VersaChem 15339 User Manual

SAFETY DATA SHEET

Revision Date 07-Apr-2015

1. IDENTIFICATION

Product identifier
Product Name

Other means of identification
Product Code
Synonyms

Recommended use of the chemical and restrictions on use
Recommended Use
Uses advised against

Details of the supplier of the safety data sheet
Manufacturer Address

ITW Permatex
10 Columbus Blvd.
Hartford, CT 06106 USA

Company Phone Number
24 Hour Emergency Phone Number

VERSACHEM DIELECTRIC CONNECTOR GREASE 3 OZ.

15339
None

Lubricant
No information available

Distributor

ITW Permatex Canada
35 Brownridge Road, Unit 1
Halton Hills, ON Canada L7G 0C6
Telephone: [phone]

1-87-Permatex
[phone]
Chem-Tel: [phone]
International Emergency:
00+1+ 813-248-0585
Contract Number: MIS0003453

Version 1

E-mail address

[e-mail]

2. HAZARDS IDENTIFICATION

Classification
OSHA Regulatory Status

This chemical is not considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)

Label elements

Emergency Overview

The product contains no substances which at their given concentration, are considered to be hazardous to health

Odor MildAppearance White Physical state Grease

Hazards not otherwise classified (HNOC)

Not applicable

Other Information

_____________________________________________________________________________________________

Page 1 / 7

Revision Date 07-Apr-201515339 - VERSACHEM DIELECTRIC CONNECTOR

GREASE 3 OZ.

_____________________________________________________________________________________________

Not applicable
Unknown acute toxicity 6.52% of the mixture consists of ingredient(s) of unknown toxicity

3. COMPOSITION/INFORMATION ON INGREDIENTS

substance(s)

Chemical Name CAS No Weight-% Trade Secret

POLYDIMETHYLSILOXANE 63148-62-9 60 - 100 *

MODIFIED SILICON DIOXIDE 68611-44-9 3 - 7 *

OXIRANE, METHYL-, POLYMER 52624-57-4 1 - 5 *

*The exact percentage (concentration) of composition has been withheld as a trade secret.

4. FIRST AID MEASURES

Description of first aid measures
General advice
Eye contact

Skin contact

Inhalation

Ingestion

Self-protection of the first aider
Most important symptoms and effects, both acute and delayed
Symptoms
Indication of any immediate medical attention and special treatment needed
Note to physicians

Get medical advice/attention if you feel unwell.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if

present and easy to do. Continue rinsing. If eye irritation persists: Get medical
advice/attention.

IF ON SKIN:. Wash skin with soap and water. If skin irritation persists, call a physician.
Wash contaminated clothing before reuse.

IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for
breathing. If symptoms persist, call a physician.

IF SWALLOWED. Do NOT induce vomiting. Never give anything by mouth to an
unconscious person. Call a physician.

Use personal protective equipment as required. Avoid contact with skin, eyes or clothing.

See section 2 for more information.

Treat symptomatically.

5. FIRE-FIGHTING MEASURES

Suitable extinguishing media

Carbon dioxide (CO2), Dry chemical, Foam

Unsuitable extinguishing media

None.

Specific hazards arising from the chemical

None in particular.

Explosion data
Sensitivity to Mechanical Impact
Sensitivity to Static Discharge

None.
None.

_____________________________________________________________________________________________

Page 2 / 7

Revision Date 07-Apr-201515339 - VERSACHEM DIELECTRIC CONNECTOR

GREASE 3 OZ.

_____________________________________________________________________________________________

Protective equipment and precautions for firefighters

As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full
protective gear.

6. ACCIDENTAL RELEASE MEASURES

Personal precautions, protective equipment and emergency procedures
Personal precautions

Environmental precautions
Environmental precautions

Methods and material for containment and cleaning up
Methods for containment
Methods for cleaning up

Prevention of secondary hazards

Ensure adequate ventilation, especially in confined areas. Avoid contact with eyes and skin.
Use personal protective equipment as required.

Do not flush into surface water or sanitary sewer system. See Section 12 for additional
ecological information.

Prevent further leakage or spillage if safe to do so.
Ensure adequate ventilation. Soak up with inert absorbent material. Sweep up and shovel

into suitable containers for disposal.
Clean contaminated objects and areas thoroughly observing environmental regulations.

7. HANDLING AND STORAGE

Precautions for safe handling
Advice on safe handling

Conditions for safe storage, including any incompatibilities
Storage Conditions

Handle in accordance with good industrial hygiene and safety practice. Avoid breathing
vapors or mists. Avoid contact with skin, eyes or clothing. Wash thoroughly after handling.
Wash contaminated clothing before reuse. Use personal protective equipment as required.

Keep containers tightly closed in a dry, cool and well-ventilated place.

Incompatible materials

Strong oxidizing agents, Acids, Reducing agent

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Control parameters
Exposure Guidelines

Appropriate engineering controls
Engineering Controls

Individual protection measures, such as personal protective equipment

Eye/face protection
Skin and body protection
Respiratory protection

General Hygiene Considerations

_____________________________________________________________________________________________

.

Showers
Eyewash stations
Ventilation systems

Wear safety glasses with side shields (or goggles).
Wear protective gloves and protective clothing.
None under normal use conditions. In case of insufficient ventilation, wear suitable

respiratory equipment.
Handle in accordance with good industrial hygiene and safety practice. Regular cleaning of

equipment, work area and clothing is recommended.

Page 3 / 7