, and marinas. The truck features a high quality hydraulic pump with welded construction
and chrome plated piston and pump plunger ensure durability and corrosion resistance. All the joints are
fitted with seals to ensure sealing and keep the body from oil leaking. Safety by-pass valve helps protect
against overload. 3-position control handle allows operator to lower, raise and engage pump into neutral
position with a simple tough of the lever. Strong & light tubular steel framing and adjustable fork width.
Large pneumatic tires make handling pallets of most sizes possible without the need for a forklift.

an go and is adapted for use in settings such as garden nurseries,

Specifications

2

Safety Instructions

1. Keep feet out from underneath load.

2. Make sure load will not fall or tip before moving.
Do not operate loaded pallet truck on ramps or inclines.

3.

4. Keep the load centered on the pallet.

5. Do not load pallet truck bey

ond rated capacity.

6. Always wear appropriate safety shoes.

Operating Pallet Truck

Pallet Truck Operation

To raise the forks, place handle in the UP
position (bottom part of the handle slot), see
Fig. 1.
To lower forks, pull lever handle to DOWN
position (upper part of the slot).
To freely move the handle, set the lever in
Neutral (center notch of slot).

To Lift a Load

1. Lower forks to lowest position, Figure 1.

2. Insert forks under load, or into pallet.

3. Place lever in UP position (bottom part
of slot), Figure 1.

4. Move handle up, and down until forks

reach desired height.

To Move a Load

1. Place lever in NEUTRAL position (center
notch of slot), Figure 1.

2. Pull or push pallet truck to desired

location.

To Lower a Load

1. Pull lever to the DOWN position (upper part of slot), Figure 1.

2. Pull forks away from load.

Fig. 1

Fig. 2

Up-Down Cam Adjustment

1. Set the lever in the NEUTRAL position, Figure 1.

2. Turn the cam nut while pumping the handle, Figure 2.

3. When lifting stops, give the nut one more turn.

4. The cam nut is properly adjusted when pumping the handle in the NEUTRAL position
causes no movement of the hydraulic ram.

Cleaning the Release Valve (Bleed the Pump)
Over time, the hydraulic pump assembly may become clogged with debris, air bubbles, and
not function properly.
To clean the release valve and bleed the pump:

1. Pump handle quickly, raising pallet truck to full extent. While continuing pumping
action, pull lever to down position.

2. When forks reach total down position, valve is flushed. Repeat if necessary.

3