Verve 501625 Operating Instructions Manual

Operating Instructions

Model #: 501625 Curved Front Electric Fireplaces

Important: Read all instructions and warnings carefully. Failure to follow these instructions
may result in a possible electric shock, fire hazard and will void the warranty.

GENERAL PRECAUTIONS

When using electrical appliances, basic precautions should always be followed to reduce the
risk of fire, electrical shock, and injury to persons, including the following:

1. Read all instructions before using this heater.

2. Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.

3. Always unplug heater when not in use.

4. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment, or
repair.

5. Do not use outdoors.

6. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into a bath but or other water
container.

7. Do not run power cord under carpeting. Do not cover power cord with throw rugs,
runners, or the like. Arrange power cord away from traffic area and where it will not
be tripped over.

8. To disconnect heater. turn controls to off , then remove plug from outlet .

9. Connect to properly grounded outlets only.

10. Do not insert or allow foreign objects to enter any ventilation or exhaust openings as
this may cause an electric shock or fire, or damage the heater.

11. To prevent a possible fire, do not block firebox air intakes or exhaust in any manner.
Do not operate firebox on soft surfaces, like a bed, where openings may become
blocked.

12. A heater has hot and arching or sparking parts inside. Do not use in areas where
gasoline, paint, or flammable liquids are used or stored.

13. Use this heater only as described in this manual, Any other use not recommended by
the manufacturer may cause fire, electrical shock, or injury to persons.

14. Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire.

15. This heater may include an audible (a visual) alarm to warm that parts of the heater

are getting excessively hot, if the alarm sounds (flashes), immediately turn the heater
off and inspect for any objects on or adjacent to the heater that may cause high
temperatures. DO NOT OPERATE THE HEATER WITH THE ALARM
SOUNDING (FLASHING).

16. “SAVE THESE INSTURCTIONS”

GENERAL INSTRUCTIONS

1. Under no circumstances should this appliance be modified parts having to be
removed for servicing must be replaced with original ‘OEM’ (original equipment
manufacturers) parts only.

2. This firebox is to be cleaned with a damp cloth (water) only.

WARNING: Always unplug the power cord before cleaning the unit.

Do not use any abrasive cleaners on the unit.

3. Please unplug this firebox when not in use.

4. The fire incorporates a flame effect, which can be used with or without heater, so
that the comforting effect may be enjoyed at any time of the year, Using the flame
effect on its own only requires little electricity.
Before connecting the heater checks that the supply voltage is the same as that stated
on the heater.

5. Unpack the heater carefully and retain the packaging for possible future use, in the
even of moving or returning the fire to your supplier.
The fire incorporates a flame effect, which can be used with or without heater, so
that the comforting effect may be enjoyed at any time of the year, Using the flame
effect on its own only requires little electricity.
Before connecting the heater checks that the supply voltage is the same as that stated
on the heater.

WARNING – THIS APPLIANCE MUST BE GROUNDED.

This heater must be used on AC – supply only and the voltage

marked on the heater must correspond to the supply voltage. Before

switching on, please read the safety warnings and operating

instructions.