Venta Sonic Vs100 Owner's Manual

User Manual

Ultrasonic Humidifier • Model # VS 100

IMPORTANT! READ AND SAVE THESE INSTRUCTIONS

VENTA-SONIC

Read all instructions: Important Safeguards

When using electrical appliances, especially when children are present, basic safety
precautions should always be followed, including the following:

1 Always have water in the water tank when operating unit.

2 Use only clean, cool tap water to fill tank.

3 Use only 110-120V AC outlet. As with any electrical device, plug and unplug unit

with dry hands only. Turn unit off prior to unplugging it. Unplug unit when not in use
and before you clean or move the unit.

4 This unit shuts off automatically when water tank is empty.

5 Never operate unit with a damaged cord or plug. Keep cord straight.

6 Always place unit on an elevated (at least 1 foot off the ground), flat, level surface

away from direct sunlight. Keep cord away from heated surfaces and areas where
it could be walked on or tripped over.

7 Do not add medication, fragrances, or oils of any type into the nozzle, base, or

water tank. Do not cover any opening of the unit or insert objects into any
openings.

8 The unit should not be left unattended in closed rooms as air could become

saturated and leave condensation on walls or furniture. Always leave room door
partially open.

9 Do not tilt or tip unit or attempt to empty or fill it while it is operating.

10 Replace demineralization cartridge every 2-3 months or more frequently as needed.

Parts Descriptions

2

VAPOR NOZZLE

TANK

INTERNAL VENTILATOR

CLEANING BRUSH

Use for cleaning of Oscillator
and parts inside the base.

POWER CORD

CONTROL PANEL

BASE

OSCILLATOR

WATER LEVEL SENSOR

HANDLE

Features

I Ultra-quiet operation.

I Optional cool or warm mist operation.

I Built-in hygrostat for controlled humidification.

How To Use Your Venta-Sonic Humidifier

IMPORTANT!

Place unit on a level, elevated (at least one foot high), flat surface away from direct
sunlight. Keep cord away from heated surfaces and areas where it could be walked on
or tripped over.

1 Fill Water Tank.

Turn off humidifier and unplug the power cord from A/C outlet. Remove tank from
base. Turn upside down and unscrew filling cap. Fill tank with clean, cool, distilled,
filtered, or tap water. Do not attempt to fill unit through Vapor Nozzle. Water temper­ature should NEVER be too hot or too cold. Extreme temperatures can damage the
unit. Tighten filling cap firmly. Return tank to base and let it sit for a few minutes. For
first time use or when replacing the demineralization cartridge filter, please soak the
filter in warm water for several minutes.

2 Turn Unit On.

Plug power cord into a 110-120V AC outlet only. Turn power switch (POWER ON/OFF,
SPRAY CONTROLLER) on (turn clockwise). Power light will illuminate. A green light
indicates “cold mist” operation and a “red” light indicates “warm mist” operation. You
may change from cold mist to warm mist and vice versa by pressing the selector
switch (WARM MIST) in the bottom center of the control panel. Aim nozzle away from
furniture and walls. Mist may take a few minutes to be visible.

3 Turn Unit Off When Finished.

Always turn humidifier off and unplug power cord from A/C outlet when not in use.

3

HUMIDITY
CONTROLLER

POWER ON/OFF
SPRAY CONTROLLER

COLD/WARM MIST
SELECTOR SWITCH

LED POWER LIGHT

Power on: green
Warm mist: red
No water: light off