Vello CB-100 User manual
Camera Platform
Multiple Camera
Mounting Holes
1/4”-20 Camera
Mounting Knob
Removable Accessory
Shoe Mount
Limited Five-Year Warranty
Vello provides a limited warranty that this product is free from defects in materials and workmanship to the original purchase under normal
use for a period of ve (5) years from the original purchase date. Vello’s responsibility with respect to this limited warranty shall be limited
solely to repair or replacement, at its option, of any product which fails during normal consumer use. This warranty does not extend to
damage or failure which results form misuse, neglect, accident, alteration, abuse, improper installation or maintenance. EXCEPT AS
PROVIDED HEREIN, VELLO MAKES NEITHER ANY EXPRESS WARRANTIES, NOR ANY IMPLIED WARRANTIES, INCLUDING BUT
NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. To obtain a
replacement during the time of this warranty, please return the defective item with proof of purchase, along with an RMA number to the place
of purchase. This warranty gives you specic legal rights, and you may also have other rights which vary from state to state.
© Copyright 2011 Gradus Group www.vellogear.com
MOUNTING THE CAMERA
There are ve mounting holes on the
bracket’s camera platform. Place your
camera on the platform and align your
camera’s mounting socket with the
mounting hole that best centers your
camera on the bracket. Attach the
camera to the QuickDraw bracket
using the 1/4”-20 mounting knob.
Tighten the knob until rmly
connected.
MOUNTING THE FLASH
The QuickDraw Bracket is equipped
with an accessory-shoe mount which
can be used to mount your ash unit
or TTL cord. To mount your ash,
loosen the red knob on the
cold-shoe, insert your ash, and
tighten the knob. Unless you are using
a wireless ash system, you will need
to connect your ash to the camera
with the appropriate cord. You may
use cable ties or an optional cord
wrap to secure the cord alongside the
bracket.
To attach separate ash heads such as
Norman or Lumedyne, or the Nikon
SC-28 and SC-29 off-camera shoe
cords, remove the cold shoe mount
from the ash arm and use the
included mounting screw to mount
the ash head to the bracket.
Thank you for choosing the Vello QuickDraw
Bracket. The QuickDraw puts you in control of
your lighting whether you’re shooting horizontally or
vertically, and allows you to switch between the two
orientations with just a quick ip of the rotating arm.
Please follow the instructions below to get the most
out of your QuickDraw Bracket and to prevent
improper installation which may cause damage to
your equipment.
USING THE BRACKET FOR
HORIZONTAL SHOOTING
Position the ash arm so that it is
raised directly above the top of the
camera’s body with the ash mount
centered above the lens when the
camera is held horizontally.
USING THE BRACKET FOR
VERTICAL SHOOTING
Rotate the ash arm 180° to center
the ash above your lens when the
camera is held vertically.
ROTATING FLASH BRACKET
QUICKDRAW
QuickDraw Grip
(Cat. # CB-RF)
Rotating Flash Arm
Loading...