Page 1
Accessory Installation
AII #:L156A
Date: 2-01-99
Page 1 of 2
Instructions
MODEL NUMBER : VXR-1000
Description: Interconnection to Vertex FTL-x011 4, 12, or 24 Chan. Mobile Radio (with Control 6B Unit)
Please also refer to the VXR-1000 Service Manual and your radio’s service manual for further guidance on installations.
Section I – Wiring Interconnections
FUNCTION VXR-1000 DB-9 RADIO
Signal Ground 1 Brown (Black) J2006-8
Mobile TX Audio 2 Red (Brown) J2006-4
Power Supply Control 3 Orange (Red) J2001-6 *
Mobile PTT Output 4 Yellow J2006-1
Vcc (13.8 V) 5 Green J2001-6 *
Mobile RX Audio 6 Blue J2001-3
Mobile COR Detect 7 Purple Q2014-base
Mobile Mic. Audio 8 Gray Jct. of C2059 / C2060 (opt.)
Mobile TX Detect 9 White Q2028 collector (optional)
Notes:
Color codes in parentheses refer to the color codes in interconnection cables provided with VXR-1000s in
Lots 03 (VHF) and Lots 04 (UHF) and later.
* Both lines go to pin #6. This will allow the VXR-1000 to power on and off automatically when the radio
is powered on and off. See Section III for an alternate installation.
Section II – VXR-1000 Programming (CE-22 software)
PARAMETER SET TO
PTT1 State Low
PTT2 State High
Pre-Emphasis Off
De-Emphasis On
EXT MIC Level Low
EXT MOD Level High
Page 2
AII #:L156A
AII #:L
Date: 2-01-99
Date:
Page 2 of 2
Page 2 of
Section III – Other Modifications or Programming
Section III – Other Modifications or Programming
Connect the primary mobile microphone to the VXR-1000 for most applications.
Other programming and setup of the VXR-1000, the associated portable radio, and the connected mobile radio are required. These
If the mobile radio is to be used while the VXR-1000 is powered-off, connect pins 8 and 9 as described in
must be accomplished by a knowledgeable installer/technician consistent with the equipment’s capabilities and the end user’s
the table in Section I and connect the mobile microphone directly to the mobile radio (not to the VXR-1000).
requirements.
Alternate power on/off control for the VXR-1000 can be obtained by using the radio’s A button:
1. Connect the Orange (Red) wire to the collector of Q2015.
2. Set the VXR-1000’s internal jumper pads as follows:
a. JP1001 – CLOSED
b. JP1002 – CLOSED
c. JP1003 – OPEN
3. Program the A button as “Accessory”.
Carefully drill a hole in the radio’s chassis to allow cable entrance to the Control Unit compartment.
Other programming and setup of the VXR-1000, the associated portable radio, and the connected mobile radio are required. These
must be accomplished by a knowledgeable installer/technician consistent with the equipment’s capabilities and the end user’s
requirements.
Ref # Old Part No. New Part No. Qty New Part Description
Loading...