
VELA Samba
100/110/120/130/150
VELA Samba 100 VELA Samba 110
VELA Samba 130
VELA Samba 150VELA Samba 120
USER MANUAL EN
VARIANT:
Manual no. 105583

TABLE OF CONTENTS
1.0. INTRODUCTION 3
1.1. SAFETY 4
1.2. WARRANTY 4
1.3. UNPACKING THE CHAIR 4
1.4. MAINTENANCE 5
1.4.1. Wheels 5
1.4.2. Frame 5
1.4.3. Upholstery 5
1.5. USER MANUAL 6
1.5.1. Attaching the backrest 6
1.5.2. Adjustment of seat height with foot ring 6
1.5.3. Adjustment of seat height with lever 6
1.5.4. Adjustment of seat height (Samba 130) 6
1.5.5. Adjustment of seat tilt 7
1.5.6. Adjustment of seat tilt (Samba 130) 7
1.5.7. Adjustment of back height 7
1.5.8. Adjustment of back tilt 7

3
DEAR CUSTOMER
We would like to thank you for purchasing a VELA
Samba. This user manual contain useful information
about positioning, operating and maintenance of VELA
Samba stools.
Important
Please read this user manual thoroughly and keep
it for later use. This user manual must always
accompany the chair. The user manual can also be
found on VELA’s website: www.vela.eu, where you
also can find other relevant information about VELA
Samba stools.
If you have any questions, please contact VELA’s
distributor in your country.
VELA reserves the right to make changes to this
manual.
VELA
Gøteborgvej 8-12
DK-9200 Aalborg
Denmark
www.vela.eu
1.0. INTRODUCTION

4
1.1. SAFETY
This chair bears the CE mark and
conforms to all applicable EU rules.
The stool is manufactured by VELA,
Vermund Larsen A/S, Goeteborgvej
8-12, 9200 Aalborg SV, Denmark.
VELA Samba is an indoor stool
designed for sitting persons.
VELA Samba 100/110/120/130/150 is
tested and approved for a maximum
user weight of 125 kg.
1.2. WARRANTY
VELA provides warranty by the laws
and regulations which are debt in the
country the chair is bought in. The
warranty only applies when using
original spare parts and accessories.
Modification may only be carried out
by authorised service technicians.
VELA does not accept responsibility
for damage or injury to the product
or user, which have arisen due to:
:: Transportation
:: Misuse
:: General wear and tear
:: Incorrect use
:: Use of non-original spare parts
and accessories
:: Adjustments carried out by
unauthorised service technicians
1.3. UNPACKING THE CHAIR
VELA Samba is supplied in cardboard
packaging, developed with consideration for the environment.
If there are any parts missing or
transport damage to the chair, please contact your dealer immediately.
Do not not try to repair any damage
or use the chair.
Content of the cardboard
packaging:
:: VELA Samba chair
:: This user manual
GENERAL

5
1.4. MAINTENANCE
We recommend your VELA Samba
undergoes an annual service to find,
for example, defective or worn parts.
1.4.1. WHEELS
VELA recommend that the wheels
are checked in regular intervals e.g.
to remove possible thread remnants.
1.4.2. FRAME
Clean with water, possibly with a PH
neutral soap.
1.4.3. UPHOLSTERY
Fabric: Clean with upholstery clea-
ners or wipe it with a tightly wrung
cloth rinsed in clean water.
Imitation leather: Clean with water
or mild soap.
Medical textiles: Clean as described
above. Can also be cleaned with
disinfectants and alcohol.
Leather: Cleen by vacuuming it
using a soft dusting brush. Avoid
cleaning products.

VELA
SAMBA
130
1.
2.
6
1.5.3. ADJUSTMENT OF SEAT HEIGHT WITH LEVER
Adjust the seat height by pushing the lever placed at your
right hand.
1.5.4. ADJUSTMENT OF SEAT HEIGHT (SAMBA 130)
Adjust the seat height by pushing the lever placed at your
left hand.
1.5.2. ADJUSTMENT OF SEAT HEIGHT WITH FOOT RING
Adjust the seat height with your foot by pushing the ring, which
is placed at the base og the chair.
1.5. USER MANUAL
Replacement of the gas spring may only be performed
by the service support team from your dealer or a
skilled technical person.
1.5.1. ATTACHING THE BACKREST
The lever for backrest adjustment (1) must be in open position.
Press the locking pin spring (2) and push the backrest arm through
the hole. Tighten the lever afterwards.
Note: The backrest arm must be pushed through completely so
the pin spring locks the backrest arm. Make sure that the backrest
arm cannot be pulled out again.

VELA
SAMBA
130
7
1.5.7. ADJUSTMENT OF BACK HEIGHT
Adjust the back height by using the lever placed on the back of
the chair. Remember to tighten the handle again afterwards.
1.5.8. ADJUSTMENT OF BACK TILT
Adjust the back tilt by pushing the rear lever placed at your
right hand.
1.5.6. ADJUSTMENT OF SEAT TILT (SAMBA 130)
Adjust the seat tilt by pushing the lever placed at your
right hand.
1.5.5. ADJUSTMENT OF SEAT TILT
Adjust the seat tilt by pushing the middle lever placed at your
right hand.

701.195 © Vermund Larsen A/S
VELA :: Gøteborgvej 8-12 :: 9200 Aalborg SV :: Denmark :: +45 96 34 76 00 :: mail@vela.dk vela.eu