Veris Industries TEA Series Installation Guide

ENVIRONMENTAL SENSORS

INSTALLATION GUIDE

TEA SEriES TEA SEriES

Wall Mount Temperature Transmitters

Installer’s Speciﬁcations

Input Power 4-20mA version: loop powered 24VDC only; 0-10V version: 3-wire, observe polarity, 12-30VDC; 0-5V version: 3-wire, observe polarity, 24VAC, 12-30VDC Analog

Output, mA version 2-wire, not polarity sensitive (clipped and capped) Sensor Type Solid state, integrated circuit (transmitter) Accuracy ±0.5°C (±01°F) typical Temperature

Range 10° to 35°C (50° to 95°F)

NOTICE

• This product is not intended for life or safety applications.

• Do not install this product in hazardous or classiﬁed locations.

• Read and understand the instructions before installing this product.

• Turn oﬀ all power supplying equipment before working on it.

• The installer is responsible for conformance to all applicable codes.

PRODUCT IDENTIFICATION

Output

TEA S

M = 4-20m A V = 0-10VDC J = 0-5VDC

DIMENSIONS

US or EU

= Standard

0.3"

(6 mm)

INSTALLATION

1. Disconnect power to the junction box.

2. Remove junction box cover.

3. Wire as shown (see Wiring Diagrams)

4. Screw TEA cover onto junction box.

3.2"

(82 mm)

2.8"

(70 mm)

4.5"

(115 mm)

0.5"

(13 mm)

Alta Labs, Enercep t, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘ V’ logo are trademark s or registered tradema rks of Veris Industries, L.L .C. in the USA and /or other count ries.

WIRING DIAGRAMS

4-20 mA Output Version (2-wire)

Orange Orange

0-10 V Output Version (3-wire)

TEA SERIES

INSTALLATION GUIDE

Red: +24V Power

Black: GND

Red: +24V Power

Black: GND

Orange: 0-10V TEMP OUT

0-5 V Output Version (3-wire)

Yellow: 0-5V TEMP OUT

Alta Labs, Enercep t, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘ V’ logo are trademark s or registered tradema rks of Veris Industries, L.L .C. in the USA and /or other count ries.