Vello CB-300 User manual

CB-300

-

QUICKSHOT
FLASH BRACKET
MANUAL

2

INTRODUCTION

Thank you for choosing a Vello Rotating Flash Bracket . The Vello CB-300
Rotating Flash Bracket accepts SLR and medium format cameras, allowing
you to position a ash directly above the lens in horizontal or vertical
orientation. The adjustable ash shoe is capable of accommodating almost
any portable ash.

The bracket is all metal yet lightweight . It includes a cork pad to prevent
the camera from slipping on the mount. The height of the upright arm of
the bracket is adjustable. There is also a 1/4˝-20 socket for tripod
mounting. Integrated feet allow you to securely set your camera down
mid-session. Please follow the instructions below to get the most out of
your Vello Rotating Flash Bracket .

© Copyright 2011 Gradus Group

FEATURES DIAGRAM

Shoe Mount Flash Rotating Arm

Locking Knob

Upright Arm

Mounting Plate

Alignment Guide Mark

1/4˝-2 0 C am era
Mounting Socket

3

Tripod 1/4 20 Socket

4

TO MOUNT THE CAMERA

1. Mount the camera to the plate
by screwing the mounting knob
into your camera's tripod socket.

The top plate can be removed if necessary to accommodate certain models of
larger cameras. Use a screwdriver to remove the screw holding the plate to
the bracket.

2. Before tightening the mounting
knob, make certain that the
camera is ush against the
retaining lip of the plate.

ADJUSTING THE UPRIGHT ARM

The upright bracket can be adjusted to properly center the ash unit
and to accommodate larger cameras.

5

1. Loosen the two screws on the
side of the upright arm.

2. Adjust the bracket's position. The
center of the lens should align with
the shaped hole in the bracket.

3. Retighten the screws. The ash
will now be centered above the
lens when you switch to a
vertical orientation.

6

MOUNTING THE FLASH

The Vello Rotating Flash Bracket features an adjustable cold shoe.

1. Turn the red knob counter­clockwise until the shoe mount is
open wide enough to
accommodate the ash.

2. Tighten the red knob until the
ash is secure.

3. Connect your ash to your
camera with the appropriate
sync cord for your model of ash
and camera (not included). Sync
cords can be obtained from your
photo equipment dealer.

ROTATING THE FLASH

7

1. The Vello Rotating Flash Bracket
allows you to hold your camera
as you normally would, right
hand holding the camera, ready
to press the shut ter button.

2. To switch from horizontal
(landscape) to vertical (portrait)
positioning, grasp the ash unit
near the shoe mount and pull the
rotating arm down clock wise.

3. At the same time, turn the camera
to the ver tical orientation.

FIVE YEAR LIMITED WARRANTY

Vello provides a limited warranty to the original purchaser that this
product is free from defects in materials and workmanship under normal
consumer use for a period of ve (5) years from the original purchase date.
Vello's responsibility shall be limited solely to repair or replacement, at its
option. This warranty does not extend to damage or failure which results
from misuse, abuse, neglect, accident, alteration, improper installation or
maintenance. Except as provided herein, Vello makes no express or implied
warranty of merchantability or tness for any particular purpose. To
exercise this warranty during the warrant y period, please return the
defective item with proof of purchase and RMA number to the place of
purchase. This warranty gives you specic legal rights, and you may have
other rights which vary from state to state.

www.vellogear.com