Verint S5020BX-DN, S5003BX-DN Quick Installation Manual

All users should read the related user manuals for complete details on installation, usage and functionality.

Quick Installation Guide

S5000 Series - BX Models

Version 1.0

Nextiva

1

Hardware Overview

The Nextiva S5000BX is available in two models S5003BX-DN and S5020BX-DN. The S5003BX-DN
features a VGA sensor and the S5020BX-DN features a 2-Megapixel sensor.

Lens are not included with the camera, but Verint offers multiple lenses that are available for purchase. If
you choose to purchase a lens elsewhere, ensure it has the following characteristics:

 Aspherical
 CS mount, 1/3 inch format
 Manual or DC auto iris
 Day/Night support

Light Sensor

Built-in
Microphone

SD/SDHC
Card Slot

Audio/Video out,
1/8in (3.5mm) jack

Status LEDs

External
Microphone In

12V DC
Power Cord
Connector

NTSC/PAL
Switch

External/Internal
Mic Switch

RJ-45 Network
Connector

DC-Iris Control
Cable Connector

Hardware Reset
Button

12V DC Output

Relay Output

Dry Contact Input

Ground

24V AC Input

RS-485 +

RS-485 -

Focus Controller*

Zoom Controller*

Auto Iris Cable

Front View Rear View

*The position of the zoom and focus controllers will vary depending on
the lens manufacturer.

2

Installing the Nextiva S5000BX Models

This section explains how to mount and connect a lens onto the Nextiva S5000BX models.

CAUTION: Verint will not be held liable for damages to persons or property due to the improper installation

of the Nextiva S5000 series IP cameras.

 To mount the lens:

1. Mount the lens by turning it clockwise onto the camera mount until it stops.

2. Connect the lens cable plug to the camera DC-Iris Control connector.

Setting the Video Standard

The Nextiva S5000FDW can run in one of two video standards (NTSC or PAL).

 To set the video standard:

1. Move the DIP switch to NTSC or PAL.

Connecting the Nextiva S5000BX Models

This section explains how to connect the power and network cables to the Nextiva S5000BX models. A
power supply is not included with the Nextiva S5000BX models and must be purchased separately.

CAUTION: Never use a PoE power connection and a 12V DC power connection at the same time. This may

damage the device.

 To power the Nextiva S5000BX models using a 802.3af compliant PoE kit:

1. Plug a straight-through ethernet cable into the RJ-45 connector on the back of the IP camera.

2. Plug the other end of the cable into a POE ethernet switch or to the Data&PWR port of a POE injector. If
you use a PoE injector, make sure the Data port of the injector is properly connected to the ethernet
switch.