Venmar VJ603302SS, VJ604302SS INSTALLATION INSTRUCTIONS AND OPERATION MANUAL

CHIMNEY RANGE HOODS

MODELS VJ603302SS & VJ604302SS

INTENDED FOR DOMESTIC COOKING ONLY

INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.

HOMEOWNER: USE AND CARE INFORMATION ON PAGES 7 AND 8.

Venmar Ventilation Inc., 550 Lemire Blvd., Drummondville QC J2C 7W9 1-800-567-3855

REGISTER YOUR PRODUCT ON LINE AT: www.bnv.ca

For additional information - visit www.venmar.ca

INSTALLATION GUIDE

READ AND SAVE THESE INSTRUCTIONS

!

!

09070 rev. 06

HB0094

HB0095

!

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSON(S) OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service

panel and lock service disconnecting means to prevent
power from being switch on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service
panel.

3. Installation work and electrical wiring must be done by qualified

personnel in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting

of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment
manufacturer’s guidelines and safety standards such as
those published by the National Fire Protection Association
(NFPA), the American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE) and the local
code authorities.

5. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Do not use this unit with any other solid-state speed control

device.

8. To reduce the risk of fire, use only metal ductwork.

9. This unit must be grounded.

10. To provide protection against electric shock, connect to

properly grounded outlets only.

11. When applicable local regulations comprise more restrictive

installation and/or certification requirements, the aforementioned
requirements prevail on those of this document and the
installer agrees to conform to these at his own expenses.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may
ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when

cooking flaming foods (i.e.: Crêpes Suzette, Cherries
Jubilee, Peppercorn Beef Flambé).

c) Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or filter.

d) Use proper pan size. Always use cookware appropriate for

the size of the surface element.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSON(S) IN
THE EVENT OF A RANGE TOP GREASE FIRE,
OBSERVE THE FOLLOWING*:

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or

metal tray, then turn off the burner. BE CAREFUL TO PREVENT
BURNS. IF THE FLAMES DO NOT GO OUT IMMEDIATELY,
EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN – You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels –

This could cause a violent steam explosion.

4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you

know how to operate it.

B. The fire is small and contained in the area where it started.
C. The fire department has been called.
D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

!

WARNING

CAUTION

1. For indoor use only.

2. For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

3. To avoid motor bearing damage and noisy and/or

unbalanced impeller, keep drywall spray, construction dust,
etc. off power unit.

4. Your hood motor has a thermal overload which will

automatically shut off the motor if it becomes overheated.
The motor will restart when it will cool down. If the motor
continues to shut off and restart, have the hood serviced.

5. The minimum hood distance above cooktop MUST NOT BE

less than 26”. For best capture of cooking impurities, the
bottom of the hood should be at a maximum of 30” above
cooking surface. For a gas range, the bottom of the hood
MUST NOT BE LESS than 30” above cooktop.

6. Two installers are recommended because of the size of this

hood.

7. To reduce risk of fire and to properly exhaust air, be sure to

duct air outside. Do not exhaust air into spaces within walls
or ceilings or into attics, crawl spaces, or garages.

8. Because of the high exhausting capacity of this hood, you

should make sure enough air is entering the house to
replace exhausted air by opening a window close to or in
the kitchen.

9. Please read specification label on product for further

information and requirements.

-2-

IMPORTANT SAFETY INSTRUCTIONS

-3-

1. INSTALL DUCTWORK

Decide where the ductwork will run between the hood and the outside.
A straight, short duct run will allow the hood to perform most efficiently.
Long duct runs, elbows and transitions will reduce the performance of the hood. Use

as few of them as possible. Larger ducting may be required for best performance with
longer duct runs.

Install wall cap or roof cap. Connect round metal ductwork to cap and work back
towards the hood location. Use metal foil duct tape to seal the joints between ductwork
sections.

WARNING

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.

!

To reduce the risk of fire, use only metal ductwork.

2. MEASURE INSTALLATION

The minimum hood distance above cooktop MUST NOT BE less than 26”.
A maximum of 30” above cooktop is highly recommended for best capture

of cooking impurities.

For a gas range, the bottom of the hood MUST NOT BE LESS than 30”
above cooking surface.

NOTE: For a 9 feet high ceiling, the bottom of the hood MUST BE located

at least at 30” above a 36-inch high cooktop.

Distances over 30” are at the installer and users discretion; providing that
ceiling height permit.

HH0097A

HOOD

12 5/8” TO CENTER

OF

BRACKET HOLES

ROUND ELBOW

HOOD MOUNTING

BRACKET

3¼”

D

ECORATIVE FLUE

6” ROUND DUCT

ROOF CAP

WALL CAP

26” MINIMUM ABOVE

COOKING

SURFACE

(30” FOR GAS RANGE)

6”

ROUND DUCT

ROOF CAP

ROUND

ELBOW

WALL CAP

HOOD

DECORATIVE

FLUE

HH0095A

26” MINIMUM ABOVE

COOKING

SURFACE

(30” FOR GAS RANGE)

WARNING

!