Versaclean VersaCarpet VC700 Owner's Manual

WARNING

Owner’s Manual

VersaCarpet™ VC700 Carpet and Upholstery Cleaner

LEGEND BRANDS, INC.

15180 Josh Wilson Road

800-932-3030 ■ http://VersaCleanSystems.com

Patents: http://www.LBpatents.com

READ AND SAVE THESE INSTRUCTIONS

Read and understand manual before operating.

WARNING! Do not alter or modify your VersaCarpet

in any way. Use only replacement parts authorized
by Legend Brands. Modifications or use of unap­proved parts could create a hazard and will void
your warranty. Contact your local authorized distrib­utor for assistance.

WARNING! Electric shock hazard, rotating head, hot
surface hazards. Unplug unit before opening cover
for cleaning or servicing.

WARNING! Unit must be grounded.

• Keep motor and wiring dry. Keep out of standing wa­ter and do not use in area likely to be subject to wa­ter intrusion. Do not expose to rain, water or snow.

• Insert three-prong plugs on power cords into a GFCI

outlet. Do not use adapter. Never cut off third
prongs.

FIRE HAZARD

• Keep away from open flames and heat sources.

• Do not use or store where vapors from gasoline, sol-

vents, thinners or other flammable materials may be
present.

■

Burlington, WA 98233

WARNING! Unplug unit before cleaning or servicing.

• Turn off unit and unplug before lifting.

• Handle the unit carefully. Always operate the unit on

a stable, level surface. Do not drop, throw, or place
where it could fall. Rough treatment can damage the
unit, and may create a hazardous condition or void
the warranty.

• Inspect the power cords before use. If cord is dam­aged, do not use. Always grasp the plug (not the
cord) to unplug.

• Use only with cords supplied with the unit, or 12
gauge (or larger) cords.

• The unit must be plugged into two 15 amp
115V/60 Hz circuits.

• Do not attempt to repair the unit. For Authorized
Service Centers, call VersaClean Service at 800­932-3030.

BEFORE YOU BEGIN

Warranty registration

Visit warranty.VersaCleanSystems.com to register your
purchase. Registration allows us to better assist you with
using, maintaining or servicing your equipment and to
contact you in case we have important safety i nformation
concerning your product. If you determine se rvice is re­quired, have your equipment model, serial number and
original proof of purchase available and call y our di strib­utor for assistance with obtaining a return mat eri al a u­thorization (RMA).

VISIT WWW.VERSACLEANSYSTEMS.COM FOR DETAILED INSTRUCTIONS

49-090A VC700 2013-07 1 Legend Brands, Inc.

CONTROLS AND COMPONENTS

Solution prespray
Rotary head solution

sight window.

Solution spray wand hose coil.

Prespray and/or upholstery
solution sight window

WARNING: Moving parts.
Front lift handle.

ACCESSORY PORTS





Solution

Rotary head

Separate circuit indicator

Vacuum switch

Pumpout switch

Waste water
Fresh water inlet

Hour meter

Waste tank

wand. Keep clipped in
place when not in use.

1. High pressure water outlet

2. Vacuum inlet (keep covered
when not in use.)

Keep hands and feet clear.

clear window
release clamps

outlet

control lever

light. Glows green when unit

is properly connected to two
15 amp circuits.

control lever

49-090A VC700 2013-07 2 Legend Brands, Inc.

VISIT WWW.VERSACLEANSYSTEMS.COM FOR DETAILED INSTRUCTIONS

Handle may

BEFORE FIRST USE

TOOLS REQUIRED: 3 mm hex drive bit, 10 mm wrench,

1. Install handle Using drive and wrench, remove two bolts from

posts. Insert tubes over posts and line up the holes. With tubes in posi­tion, reinsert two bolts supplied into either the uppe r or lower holes and
tighten until they are snug. For operator comfort , handle may be fixed
in one of two positions.

After handle is installed, tuck exce ss co r ds into top panel.

NOTE: Locate the Accessory/Spare Parts Kit in product packag­ing. It contains two sets of impellers and gaskets for servicing
pumpout pump. Set aside for future use.

be installed
in high or
low position.

2. Flush system lines. Unit may contain residual antifreeze

from the factory. Flush internal lines with fresh water prior to use.
DO NOT drain used antifreeze on the ground or into storm drains. Dis-

pose of antifreeze only in an approved location. Observe local, state,
and federal laws when disposing antifreeze.

THE VC700 IS NOW READY FOR CONNECTING WATER SUPPLY.

A. Flush cleaning head solution lines. Set
unit up for operation (see “Setup for Cleaning
below), except leave cleaning solution intake
tubes disconnected and direct pumpout dis­charge hose into a bucket or suitable drain. Op­erate unit for a few minutes on a hard, water­proof surface until discharge runs clear.
B. Flush accessory solution line. Set unit up
for accessory operation (see “Cleaning with Ac­cessory Tool/Upholstery Tool” below). Place
accessory tool end in a bucket of clean water
and operate the VC700 until discharge runs
clear.

49-090A VC700 2013-07 3 Legend Brands, Inc.

VISIT WWW.VERSACLEANSYSTEMS.COM FOR DETAILED INSTRUCTIONS