VENOM P4 Professional Operating Manual

1

© Venom Group International 2016

P4PROFESSIONAL

venompower.com

400W 4 PORT PHANTOM 4

™

BATTERY CHARGER

OPERATING MANUAL

P4PROFESSIONAL

CHARGER

0697

venompower.com

Thank you for purchasing the Venom P4 Professional Charger.
This Venom P4 Professional battery charger is designed to charge,
cycle, or storage charge up to four DJI Phantom 4™ batteries
simultaneously.

If you have read the entire manual and still are unclear regarding
any of the functions, warnings, or safety precautions, please
contact our customer service department PRIOR to using this
product.

These warnings and safety notes are VERY IMPORTANT. Please follow the instructions
for maximum safety; misuse can result in damage to the charger and battery. In extreme
cases, improper use can result in bodily injury or property damage.

• Never leave the charger unsupervised when connected to a power supply. If any
malfunction is observed immediately terminate the process, unplug the charger and

refer to the operation manual.

• Keep the charger away from dust, water, heat, direct sunlight and vibration.

• The circuit of this unit can be powered by AC 100-240V power source.

• This unit and the battery to be charged or discharged should only be set upon a heat
resistant, non-flammable and non-conductive surface. Keep all flammable or volatile
materials well away from operating area.

• Be sure to understand the specifications of the battery to be charged or discharged. If the
program is set up incorrectly the battery can be severely damaged. Lithium batteries when
improperly charged or discharged, can cause permanent damage or fire.

• Never attempt to disassemble or repair the charger or batteries. For any issues please
submit a support case at: www.venompower.com/pages/submit-a-support-case

• Lithium batteries prefer a partial rather than a full discharge. Frequent full discharges

should be avoided if possible. Instead, charge the battery more often or use a larger
capacity pack. (Cycle the battery completely once every 20 charge / discharge
cycles to optimize the battery.)

Warnings & Safety Notes

© Venom Group International 2016

P4PROFESSIONAL

venompower.com

1. Exterior of the Unit 1

2. Using Your Charger 2

3. Notes on the Cycle and Storage Modes 3-4

4. Charging Your Phantom 4 Transmitter 5

5. Specifications 6

6. Warranty and Service 6-7

7. Notes 8

1

0697

venompower.com

1. EXTERIOR OF THE UNIT

Storage Battery

Mode Button (X4)

Cycle Battery

Mode Button (X4)

Status Light

Indicator (X4)

2.3A USB Ports

Transmitter Charge Port

X4 POWER

P4PROFESSIONAL

CHARGER

USB

TRANSMITTER

USB

100W X4

PART#: 0697

AC input power:

Circuit power:

Transmitter:

USB:

Input: 100~240 Volt

Max 100W for charging(X4)

Max 10W for discharging(X4)

17.5V out DC

5.3V / 2.3A (X2)

AC POWER

100V - 240V

OFF

ON

FRONT

RIGHT

Power Switch

AC Power Input