VEC431
4
Using the External Antenna
The External Antenna is used to enhance reception in areas
where the audio signal is weak. It can be easily repositioned as
needed if audio signal strength changes during travel.
Plug the Antenna’s barrel connector into the External Antenna
Port on the Dock and screw either the suction cup or clip into the
wing antenna end. Attach the wing antenna end:
• to the lower passenger side front window (or other flat surface
location near the vehicle antenna) using the supplied suction
cup, or
• to the sun visor, dashboard, air vents, etc. using the supplied
clip.
CAUTIONS
Position the External Antenna so that it will not
become tangled, crimped or damaged; and make
sure it does not impede the driver’s access to vehicle
controls (turn signals, etc.) or visibility.
NEVER position the External Antenna in front of an
air bag.
SPECIFICATIONS
Power supply: 12 volts DC
Consumption Electric Current: 100 mA
Range of the frequency: From 88.1 to 107.9 MHz
Operating Distance: 7 meters (max.)
FM Audio Transmitter
Charging Dock
for iPod
®
USER’S MANUAL
& WARRANTY INFORMATION
IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.
www.vectormfg.com
4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312
Toll Free: (866) 584-5504
ANTENNA
SUCTION CUP
ANTENNA CLIP
iPod is a registered trademark of Apple Computer, Inc.Vector Manufacturing is not associated with or otherwise affiliated with
Apple Computer, Inc.
VEC431_Manual_080505 8/5/05 5:10 PM Page 4
ii iii
IMPORT
ANT SAFETY INSTRUCTIONS
WARNINGS
1. To reduce the risk of electrical shock, do not expose this unit to rain or moisture, or
submerge it in water.
2. DO NOT attempt to connect or set up the unit or its components while operating
your vehicle. Inattention to the road may result in a serious accident.
3. Do not position the External Antenna in such a way that it impedes the driver’s
access to vehicle controls or visibility.
CAUTIONS
1. Use only the supplied 12 volt DC power adapter for powering this unit.
2. Make sure your vehicle’s accessory outlet is 12 volt DC and negative ground (common in most
vehicles).
3. Turn the FM Transmitter Charging Dock OFF before connection to a power source.
4. Never insert anything other than the supplied DC power adapter into the 12 volt DC power socket
on this unit. Do not use any accessory not recommended or provided by the manufacturer.
5. Follow all warnings, cautions, and instructions marked on this unit and contained in this User’s
Manual.
6. The external antenna should be attached securely to the wall of your vehicle in a position where it
will not be subjected to undue stress.
7. For protection during violent storms, or when left unattended or unused for long periods of time,
unplug the 12 volt DC power adapter and disconnect the external antenna.
8. To prevent possible electrical damage to unit or your vehicle, always unplug the 12volt DC adapter
cord from your vehicle’s accessory power outlet BEFORE removing the plug from the unit.
9. Do not open this unit. There are no user replaceable parts.
10. Check unit periodically for wear and tear. Replace worn or defective parts immediately. Contact
Vector’s Customer Service department, toll-free (866) 584-5504.
Read This User’s Manual Before Installing or Using This Unit.
SAVE THESE INSTRUCTIONS
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
ONE YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Manufacturing, regarding this product. There is no other warranty , other than those
described herein.
This Vector Manufacturing product is warranted, to the original purchaser only, to be free of defects in
materials and workmanship for one year from the date of purchase without additional charge. The
warranty does not extend to subsequent purchasers or users. Manufacturer will not be responsible for any
amount of damage in excess of the retail purchase price of the product under any circumstances. Incidental
and consequential damages are specifically excluded from coverage under this warranty.
This product is not intended for commercial use. This warranty does not apply to accessories or damage to
units from misuse or incorrect installation/connection. Misuse includes wiring or connecting to improper
polarity power sources.
RETURN/REPAIR POLICY : Defective products, other than accessories, may be returned to manufacturer. Any
defective product, other than accessories, that is returned to manufacturer within 30 days of the date of
purchase will be replaced free of charge. If such a product is returned more than 30 days but less than one
year from the purchase date, manufacturer will repair the unit or, at its option, replace it free of charge.
If the unit is repaired, new or reconditioned replacement parts may be used, at manufacturer’s option. A
unit may be replaced with a new or reconditioned unit of the same or comparable design. The repaired or
replaced unit will then be warranted under the terms of the remainder of the warranty period. The customer
is responsible for the shipping charges on all returned items after 30 days. During the warranty period,
manufacturer will be responsible for the return shipping charges.
LIMITATIONS: This warranty does not cover accessories, bulbs, fuses and batteries, defects resulting from
normal wear and tear (including chips, scratches, abrasions, discoloration or fading due to usage or
exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unauthorized
use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance, fire, flood and
Acts of God.
If your problem is not covered by this warranty, call our Technical Support Department at (954) 584-4446
or toll free at (866) 584-5504 for general repair information and charges if applicable. You may also
contact us through our website at www.vectormfg.com.
STATE LAW RIGHTS: This warranty gives you specific legal rights. Some states do not allow limitations on
how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages,
so the exclusions or limitations stated herein may not apply. This warranty gives the purchaser specific legal
rights; other rights, which vary from state to state, may apply.
TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT: Contact Technical Support by telephone, fax or
mail (see below). We suggest that you keep the original packaging in case you need to ship the unit. When
returning a product, include your name, address, phone number, dated sales receipt (or copy) and a
description of the reason for return and product serial number. After repairing or replacing the unit, we will
make every effort to return it to you within four weeks.
WARRANTY ACTIVATION: Please complete Warranty Activation Card and mail to Vector Manufacturing.
Enter “VEC431” as Model and “FM Transmitter Charging Dock for iPod
®
” as Product Type. All Vector
products must be registered within 30 days of purchase to activate this warranty. Mail the completed
registration form, along with a copy of the original sales receipt to:
ATTN.: CUSTOMER SERVICE
4140 SW 30th Ave., Ft. Lauderdale, FL 33312
• TOLL FREE: (866 ) 584-5504 • FAX: (954) 584-5556 •
WARRANTY IS NON-TRANSFERABLE AND NON-REFUNDABLE.
RD080305
© 2005 VECTOR MANUFACTURING
MADE IN CHINA
VEC431_Manual_080505 8/5/05 5:10 PM Page ii
iv 1
TABLE OF CONTENTS
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Setting Up the iPod
®
FM Transmitter Power Dock . . . . . . . . . . . . . . . . . . . . . . . 2
Customizing the Dock to Fit Your iPod
®
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Operating the Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
FM Station Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Using the External Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
INTRODUCTION
Thank you for purchasing the
VEC431 FM Transmitter Charging Dock for
iPod®,
the accessory that allows you to play your iPod®over any FM stereo system,
creating your own personalized FM radio station. The
VEC431
also conveniently
recharges your iPod®while it is docked, even when it is in use.
Please read this User’s Manual carefully before use to ensure optimum performance
and to avoid damage to this product.
FEATURES
• Transmits music from iPod®to any FM stereo
• Recharges iPod
®
while docked in the station (in use or idle)
• Multiple fitting adapters to accommodate most iPod
®
models
• 14 preset transmitter stations, all customizable by user
• Flexible pedestal for easy access and viewing
• Cup-style base fits perfectly in your vehicle cup holder for traveling
• Green backlit LCD display in Dock
• External antenna for superior reception in weak areas
• Detachable 12 volt DC power adapter
VEC431_Manual_080505 8/5/05 5:10 PM Page iv
3
Operating the Unit
Press any button for 1 second to turn the unit ON.
The left and right arrow buttons are the Station Select buttons. Pressing them cycles
forward or backward through the preset/user-programmed FM stations.
Tune your vehicle FM stereo to the same station.
Press the “Play” button on your iPod
®
.
Use your vehicle’s radio controls to adjust volume, balance, etc., just as you would
any other radio station.
Press and hold any two buttons at the same time for 2 seconds to turn the unit OFF.
This will power off the FM transmitter and LCD backlight at the same
time.
FM Station Selection
The
VEC431
features 14 preset stations that can be reprogrammed as needed to
achieve the best reception (see “Specifications” for this unit’s operating range of
frequencies). The preset numbers and their corresponding FM stations are shown on
the backlit LCD display as follows:
Programming Stations
If you need to reprogram the preset stations, choose FM stations on your vehicle
stereo that are free of strong outside audio signals.
With the unit turned ON, press and hold the center button for 2 seconds to enter
Program Mode.
Press the left or right arrow buttons until the preset number you want to change is
displayed (the currently stored FM station will be listed on the right side of the LCD
display).
Press and hold the center button for 1 second.
Press the left or right arrow buttons to set the desired FM station.
Press and hold the center button again for 1 second to store.
The unit will automatically exit Program Mode when you are through.
Note: The same factors that influence vehicle radio reception in general will naturally
affect signal strength of the VEC431. For example, there are cases in dense
metropolitan areas where a local station’s audio signal may “bleed” over to
adjacent frequencies. Reception may vary depending upon location as you
travel.
Experiment when programming your preset stations to find the clearest sound
with the least interference.
An External Antenna is supplied to supplement your vehicle antenna.
PRESET
NUMBER
FM
STATION
2
OPERATING INSTRUCTIONS
Setting Up the
iPod®FM Transmitter Power Dock
• Insert the base of the
VEC431
into your vehicle’s cup holder. If necessary, use the
supplied Base Adjustment Sleeve to ensure a snug fit.
• Plug the 12 Volt DC Power Adapter’ s barrel end tip into the unit’s 12 Volt DC Power
Port (see illustration above). Plug the other end of the adapter into your vehicle’s
accessory outlet.
• Place your iPod
®
in the Dock, using the Fitting Adapters to achieve a secure,
vibration-free fit (see “Customizing the Dock to Fit Your iPod®”). iPod®will
automatically recharger while docked.
Customizing the Dock to Fit Your iPod
®
To achieve optimum performance and avoid damage to your
iPod®, make sure it sits firmly in the Dock. If necessary, slide the
Front Lip Spacer into the half-circle cutaway on the front of the
Dock, insert your iPod®, then rotate the Size Adjustment Knob on
the back of the Dock to adjust.
A separate fitting adapter is supplied for use with the iPod
®
Mini
(see the illustration above). Fit this into the VEC431 Dock first,
then insert your iPod®Mini into the adapter.
12 VOLT DC
POWER ADAPTER
EXTERNAL ANTENNA
IPOD®MINI
FITTING ADAPTER
BACKLIT LCD
DISPLAY
FRONT LIP
SPACER
12 VOLT DC
POWER PORT
DOCK
BASE
ON/OFF/PROG/
STATION SELECT
PUSHBUTTONS
FLEXIBLE
PEDESTAL
SIZE ADJUSTMENT
KNOB
EXTERNAL
ANTENNA
PORT
BASE ADJUSTMENT
SLEEVE
FRONT LIP
SPACER
SIZE ADJUSTMENT
KNOB
VEC431_Manual_080505 8/5/05 5:10 PM Page 2
Loading...