Versia LED-340B User Manual

15-

Innovation, Quality, Performance

LED-340B

User Manual

Please read the instructions carefully before use

1-

TABLE OF CONTENTS

1. Safety Instructions

2. Technical Specifications

3. Installation

4. How to set the fixture

5. How to control the fixture

6. DMX 512 Configuration

7. DMX 512 Connections

8. Troubleshooting

9. Fixture Cleaning

14-

EC - Declaration of Conformity

We declare that our products (lighting equipments) comply with the following

specification and bears CE mark in accordance with the provision of the

Electromagnetic Compatibility (EMC) Directive 89/336/EEC.

EN55014-2: 1997 A1: 2001, EN61000-4-2: 1995; EN61000-4-3: 2002;

EN61000-4-4: 1995; EN61000-4-5: 1995, EN61000-4-6: 1996,

EN61000-4-11: 1994.

&

Harmonized Standard

EN60598-1: 2000+ALL: 2000+A12: 2002

Safety of household and similar electrical appliances

Part 1: General requirements

13-

9. Fixture Cleaning

The cleaning of internal must be carried out periodically to optimize light output. Cleaning
frequency depends on the environment in which the fixture operates: damp, smoky or
particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s optics.

y Clean with soft cloth using normal glass cleaning fluid.
y Always dry the parts carefully.
y Clean the external optics at least every 20 days. Clean the internal optics at least every

30/60 days.

2-

1. Safety Introductions

WARNING

y Please keep this User Manual for future consultation. If you sell the fixture to another

user, be sure that they also receive this instruction booklet.

y Unpack and check carefully there is no transportation damage before using the fixture.
y It’s important to ground the yellow/green conductor to earth in order to avoid electric

shock.

y Disconnect main po wer before servicing and maintenance.
y Maximum ambient temperature is Ta : 40℃. Don’t operate it where the temperature is

higher than this.

y In the event of serious operating problem, stop using the fixture immediatel y. Never try

to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.

y Do not connect the device to an y dimmer pack.
y Do not touch any wire during operation and there might be a hazard of electric shock.
y To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain

or moisture.

y The housing must be repl aced if they are visibly damaged.
y Do not look directly at the LED light beam while the fixture is on.
y There are no user serviceable parts inside the fixture. Do not open the housing or

attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact your nearest dealer.

y Due to the magnifying type lens, please keep the lens out of contact with direct sunlight.

Direct sunlight can cause heat to build up inside of the unit, which will seriously damage
unit.

Please read the instructions carefully which includes important

information about the installation, operation and maintenance.

For power supply, do not connect in series much more than 31 units, use
another mains supply for next 31 units.