Vector VEC1043 User Manual

750 Watt

Power Inver ter

Vehicle Power System

Converts DC Vehicle Power

to 115 Volt AC Household Power

VEC1043

USER’S MANUAL

& WARRANTY INFORMATION

IIIIMMMMPPPPOOOORRRRTTTTAAAANNNNTTTTSSSSAAAAFFFFEEEETTTTYYYYIIIINNNNFFFFOOOORRRRMMMMAAAATTTTIIIIOOOONNNN,,,,SSSSAAAAVVVVEEEETTTTHHHHEEEESSSSEEEEIIIINNNNSSSSTTTTRRRRUUUUCCCCTTTTIIIIOOOONNNNSS

SS

TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.

www.vectormfg.com

4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312

T oll Free: [phone]

8

Fault Protection Code and Troubleshooting Guide

INVERTER POWER SWITCH TURNED ON

SPECIFICATIONS

Output Connection: North American standard outlet
Output Voltage: Approx. 115 volts AC, RMS 60 Hz
Output Current: 6.5 amps Max
Output Waveform: Modified Sine Wave
Input Voltage: 12.5 volts DC
Low Voltage Alarm: 11.0 volts DC
No Load Input Current: 0.7 amps max.
Input Fuses: Internal
Input Cables: Battery clip cables
Additional Protection: Overload, overvoltage, overheating

Trouble/Indication Possible Cause Suggested Remedy

No AC output — yellow
LED lit

DC input is below
10 volts

Recharge or replace the
battery.

No AC output — red LED
lit

Excessive appliance
load

Reset unit by turning OFF,
then back ON.

Inverter hot Disconnect load from

inverter. Operate inverter
without load for a few
minutes. Reconnect load.

No AC output — green
LED not lit

Bad connection or
wiring

Tighten all DC connections.

Low battery alarm sounds Low battery voltage Recharge battery. Remove

load from inverter while
recharging battery.

Motorized power tool will
not operate

Excessive start-up load If appliance does not start,

appliance is drawing too
much voltage and will not
work with this inverter.

Motorized power tool
does not operate at
correct speed

Purely inductive load Make the load not purely

inductive (i.e., operate an
incandescent lamp at the
same time as power tool).

Television/radio
interference

Snow in picture,
“buzzing” sound

Keep inverter and antenna
distant from each other.
Use shielded antenna.
Connect antenna to
amplifier.

VEC1043_ManualEN_091505 1/17/06 5:49 PM Page 8

ii iii

IMPORT ANT SAFETY INSTRUCTIONS

WARNINGS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPLOSION OR INJURY:

• Do not connect to AC distribution wiring.

• Remove appliance plug from outlet strip or turn off inverter before working on the
appliance. Multiple outlet power strips with switches and circuit breakers only
interrupt power to the “hot” receptacle terminals. The “neutral” terminals remain
powered with respect to the “ground” terminals.

• NOT approved for ignition protected areas. Do not make any electrical connections
or disconnections in areas designated as IGNITION PROTECTED.

• This is not a toy — keep away from children.

• This equipment employs components that tend to produce arcs or sparks. DO NOT
install in compartments containing batteries or flammable materials.

• Use this unit in properly ventilated areas ONLY.

• Do not open — there are no user-serviceable parts inside.

• Do not insert foreign objects into the outlet.

• Do not expose the unit to water, rain or snow.

CAUTIONS

• Always inspect battery supply connections and cables to ensure they are tight and
that cable insulation is not damaged.

• Do not use with positive ground electrical systems*. Reverse polarity connection will
result in a blown fuse and may cause permanent damage to the inverter and will
void warranty.

*The majority of modern automobiles, RVs, trucks and boats are negative ground.

• This inverter will not operate high wattage appliances or equipment that produces
heat, such as hair dryers, microwave ovens and toasters.

• Grounding the Neutral will cause the inverter to shut down. Do not operate this
inverter if it is wet. Do not install in engine compartment — install in a well
ventilated area.

• This inverter has not been tested for use with medical devices.

• Do not attempt to install or operate this unit while operating a motor vehicle.

Important Cable Information

Substantial power loss and reduced battery operating time results from inverters installed with cables that
are not able to supply full power. Symptoms of low battery power can result from cables that are either
excessively long or an insufficient gauge. Marine installations are also subjected to vibration and stresses
that exceed those of other mobile installations. Therefore, the installer/operator should be especially
aware of the requirements to maintain secure, tight, water-resistant electrical connections and to provide
for strain relief for DC cables and appliance wiring. Cable insulation must be the appropriate type for
the environment.

Read This User’s Manual Before Using This Power Inverter.

SAVE THESE INSTRUCTIONS

TTTTWWWWOOOOYYYYEEEEAAAARRRRLLLLIIIIMMMMIIIITTTTEEEEDDDDWWWWAAAARRRRRRRRAAAANNNNTTTTYYYYPPPPRRRROOOOGGGGRRRRAAAAMM

MM

This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Manufacturing regarding this product. There is no other warranty, other than those
described herein.

This Vector Manufacturing product is warranted, to the original purchaser only, to be free of defects in
materials and workmanship for two years from the date of purchase without additional charge. The
warranty does not extend to subsequent purchasers or users. Manufacturer will not be responsible for any
amount of damage in excess of the retail purchase price of the product under any circumstances. Incidental
and consequential damages are specifically excluded from coverage under this warranty.

This product is not intended for commercial use. This warranty does not apply to accessories or damage to
units from misuse or incorrect installation/connection. Misuse includes wiring or connecting to improper
polarity power sources.

RETURN/REPAIR POLICY: Defective products, other than accessories, may be returned to manufacturer .Any
defective product, other than accessories, that is returned to manufacturer within 30 days of the date of
purchase will be replaced free of charge. If such a product is returned more than 30 days but less than two
years from the purchase date, manufacturer will repair the unit or, at its option, replace it free of charge.

If the unit is repaired, new or reconditioned, replacement parts may be used, at manufacturer’s option. A
unit may be replaced with a new or reconditioned unit of the same or comparable design. The repaired or
replaced unit will then be warranted under the terms of the remainder of the warranty period. The customer
is responsible for the shipping charges on all returned items after 30 days. During the warranty period,
manufacturer will be responsible for the return shipping charges.

LIMITA TIONS: This warranty does not cover accessories, bulbs, fuses and batteries, defects resulting from
normal wear and tear (including chips, scratches, abrasions, discoloration or fading due to usage or
exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unauthorized
use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, fire, flood and
Acts of God.

If your problem is not covered by this warranty, call Technical Support at [phone] for general
repair information and charges, if applicable. You may also contact us through our website at
www.vectormfg.com.

ST ATE LA W RIGHTS: This warranty gives you specific legal rights. Some states do not allow limitations on
how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages,
so the exclusions or limitations stated herein may not apply. This warranty gives the purchaser specific legal
rights; other rights, which vary from state to state, may apply.

TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT: Contact Technical Support by telephone, fax or
mail (see below). We suggest that you keep the original packaging in case you need to ship the unit. When
returning a product, include your name, address, phone number, dated sales receipt (or copy) and a
description of the reason for return and product serial number . After repairing or replacing the unit, we will
make ever y effort to return it to you within four weeks.

W ARRANTY ACTIVA TION: Please complete Warranty Activation Card and mail to Vector Manufacturing.
Enter “VEC1043” as Model and “750 Watt Power Inverte r Vehicle Power System” as Product Type. All
V ector products must be registered within 30 days of purchase to activate this warranty. Mail the completed
registration form, along with a copy of the original sales receipt to:

ATTN.: CUSTOMER SERVICE

4140 SW 30th Ave., Ft. Lauderdale, FL 33312

• TOLL FREE: [phone] • FAX: [phone] •

WARRANTY IS NON-TRANSFERABLE AND NON-REFUNDABLE.

BD070605

© 2005 VECTOR MANUFACTURING

MADE IN CHINA

VEC1043_ManualEN_091505 1/17/06 5:49 PM Page ii