Vencer BTVS3000 User Manual

BBlluueettooootthh VV55..00 TTrruuee W

Wiirreelleessss EEaarrbbuuddss

GENERAL INSTRUCTIONS

 Multimedia Interface

Function Operation Notification Tone Voice Prompt LED Indication

Power On

Press and hold for 1 second
and release.

Power On Blue LED flashes 1 time.

14F-12, No. 79, Section 1, Hsin Tai Wu Road, Hsi-Chih District, New Taipei City, 22101 Taiwan

Tel: [phone] Fax: [phone]

1/4

BBlluueettooootthh VV55..00 TTrruuee W

Power Off

Pairing

Answer a Call

End a Call

Reject a Call

Play/Pause

Factory Reset

Long press and hold for 3
seconds and release.

Long press and hold for 6
seconds and release.

Short press once. Beep

Short Press once. Beep

Press and hold for 1 second
and release.

Short press once. Beep

Long press and hold for 15
seconds and release for both
sides at the same time.

Wiirreelleessss EEaarrbbuuddss

DongDong-Dong Power Off

DongDong-Dong
Dong-Dong-Dong

Dong Beep

DongDong-Dong

Dong-Dong-Dong
Dong-Dong-Dong-Dong
 Dong-Ding-Dong
Dong-Ding-Dong-Dong-

Ding

 LED Indication & Tone/Voice Prompt

Status Blue LED Red LED Green LED Tone / Voice Prompt

Red LED flashes 2 times.

Pairing Blue and red LED flash alternately.

Green LED flashes 2 times.
Blue LED quickly flashes while
entering factory reset to start peer
pairing. (Note: The left side earbud
will automatically enter pairing
mode when peer pairing is
completed.)

Power On
Power Off
Pairing
Pairing Successful
Connected
Disconnected
AAC/SBC Streaming On
aptX Streaming On
Call-ringing

Flashes 2 times. “Power On”

Flashes 2 times. “Power Off”

Flash alternately. “Pairing”

“Pairing Successful”

Flashes 2 times. “Connected”

“Disconnected”

Flashes 2 times.

Flashes 2 times.

Flashes 3 times.

Answer a Call
End a Call

Low Battery
Play/Pause

Earbuds Charging
Earbuds Charging

Completed

Flashes 2 times.

Flashes 5 times.

On

Off

 LED Indication of Charging Case

Status Condition Blue LED Indication
Charging the battery of charge case
Charging completed for the battery of
charge case

Micro-USB charging cable plug-in Flashes 1 time every 2 seconds.

Micro-USB charging cable plug-in Remains on.

Flashes 2 times. Beep

Beep

15% of power level: “Battery Low”
3% of power level: Dong-Dong & ”Battery Low”

Beep

14F-12, No. 79, Section 1, Hsin Tai Wu Road, Hsi-Chih District, New Taipei City, 22101 Taiwan

Tel: [phone] Fax: [phone]

2/4

BBlluueettooootthh VV55..00 TTrruuee W

Charging the earbuds
Charging the earbuds when battery
level of charge case is low

Wiirreelleessss EEaarrbbuuddss

No micro-USB charging cable plug-in Remains on (off after fully charged).

No micro-USB charging cable plug-in Flashes 1 time every 1 second.

OPERATIONS GUIDE

1. Power On/Off

To power on
Wear VS-3102 on ears and then short press the button on each of the earbuds. Blue LED will flash one
time and you can hear a “Power on” voice prompt in each of them.

To power off

1. Put VS-3102 back into the charging case. Or,

2. Long press and hold the button for 3 seconds and then release after you hear a Dong-Dong
notification tone. Then the earbud will be powered off after you hear a “Power-off” voice prompt.

2. Bluetooth Pairing:

Both sides of the earbuds have been pre-paired for connection before shipped out from the factory.
Users must pair either side of the earbuds with your Bluetooth device before used.

Step 1: Wear earbuds on ears and turn on both earbuds or hold one side to see the LED status first.

Step 2: Choose one earbud and long press and hold the button for 6 seconds then release after you hear
a Dong-Dong-Dong notification tone. The earbud will be in the pairing mode and a “Pairing”
voice prompt will be announced. Blue and red LED will flash alternately.
Step 3: Initiate the pairing process on your Bluetooth device to pair with the selected earbud. Device
name “VS-3102_Left” or “VS-3102_Right” will be shown on the device screen after searching.
Step 4: Select “VS-3102_Left” or “VS-3102_Right” to complete the pairing process with the Bluetooth

device. Now you can hear “Pairing successful” and “Connected” voice prompts.
Step 5: A pop-up message on the device screen will be shown to ask for pairing with another earbud. Tap
the “Pair” icon on the screen to complete the whole pairing process. Once the pairing process is
finished, both sides of the earbuds will be listed as paired devices. And the one connected with
the Bluetooth device will be highlighted.

3. Listening to Music

If your Bluetooth device supports the A2DP stereo audio profile, you can listen to music with VS-3102. If

it also supports the AVRCP profile, you may control music play/pause by short pressing the button.

4. Make a Call

Dial a phone number on a mobile phone as you normally do. Once a call is getting through, the voice
will be transmitted to your earbuds automatically.

5. Answer, End, or Reject a Call

When VS-3102 connects with your mobile phone, you will hear a ring tone while there is an incoming
call. On either side of the earbuds, you can

(1) short press the button to answer the call.

14F-12, No. 79, Section 1, Hsin Tai Wu Road, Hsi-Chih District, New Taipei City, 22101 Taiwan

Tel: [phone] Fax: [phone]

3/4

BBlluueettooootthh VV55..00 TTrruuee W

Wiirreelleessss EEaarrbbuuddss

(2) short press the button to end the call.
(3) press and hold the button for 1 second and then release after you hear a Dong notification tone to

reject the incoming call.

6. Factory Reset

On both sides at the same time, long press and hold the button for 15 seconds and release after you

hear a Dong-Ding-Dong-Dong-Ding notification tone. When Blue LED quickly flashes it means factory
reset starts. The left side earbud will automatically enter the pairing mode when peer pairing is
completed.

7. Charge Earbuds & Charging Case

Put the earbuds back into the charging case to charge the earbuds.

- Red LED of the earbud will be on when it is charging. Once it is fully charged, the red LED will go off.

- Blue LED of the charging case will be on when earbuds are charging and go off after the earbuds are
fully charged.

Plug the micro-USB charging cable into the connector of the charging case for charging its battery.

- Blue LED of the charging case will flash when it is charging and will remain on after charging case’s
battery is fully charged.

8. Landscape Sound On/Off

You can download the “Soundthrough” App from Google Play or iOS store. The landscape sound function

can be activated and controlled through the App.

FCC Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.

Note: Vencer Co., Ltd. reserves the right to amend the content of this document when necessary without prior notice to its users.

14F-12, No. 79, Section 1, Hsin Tai Wu Road, Hsi-Chih District, New Taipei City, 22101 Taiwan

Tel: [phone] Fax: [phone]

4/4