Vector 90510392, SLH100P User Manual

SLH100P
IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND THIS INSTRUCTION MANUAL. THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS PRODUCT.
4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312
Toll Free: (800) 544-6986
Cordless • Rechargeable
INSTRUCTION MANUAL
& WARRANTY INFORMATION
Cat. # SLH100P Form # 90510392 SEPTEMBER ‘06 Printed in China
SLH100P_ManualEN_091406 9/28/06 10:55 AM Page i
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES
READ ALL INSTRUCTIONS
WARNING: Read and understand all instructions before operating product. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury.
AVOID DANGEROUS ENVIRONMENTS. Don’t use appliances in damp or wet locations. Don’t use appliances in the rain.
KEEP CHILDREN AWAY. All visitors should be kept at a distance from work area.
STORE IDLE APPLIANCES INDOORS. When not in use, appliances should be stored indoors in dry, and high or locked-up place – out of reach of children.
USE RIGHT APPLIANCE. Do not use the appliance for any job except that for which it is intended.
DRESS PROPERLY. Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and substantial, non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain long hair.
USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT. Use safety goggles or safety glasses with side shields, complying with applicable safety standards and, when needed, a face shield. Also use face or dust mask if operation is dusty. This applies to all persons in the work area. Also use a hard hat, hearing protection, gloves, safety shoes and dust collection systems when specified or required. Safety glasses or the like are available at extra cost at your local dealer.
DON’T ABUSE CORD. Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp edges.
DON’T OVERREACH. Keep proper footing and balance at all times.
DISCONNECT APPLIANCES. Disconnect the appliance from the power supply when not in use, before servicing, and when changing accessories such as blades and the like.
AVOID UNINTENTIONAL STARTING. Don’t carry plugged-in appliance with finger on switch. Be sure switch is off when plugging in.
GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on the circuits or outlets to be used. Receptacles are available having built in GFCI protection and may be used for this measure of safety.
USE OF ACCESSORIES AND ATTACHMENTS. The use of any accessory or attachment not recommended for use with this appliance could be hazardous. Note: Refer to the accessory section of this manual for further details.
ST AY ALERT . W atch what you are doing. Use common sense. Do not operate tool when you are tired.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by authorized service center. Do not use tool if switch does not turn it on and off.
DO NOT OPERATE portable electric tools near flammable liquids or in gaseous or explosive atmospheres. Certain components in these tools normally spark, and the sparks might ignite fumes.
EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
1
SLH100P_ManualEN_091406 9/28/06 10:55 AM Page 1
OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords intended for use outdoors and so marked.Safety guidelines / definitions
SAFETY GUIDELINES/DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death
or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury. CAUTION: Used without the safety alert symbol indicates potentially hazardous situation which, if not
avoided, may result in property damage.
WARNING: RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety precautions should always be followed to reduce the risk of personal injury. Improper operation, maintenance or modification of tools or equipment could result in serious injury and property damage. There are certain applications for which tools and equipment are designed. Vector Products, Inc. strongly recommends that this product NOT be modified and/or used for any application other than for which it was designed. Read and understand all warnings and operating instructions before using any tool or equipment.
SAVE THESE INSTRUCTIONS
THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR THE HID SPOTLIGHT SLH100P.
WARNING: TO REDUCE THE RISK OF INJURY:
• Follow these instructions and those published by the manufacturer of any equipment you intend to use with this unit. Review cautionary markings on these products.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: This product or its power cord contains lead, a chemical known to the State of California to cause cancer and birth defect or other reproductive harm. Wash hands after handling.
WARNING: RISK OF ELECTRIC SHOCK: This light contains high voltage components. Do not disassemble this light other than to replace or recycle the battery. Should this light become damaged, immediately discontinue use and return it to an authorized service center for repair.
• This light is for dry location use only. Never expose this light to rain.
Do not operate light with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or otherwise damaged in any way. Evidence of tampering with the light will void the warranty.
• Do not operate this unit with a missing or damaged guard or glass lamp containment barrier.
• Do not immerse this spotlight in water. This unit is not waterproof.
WARNING: Risk of injury to eyes and skin from UV exposure. The glass of the bulb blocks harmful UV radiation emitted by the bulb. Never operate the light if you suspect the bulb is cracked or see that it is broken. Prior to each use look for evidence of bulb damage and if suspected or observed do not use the light. Return the light to an authorized service center for repair.
2
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more American Wire Gage Than Than 0 - 6 18 16 16 14 6 -101816 14 12 10 -121616 14 12 12 - 16 14 12 Not Recommended
SLH100P_ManualEN_091406 9/28/06 10:55 AM Page 2
• Do not look directly at lighted lamp.
• Never shine the spotlight into another person’s eyes.
• Keep sharp objects away from lens – it is glass and can break.
WARNING: RISK OF FIRE OR INJURY TO PERSONS FROM CONTACT WITH HOT LENS:
Never block the lens of this light. If the light is operated with the lens blocked, the lens will get hot and may ignite or damage materials it contacts and it can burn the skin.
• Never place the light with the lens face-down on any surface when lit.
• Keep lamp away from materials that may burn.
• Do not touch hot lens, guard, or enclosure.
• Lens can get hot – do not touch lens while spotlight is operating.
WARNING: TO REDUCE THE RISK OF INJURY, THIS UNIT SHOULD ONLY BE OPERATED BY
ADULTS; IT IS NOT FOR USE BY CHILDREN.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
• Charge only with originally supplied 120 volt AC or 12 volt DC charging adapters. Consult your
authorized service center for replacement.
• Replace batteries with the same size and type indicated in the Specifications in the back of this
instruction manual.
• Do not drop or throw spotlight.
• Do not crush, cut, pull or expose charging adapter cords to extreme heat or sharp edges.
• Position charging adapter cords so that they do not become entangled and away from lens so that
they do not become a safety hazard.
• Always charge in a dry location.
• Plug in the charging adapter at the spotlight first, then plug into the charging source.
• After recharge, disconnect charging adapter and wait 5 minutes before use.
SA VE THESE INSTRUCTIONS
3
SLH100P_ManualEN_091406 9/28/06 10:55 AM Page 3
Loading...
+ 8 hidden pages