Vermont Castings VCS322SSBI Series, VCS522SSBI Series Assembly Procedures
Assembly Procedures
VCS322SSBI Series / VCS522SSBI Series
Tools Required: Knife or scissors, Phillips or Robertson (square head) screwdriver.
Model VCS522SSBI Shown
CAUTION: This grill is intended ONLY to be built into an enclosure.
CAUTION: The assembly of this grill requires two (2) people.
WARNING: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly,
lifting or moving the grill is recommended. Protective eyewear and long sleeves are also strongly
recommended.
30005823 5/12 Rev. 5 En
VCS322SSBI/522SSBI Series Assembly
3
2
1
5
4
Step 1: Unpack Carton and Verify Contents
Use a sharp cutting tool to cut the straps on the packaging and then lift off the carton top. The sleeve surrounding the barbecue can be removed by lifting it straight up and over the top of the unit. Compare all
contents to the parts list and the carton content lists below. Refer to the parts list for fastener detail.
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly is strongly
recommended.
Remove two (2) tie-down brackets, one on each lower side of unit, by removing two (2) screws from each
bracket. Discard brackets.
IMPORTANT: Replace screws removed from lower sides of unit.
VCS322SSBI Carton Contents
Box 1 (20304616)
Warming Rack
Cover, Rear
Front Grease Tray Assy.
Box 2
Cook Grates (2)
Box 3
Heat Plates (3)
Smoker Box
Knobs (4)
Hardware Bag
Handle, Curved
Battery Case
4. Firebox Assy. (50004822)
5. Lid Assy. (20300391)
Bag-Literature
‘AA’ Battery
Lid Bumpers Set
Assembly Instructions
Parts List
User’s Manual
Bracket, Left
Bracket, Right
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or
moving the grill is recommended.
2
30005823
VCS322SSBI/522SSBI Series Assembly
VCS500BIC
5
6
2
3
4
1
7
1
Step 1: Unpack Carton and Verify Contents (continued)
Bag - Literature
VCS522SSBI Carton Contents
Box 1 (pt. no. 20304500) x 2 boxes
Cook Grate (2 per box = 4 total)
Bag - Literature (pt. no. 30005974)
Assembly Instructions VCSBI (pt.no. 30005823)
Box 2 (pt. no. 20304501)
1. Warming Rack
2. Spit Rod
3. Cover Rear BI
4. Front Grease Tray
Parts List VCSBI (pt. no. 30005806)
User’s Manual VCS (pt. no. 30005801)
Battery “AA”
Lid Bumper (Set of 6)
Deluxe BBQ Cover (VCS500BIC)
Box 3 (pt. no. 20304502)
Heat Plate (5)
Rotisserie Kit
5. Bracket Right
6. Bracket Left
7. Smoker Box
Hardware Bag
Handle
Knobs (6)
Battery Box
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or
moving the grill is recommended.
30005823
3
VCS322SSBI/522SSBI Series Assembly
A
E
D
F
I
B
L
P
H
N
M
G
J
K
C
O
VCS322SSBI / VCS522SSBI Framing Dimensions
When Using Noncombustible Materials
Drain Holes
(2” diameter)
Drain Holes
(2” diameter)
B332
Ref. VCS322SSBI VCS522SSBI
A 31Z\x” (800 mm) 43Z\x” (1105 mm)
B 24” (610 mm) 24” (610 mm)
C 9C\,” (239 mm) 9C\,” (239 mm)
D 3Z\zn” (78 mm) 3Z\zn” (78 mm)
E 3” (76 mm) 3” (76 mm)
F 2” (51 mm) 2” (51 mm)
G 4C\v” (120 mm) 4C\v” (120 mm)
H 18C\v” (476 mm) 18C\v” (476 mm)
I 28C\v” (730 mm) 38” (965 mm)
J* 12B\,” (321 mm) 12B\,” (321 mm)
K* 18Z\v” (464 mm) 18Z\v” (464 mm)
L 10” (254 mm) 10” (254 mm)
M* 3Z\x” (89 mm) Min. 3Z\x” (89 mm) Min.
N 4” (102 mm) Min. 4” (102 mm) Min.
O 4” (102 mm) Min. 4” (102 mm) Min.
P* 2Z\x” (64 mm) Min. 2Z\x” (64 mm) Min.
*Applies if optional side burner Model VCSSBIB will be installed.
NOTE: If the optional side sear burner Model VCSSBIE will be installed, refer to
installation instructions suppied with burner kit for framing dimensions.
NOTE: If the grill is installed directly under a combustible overhang or ceiling, the
ceiling must be at least 38” (965 mm) above the countertop.
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or
moving the grill is recommended.
4
30005823
Loading...