Vela Tango 100 Arthrodesis, Tango 200, Tango 100, Tango 100EL, Tango EL Sit-stand User Manual
...
VELA Tango
VELA Tango 100 VELA Tango 200
VELA Tango 200ElVELA Tango 100El
USER MANUAL EN
VARIANT:
Manual no. 105017
VELA Tango 100
Arthrodesis
VELA Tango El
Sit-stand
100, 100EL, 200 & 200EL
TABLE OF CONTENTS
1.0. INTRODUCTION 3
1.1. SAFETY 4
1.1.1. Usage 4
1.1.2. Transport 4
1.2. WARRANTY 4
1.3. UNPACKING THE CHAIR 5
1.4. MAINTENANCE 5
1.4.1. Wheels 5
1.4.2. Frame 5
1.4.3. Upholstery 5
1.5. RECYCLING 5
1.6. USER MANUAL 6
1.6.1. Attaching the backrest 6
1.6.2. Adjustment of seat height (VELA Tango El) 6
1.6.3. Changing place for height adjustment - right/left
armrest or switch box (VELA Tango El) 6
1.6.4. Adjustment of seat height (VELA Tango) 6
1.6.5. Adjustment of seat tilt 7
1.6.6. Adjustment of back angle 7
1.6.7. Adjustment of back height 7
1.6.8. Adjustment of armrest, height 7
1.6.9. Adjustment of armrest, width 8
1.6.10. Brakes 8
1.6.11. Rotation (VELA Tango) (optional) 8
1.6.12. Rotation (VELA Tango El) (optional) 8
1.6.13. Back latch (VELA Tango 200 & 200El) 9
1.6.14. Charging (VELA Tango El) 9
1.6.15. Coxit split seat (optional) 9
1.6.16. Footrest (optional) 9
1.6.17. Foot plate (optional) 10
1.6.18. Push Handle (optional) 10
1.6.19. Footbrake pedal (optional) 10
1.6.20. Angle Contact (optional) 10
1.6.21. Remote Control (optional) 11
1.6.22. Electric tilt (optional) 11
1.6.23. Electric brake (optional) 11
3
DEAR CUSTOMER
Thank you for purchasing a VELA Tango. This user
manual contains useful information about positioning,
operating and maintenance of VELA Tango chairs.
Important
Please read this user manual thoroughly and keep
it for later use. This user manual must always
accompany the chair. The user manual is also
available on VELA’s website: www.vela.eu, where you
also can find other relevant information about VELA
Tango chairs.
If you have any questions, please contact VELA’s
distributor in your country.
VELA reserves the right to make changes to this
manual.
VELA
Gøteborgvej 8-12
DK-9200 Aalborg SV
Denmark
www.vela.eu
1.0. INTRODUCTION
4
1.1. SAFETY
This chair bears the CE mark and
conforms to all applicable EU rules.
The stool is manufactured by VELA,
Vermund Larsen A/S, Goeteborgvej
8-12, 9200 Aalborg SV, Denmark.
VELA Tango El lives up to all
EMC-demands according to the IEC
60601-1-2. Please exercise special
caution when using strong sources of interference, such as high
frequency surgical equipment and
similar, so that HF cables do not
come near the chair. If in doubt,
please contact an authorized technician.
1.1.1. USAGE
VELA Tango is an indoor chair
designed for sitting persons.
:: The chair is not built to stand on.
:: For safe transfer of a person to
and from the chair, the chair must
always have its brakes on.
VELA Tango 100/100El/200/200El is
tested and approved for a maximum
user weight of 160 kg.
Important: People using a seatbelt
in a VELA Tango, should always be
supervised when the belt is in use.
1.1.2. TRANSPORT
By transport in car, by plane or
other means of transport, always
use the chair’s brake. The chair is
not approved as a passenger seat in
means of transportation and should
not be used as such.
The chair withstands the following
transport specifikations:
Temperature: -40°C (-40°F) to
+70°C (+158°F)
Humidity: 15-95%
Air pressure: PPP up to 1000 meters
(3280 ft) above sea level
1.2. WARRANTY
VELA provides warranty by the laws
and regulations which are debt in the
country the chair is bought in. The
warranty only applies when using
original spare parts and accessories.
Modification may only be carried out
by authorised service technicians.
VELA does not accept responsibility
for damage or injury to the product
or user, which have arisen due to:
:: Transportation
:: Misuse
:: General wear and tear
:: Incorrect use
:: Use of non-original spare parts
and accessories
:: Adjustments carried out by
unauthorised service technicians
GENERAL
Loading...