Vencer BTVR2100 User Manual

QQuuiicckk GGuuiiddee ooff VVRR--22110000

FCC Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

14F-12, No.79, Sec.1 , Hsin Tai Wu Rd., Hsi-Chih, New Taipei City, Taiwan

Tel. No.:[phone] Fax No.:[phone]

1/2

QQuuiicckk GGuuiiddee ooff VVRR--22110000

To turn the Plant on

Press the button 3 seconds when power off. The Plant will power on and enter

advertising mode automatically. Green LED will slow flash with 10 seconds.

To turn the Plant off

Press the button 3 seconds when power on. The Plant will power off and stop

advertising mode automatically. Green LED will fast flash 3 times.

Plant Low battery warning

If battery voltage lower then 1.2 volts, the Red LED will slow flash around 10

seconds.

Data Storage

VR-2100 provide temperature, humidity and sunshine data store, under normal

operating the Plant lose connection with the APP, Plant will automatically

record data per two hours, but at most retain 90 days data

When VR-2100 connection with APP, it will send stored data to APP, the APP

received all data from Plant completed, the Plant stored data will be deleted.

14F-12, No.79, Sec.1 , Hsin Tai Wu Rd., Hsi-Chih, New Taipei City, Taiwan

Tel. No.:[phone] Fax No.:[phone]

2/2