Vela Tango 100S, Tango 100ES User Manual

Page 1
VELA Tango 100S
100S & 100ES
VELA Tango 100ES
USER MANUAL EN
VARIANT:
Manual no. 105163
VELA Tango for children
Page 2
INDHOLDSFORTEGNELSE
1.0. INTRODUCTION 3
1.1. SAFETY 4
1.1.1. Usage 4
1.1.2. Transport 4
1.2. WARRANTY 4
1.3. UNPACKING THE CHAIR 5
1.4. MAINTENANCE 5
1.4.1. Wheels 5
1.4.2. Frame 5
1.4.3. Upholstery 5
1.5. RECYCLING 5
1.6. USER MANUAL 6
1.6.1. Attaching the backrest 6
1.6.2. Adjustment of seat height (VELA Tango 100ES) 6
1.6.3. Adjustment of seat height (VELA Tango 100S) 6
1.6.4. Adjustment of seat tilt 6
1.6.5. Adjustment of backrest angle 7
1.6.6. Adjustment of back height 7
1.6.7. Back latch 7
1.6.8. Adjustment of armrest, height 7
1.6.9. Adjustment of armrest, width 8
1.6.10. Brake 8
1.6.11. Charging (VELA Tango 100ES) 8
1.6.12. Foot plate 8
1.6.13. Rotation (VELA Tango 100S) (optional) 9
1.6.14. Rotation (VELA Tango 100ES) (optional) 9
1.6.15. Push Handle (optional) 9
1.6.16. Foot pedal for brake (optional) 9
1.6.17. Hand box (optional) 10
1.6.18. Electric brake (optional) 10
Page 3
3
DEAR CUSTOMER
Thank you for purchasing a VELA Tango children’s chair. This user manual contain useful information about positioning, operating and maintenance of VELA Tango 100ES/S chairs.
Important
Please read this user manual thoroughly and keep it for later use. This user manual must always accompany the chair. The user manual is also available on VELA’s website: www.vela.eu, where you also can find other relevant information about VELA Tango children’s chairs.
If you have any questions, please contact VELA’s distributor in your country.
VELA reserves the right to make changes to this manual.
VELA
Gøteborgvej 8-12 DK-9200 Aalborg SV Denmark www.vela.eu
1.0. INTRODUCTION
Page 4
4
1.1. SAFETY
This chair bears the CE mark and conforms to all applicable EU rules. The stool is manufactured by VELA, Vermund Larsen A/S, Goeteborgvej 8-12, 9200 Aalborg SV, Denmark.
VELA Tango 100ES lives up to all EMC-demands according to the IEC 60601-1-2.
1.1.1. USAGE
VELA Tango 100ES/S is an indoor children’s chair designed for sitting persons.
:: The chair is not build to stand on.
:: For safe transfer of a person to
and from the chair, the chair must always have its brakes on.
VELA Tango 100 ES/S is tested and approved for a maximum user weight of 80 kg.
Important: People using a seatbelt in a VELA Tango 100ES/S, should always be supervised when the belt is in use.
1.1.2. TRANSPORT
By transport in car, by plain or other means of transport, always use the chair’s brake. The chair is not approved as a passenger seat in means of transportation and should not be used as such.
The chair withstands the following transport specifikations:
Temperature: -40°C (-40°F) to +70°C (+158°F) Humidity: 15-95% Air pressure: PPP up to 1000 meters (3280 ft) above sea level
1.2. WARRANTY
VELA provides warranty by the laws and regulations which are debt in the country the chair is bought in. The warranty only applies when using original spare parts and accessories. Modification may only be carried out by authorised service technicians.
VELA does not accept responsibility for damage or injury to the product or user, which have arisen due to:
:: Transportation
:: Misuse
:: General wear and tear
:: Incorrect use
:: Use of non-original spare parts
and accessories
:: Adjustments carried out by
unauthorised service technicians
GENERAL
Page 5
5
1.3. UNPACKING THE CHAIR
All VELA Tango 100ES/S chairs are supplied in cardboard packaging, developed with consideration for the environment.
If there are any parts missing or transport damage to the chair, plea­se contact your dealer immediately. Do not not try to repair any damage or use the chair.
Content of the cardboard packaging:
:: VELA Tango 100ES/S chair
:: This user manual
1.4. MAINTENANCE
We recommend your VELA Tango undergoes an annual service to find, for example, defective or worn parts.
1.4.1. WHEELS
VELA recommend that the wheels are checked in regular intervals e.g. to remove possible thread remnants.
1.4.2. FRAME
Clean with water, possibly with a PH neutral soap.
1.4.3. UPHOLSTERY
Fabric: Clean with upholstery clea-
ners or wipe it with a tightly wrung cloth rinsed in clean water.
Imitation leather: Clean with water or mild soap.
Medical textiles: Clean as described above. Can also be cleaned with disinfectants and alcohol.
Leather: Cleen by vacuuming it using a soft dusting brush. Avoid cleaning products.
1.5. RECYCLING
Several parts of the chair can be re­used. Please return the chair to VELA or to your local recycling center.
Page 6
VELA
TANGO
100S
VELA
TANGO
100ES
6
1.6. USER MANUAL
Replacement of the gas spring may only be performed by the service support team from your dealer or a skilled technical person.
1.6.3. ADJUSTMENT OF SEAT HEIGHT (VELA TANGO 100S)
Adjust the seat height by pulling up the front lever placed at your right hand.
1.6.2. ADJUSTMENT OF SEAT HEIGHT (VELA TANGO 100ES)
Is operated from the flip-up height control pad located ot the underside of either the right or left armrest. Note: VELA Tango 100ES is also available with height adjustment via hand box (i.e. if caregivers must be able to adjust the height).
1.6.4. ADJUSTMENT OF SEAT TILT
Adjust the seat tilt by pulling up the middle lever placed at your right hand.
2.
1.
3.
1.6.1. ATTACHING THE BACKREST
The lever (1) for backrest adjustment (see section 1.6.6.) must be in open position. Put the backrest rod through the protective cap and into the hole. Tighten the lever afterwards. Insert the end cap (2) in the bottom of the backrest rod. Insert the plastic knop (3) into the small hole on the left side of the backrest rod.
Page 7
7
1.6.6. ADJUSTMENT OF BACK HEIGHT
Adjust the back height by pulling up the lever situated at the bottom of the backrest. Remember to tighten the handle again afterwards.
1.6.8. ADJUSTMENT OF ARMREST, HEIGHT
Adjust by loosening the screw/lever on the armrest bar and regulate the height of the armrest. Remember to tighten the screw/lever again.
1.6.5. ADJUSTMENT OF BACKREST ANGLE
Adjust the back tilt by pulling up the rear lever placed at your right hand.
1.6.7. BACK LATCH
The backrest can be set to a specific angle by adjusting and secure the bolt which is mounted on the back of the chair back.
Page 8
VELA
TANGO
100ES
8
1.6.11. CHARGING (VELA TANGO 100ES)
Daily charging is recommended. Place the charger in the plug ­if the chair is charging, an yellow LED is illuminated. If the chair is fully charged the LED is green. Note: The chair should not be used during charging.
1.6.10. BRAKE
The chair brakes by moving the lever situated on the side of the chair forward. Unlock the chair by moving the handle back into upright position. Note: The brake can be moved by loosening the screw at the bottom of the brake lever, remove the plastic knob on the opposite side hole and insert the brake lever. Remember to tighten the screw again.
1.6.9. ADJUSTMENT OF ARMREST, WIDTH
Adjust by loosening the screw underneath the seat and regulate the width of the armrest. Remember to tighten the screw again.
1.6.12. FOOT PLATE
The foot plate can be adjusted in length by loosening the hand screw in the center of the rod on the footrest. Remember to tighten the screw afterwards. The foot plate can be folded up so that it does not interfere when getting in and out of the chair. Note: When adjusting the height of the footplate, always have the chair height in lowest position to avoid damage on the chair.
Page 9
VELA
TANGO
100S
VELA
TANGO
100ES
9
1.6.13. ROTATION (VELA TANGO 100S) (OPTIONAL)
By pulling up the lever situated on the back left side, you can rotate the seat 90° in either direction. The seat will lock into at stable position, when turning the seat.
1.6.15. PUSH HANDLE (OPTIONAL)
Push handle for transporting a person in the chair. The push handle should be mounted on the back wheel towers. Note: The push handle is also available in a configuration that can be adjusted in height. Loosen the screw located in the middle of the rod. Adjust the height. Remember to tighten the screw.
1.6.16. FOOT PEDAL FOR BRAKE (OPTIONAL)
VELA Tango with foot pedal brakes by pressing the top part of the pedal forwards. Unlock the chair by pressing the foot brake back in its original position. Note: The foot pedal can be mounted in left or right side at the back of the chair.
1.6.14. ROTATION (VELA TANGO 100ES) (OPTIONAL)
By pushing the lever situated on the front right side, you can rotate the seat 90° in either direction. The seat will lock into at stable position, when turning the seat. The rotation can remain open, if you heave the lever outwards.
Page 10
10
1.6.18. ELECTRIC BRAKE (OPTIONAL)
VELA Tango with electric brake, is braked and unlocked via hand box or angle contact. The brake is hydraulic, and it is adviced to fully braked/unlocked when using this function. Note: This function can only be controlled via height adjustment under armrest, hand box or angle contact.
1.6.17. HAND BOX (OPTIONAL)
The hand box is operated via buttons on the front. An VELA hand box can have one or more functions. See the hand box icons to see what functions the buttons operate. Note: insert plug in hand box to operate.
Page 11
11
Page 12
701.301 © Vermund Larsen A/S
VELA :: Gøteborgvej 8-12 :: 9200 Aalborg SV :: Denmark :: +45 96 34 76 00 :: mail@vela.dk vela.eu
Loading...